FCC Statement
This device complies with part 15 of FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation. This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction guide, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult a service representative for help.
Properly shielded and grounded cables and connectors must be used in order to comply
with FCC emission limits. Tech Universe is not responsible for any radio or television
interference caused by using other than recommended cables and connectors or by
unauthorized changes or modifications to this product. Unauthorized changes or
modifications could void the user’s authority to operate the product.
Responsible party: Tech Universe 75 Montebello Road, Suffern, NY 10901
Tested To Comply With FCC Standards FOR HOME OR OFFICE USE
Warning Improper setup, use and care of this product can increase the risk of serious
injury, death or device damage. Read and keep this guide and all other printed guides
for future reference. For updated information go to www.techuniverseproducts.com.
Do Not Attempt Repairs Do not attempt to take apart, open, repair, service or modify
the device(s). Doing so may risk electric shock or other hazard. Evidence of any attempt
to open or modify the device, including any peeling, puncture or removal of labels, will
void the Limited Lifetime Warranty.
1. Install battery (1 x "AA" not included)
GETTING STARTED
Take out the Receiver from
the Bottom
Battery compartment lifts
open
Be sure to insert battery
as indicated by "+" and
"-" on mouse
2. The mouse will power on/o automatically
Your mouse will automatically turn on when the battery is installed.
To conserve battery power, the mouse will turn off after a period of
inactivity. To "awaken" your mouse simply press any key. If the
battery power is low, you may need to press DPI selector to
reactivate mouse.
You can select DPI accuracy 1000/1500/2000 by pressing selector. A
higher DPI will provide for slower mouse movement and better
accuracy.
Note: When set to 1000 DPI the scroll wheel will flash 1 time, the wheel
will flash twice on 1500 DPI, and 3 times when set to 2000 DPI.
DPI Selector
3. Connect receiver to USB port 4. Begin using your mouse
Connect receiver to
computer’s USB port.
You can adjust mouse settings within
your operating system’s preferences.
(TU1318)
www.techuniverseproducts.com
customer care: support @techuniverseproducts.com
(TU1318)
www.techuniverseproducts.com
customer care: support @techuniverseproducts.com
