TabletKiosk TufTab v7112XT User manual

User’s Guide

eo TufTab™ v7112XT

Ultra-Mobile PC

Preface i

Pref ce

This m nu l will help you get the most out of your new

eo TufTab™ Ultra-Mobile PC. If you re new computer user, or

just new to UMPCs, re d through this m nu l c refully before

ﬁrst using your eo TufTab. If fter re ding this m nu l you still

h ve questions, visit us online t www.tabletkiosk.com for

ddition l resources nd inform tion on using your rugged

eo TufTab v7112XT UMPC.

Cop right

inform tion is subject to ch nge without notice. eo, eo TufT b,

nd T bletKiosk re tr dem rks of S nd Dune Ventures, Inc. in

the United St tes nd/or other countries. Microsoft, Windows XP,

Windows Vist nd the Windows logo re either registered

tr dem rks or tr dem rks of Microsoft Corpor tion in the United

St tes nd/or other countries. VIA C7-M , VIA P dlock Security

Engine, VN800, VT8237R, nd VT1618 re tr dem rks of VIA

Technologies, Inc. The Bluetooth word m rk nd logos re

owned by the Bluetooth SIG, Inc. nd ny use of such m rks by

T bletKiosk is under license. Linux is registered tr dem rk of

Linus Torv lds.

ii Preface

Discl imer

The speciﬁcations and information in this manual are subject to

change without prior notice in order to improve reliability,

design and/or function. In no way does this represent a

commitment on the part of the manufacturer. The manufacturer

assumes no responsibility for errors or omissions in this

document.

In no event will the manufacturer be liable for direct, indirect,

special, incidental, or consequential damages arising from the

use, or inability to use, the UMPC or this documentation, even if

advised of the possibility of such damages.

This document contains proprietary information protected by

may be reproduced by any mechanical, electronic, or other

means in any form without prior written permission of

Tablet iosk.

If you have any questions regarding the eo TufTab, or the

information contained within this manual, please contact

Tablet iosk at info@tabletkiosk.com.

S fety Instructions

For your own safety and the safety of your equipment, please

follow these rules for the handling and care of your eo TufTab.

eep this User’s Manual for future reference by you and other

users.

Never use sprays, liquids or cleaning detergents to clean the eo

TufTab. Use a micro ﬁber cloth to clean the touch screen. Avoid

the use of tissue paper since tissue ﬁbers can easily lodge

between the touch screen and the top cover of the tablet.

Never pour liquids into any opening or directly on the eo TufTab.

This could result in ﬁre or electrical shock.

Preface iii

Check that the voltage range of the power outlet is between

100V and 240V before connecting the eo TufTab. Exceeding the

maximum rated voltage may cause damage to the AC adapter or

to the eo TufTab. This could result in ﬁre or electrical shock.

When the AC adapter is plugged into an electrical outlet, place

the power cord so it will not be stepped on or walked on. Do not

place objects over or on the power cord.

Use the eo TufTab in a clean, dry, temperature controlled

environment. Do not use the eo TufTab in areas of high humidity,

around water or outdoors while it is raining.

Never open or disassemble the eo TufTab. For safety reasons, and

to prevent permanent damage, the equipment should only be

repaired by qualiﬁed service personnel.

Contact a qualiﬁed service center if any of the following issues

should arise:

1. The AC adapter, power cord or plug is damaged;

2. liquid has been spilled into the eo TufTab;

3. The eo TufTab has been exposed to excessive moisture;

4. The eo TufTab exhibits errors and/or does not function

according to speciﬁcations;

5. The eo TufTab has been dropped or otherwise physically

damaged.

Lithium-Ion batteries can be dangerous. There is a danger of

explosion if the battery is incorrectly replaced. Replace only with

the same or equivalent type recommended by the manufacturer.

Dispose of used batteries according to state or local hazardous

waste requirements.

iv Preface

Under no circumstances should the user attempt to disassemble

the power supply. The power supply has no user-replaceable

parts and its insides contain components that are electrically-

charged with hazardous voltage levels that can cause serious

personal injury. A defective power supply must be returned to

your dealer.

S fety Notices for the Power Cord

This equipment has a 2 or 3-wire power cord. Replace the power

cord if it becomes damaged. Contact your dealer for an exact

replacement.

In the U.S.A. and Canada, the power cord must be a UL-listed

detachable power cord (in Canada, CSA-certiﬁed).

2-wire cord SPT-2 18AWG

3-wire cord SVT or SJT, 18 AWG, 3-conductor

The cord should be provided with a molded-on cord connector

body at the other end. The cord length must not exceed 3 meters

(9.8 feet).

Outside the U.S.A. and Canada, the plug must be rated for 250

VAC, 2.5 amp minimum, and must display an international

agency approval marking. The cord must be suitable for use in

the end-user’s country. Consult your dealer or the local electrical

authorities if you are unsure of the type of power cord to use in

your country. Voltage changes occur automatically in the power

supply.

Notice of FCC Compli nce

. Feder l Communic tions Commission (FCC)

Requirements, P rt 15:

This device complies with Part 15 of the FCC rules.

Preface v

Operation is subject to the following two conditions:

1. this device may not cause harmful interference,and

2. this device must accept any interference

received,including interference that may cause

undesired operation.

This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful

interference in a residential installation. This equipment

generates, uses, and can radiate radio frequency energy

and if not installed and used in accordance with the

instruction manual may cause harmful interference to

radio communications. However, there is no guarantee

that interference will not occur in a particular

installation. If this equipment does cause harmful

interference to radio or television reception, which can

be determined by turning the equipment oﬀ and on,

the user is encouraged to try to correct the interference

by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and

the receiver.

Connect the equipment into an outlet on a circuit

diﬀerent from that to which the receiver is connected.

Consult the dealer or an experienced technician for

help.

Use only shielded I/O cables to connect I/O devices to

this equipment.

You are cautioned that any changes or modiﬁcations

not expressly approved by Tablet iosk could void your

authority to use the equipment.

vi Preface

b. Regul tory inform tion / Discl imers

This device must be installed and used in strict

accordance with the instructions included in the user

documentation provided with the product. Any

changes or modiﬁcations (including the antennas)

made to this device that are not expressly approved by

the manufacturer may void the user’s authority to

operate the equipment. The manufacturer is not

responsible for any radio or television interference

caused by unauthorized modiﬁcation of this device, or

the substitution of the connecting cables and

equipment other than the ones speciﬁed by

manufacturer. It is the responsibility of the user to

correct any interference caused by such unauthorized

modiﬁcation, substitution or attachment. The

manufacturer and its authorized resellers or distributors

will assume no liability for any damage or violation of

government regulations arising from the failure to

comply with these guidelines.

c. For port ble devices without co-loc tion condition (eg.

notebook pc)

FCC RF Radiation Exposure Statement:

1. This Transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.

2. This equipment complies with FCC RF radiation

exposure limits set forth for an uncontrolled

environment. This device was tested for typical lap-held

operations with the device contacted directly to the

human body to the back side of the UMPC. To maintain

compliance with FCC RF exposure compliance

requirements, please follow operation instruction as

documented in this manual.

Preface vii

The availability of some speciﬁc channels and/or

operational frequency bands are country dependent

and are ﬁrmware programmed at the factory to match

the intended destination. The ﬁrmware setting is not

accessible by the end user.

d. SAR Exposure

This device has been tested for compliance with FCC RF

Exposure (SAR) limits in typical ﬂat conﬁgurations.

In order to comply with SAR limits established in the

ANSI C95.1 standards, it is recommended that the

integrated antenna is positioned more than 1.5cm from

your body or from nearby persons during extended

periods of operation. If the antenna is positioned less

than 1.5 cm (0.6 inches) from the user, it is

recommended that the user limit the exposure time.

FCC St tement to Users for the F xModem

Notice of FCC Compli nce for the F x/Modem

This equipment complies with Part 68 of the FCC rules. The FCC

Registration Number and Ringer Equivalence Number for this

equipment are located on a label at the bottom of this

equipment. IF REQUESTED, THIS INFORMATION MUST BE GIVEN

TO THE TELEPHONE COMPANY.

The REN helps to determine the number of devices you may

connect to your telephone line while allowing all of those

devices to ring when your telephone number is called. In most,

but not all areas, the amount of devices connected to one line

should not exceed ﬁve (5).

To know precisely how many devices you may connect to your

line, as determined by the REN, you should contact your local

telephone company to determine the maximum REN for your

calling area.

viii Preface

If your telephone equipment causes harm to the telephone

network, the telephone company may disconnect your service

temporarily. They may notify you in advance, but if advance

notice is not practical, you will be informed of your right to ﬁle a

complaint with the FCC.

Your telephone company may make changes in its facilities,

equipment, operations or procedures that could aﬀect the

proper functioning of your equipment. If they do, you will be

notiﬁed in advance and given the opportunity to maintain

uninterrupted telephone service.

The telephone company may ask you to disconnect this

equipment from the network until the problem has been

corrected or until you are sure that the equipment is not

malfunctioning. This equipment may not be used on coin service

provided by the telephone company.

The Telephone Consumer Protection Act of 1991 makes it

unlawful for any person to use a computer or an electronic

device to send any message via a telephone facsimile machine

unless such message clearly contains in a margin at the top or

bottom of each transmitted page or on the ﬁrst page of the

transmission the following information:

The date and time of transmission

Identiﬁcation of either business, business entity or

individual sending the message;

Telephone number of either the sending machine,

business entity or individual.

In order to program this information into your fax/modem,

please refer to the appropriate instructions in your fax/modem

manual.

Note-TNV S fety C ution:

To reduce the risk of ﬁre, use only No. 26 AWG or l rger

telecommunic tion line cord. Avoid using telephone (other

Preface ix

th n cordless type) during n electric l storm. There m y be

remote risk of electric shock from lightning. Do not use the

telephone to report g s le k in the vicinity of the le k.

C n di n EMI Compli nce St tement

This Class B digital apparatus meets all requirements of the

Canadian Interference - Causing Equipment Regulations.

IC Warning statement:

. WLAN

“To prevent radio interference to the licensed service,

this device is intended to be operated indoors and away

from windows to provide maximum shielding.

Equipment (or its transmit antenna) that is installed

outdoors is subject to licensing.”

b. For LPD

“Operation is subject to the following two conditions:

(1) this device may not cause interference, and (2) this

device must accept any interference, including

interference that may cause undesired operation of the

device.”

This Class B digital apparatus complies with Canada RSS-210.

The abbreviation, IC, before the registration number signiﬁes

that registration was performed based on a Declaration of

Conformity (DoC) indicating that Industry Canada technical

speciﬁcations were met. It does not imply that Industry Canada

approved the equipment.

Europe n Union CE M rking Decl r tion

This product has been tested and found to comply with the EMC

requirement subject to the EU directive for CE marking.

Table of contents

Other TabletKiosk Tablet manuals

TabletKiosk

TabletKiosk Sahara Slate PC i500 User manual

TabletKiosk

TabletKiosk Sahara Slate PC i500 User manual

TabletKiosk

TabletKiosk Sahara Slate PC i412T User manual

TabletKiosk

TabletKiosk Sahara NetSlate a230T User manual

TabletKiosk

TabletKiosk eo TufTab a7230X User manual

TabletKiosk

TabletKiosk eo TufTab a7230X User manual

TabletKiosk

TabletKiosk Sahara Slate PC i500 User manual

TabletKiosk

TabletKiosk Sahara NetSlate a525 User manual

TabletKiosk

TabletKiosk Sahara NetSlate a230T User manual

TabletKiosk

TabletKiosk Sahara Slate PC i400 Series User manual

TabletKiosk

TabletKiosk Sahara Slate PC i500 User manual

TabletKiosk

TabletKiosk Sahara Slate PC i400 Series User manual

TabletKiosk

TabletKiosk Sahara Slate PC i400 Series User manual

TabletKiosk

TabletKiosk eo a7400 User manual

TabletKiosk

TabletKiosk Sahara NetSlate a510 User manual

Popular Tablet manuals by other brands

Laser

Laser MID-1060 Quick operation guide

MUNBYN

MUNBYN IRT09J Easy setup guide

Motorola

Motorola MC3090R - Win CE 5.0 Professional 520 MHz quick start guide

Dell

Dell Latitude ST Setup and features information

Lenovo

Lenovo IdeaTab S6000L Hardware Maintenance Manual

Venturer

Venturer WT9L11 quick start guide

EDUGEAR

EDUGEAR UnoBook user guide

Philips

Philips PI3210G/58 user manual

ADLINK Technology

ADLINK Technology IMT-BT user manual

TwinMOS

TwinMOS TwinTAB-T102D1 user guide

Archos

Archos 9.7 xenon manual 

Getac

Getac E100 user manual

HANNspree

HANNspree HANNspad SN70T3 quick start guide

Philips

Philips PI3105W2/55 user manual

LG LG-V935 user guide

Zeki

Zeki TBDB763B user guide

Ricoh

Ricoh eQuill user guide

DT Research

DT Research DT365CT Basic operation guide