Shenzhen Comark Technology Co., Ltd Innovation Quality Service
7 8 9
DIN Rail Mounting
Using 35 mm standard DIN rail installation, in
most industrial applications are very convenient and the
installation steps are as follows:
Step 1: Check whether have the DIN rail installation tool
accessories (this product has been installed accessories).
Step 2: Check whether the DIN rail is fixed, is there a
suitable location to install this product?
Step 3: Connect the product accessories card DIN rail seat
upper card into the DIN rail (upper with spring support), and
then will connect the lower part of the card into the DIN rail
(upper card into a little, and put forth your strength with
balance of equipment get stuck into the bottom).
Step 4: The DIN rail clip into the DIN rail, then check and
confirm the product firmly into the DIN rail.
Fault indicator and troubleshooting
Fault
phenomenon Treatment Measure
PWR off
Check whether the power supply is
meet the requirements, the power
supply terminal wiring is correct.
Package List
Using encoder TTL/HTL signal optical fiber converter at the
first time, please check the attachment packing is complete
or not? The package List as follows:
Encoder TTL/HTL signal optical fiber converter 1 pair
(with industrial terminal for power supply connection)
User manual 1 piece
Warranty card 1 piece
Precautions
Please configure DC18~36V industrial standard power
supply, typical voltage at 24V. Two power supplies
sharing the negative pole. Please use 0.75 mm2or
above high-quality copper
Optical port is not used, it must be with a fiber optic cap,
it will avoid polluted.
Do not look straight equipment optical fiber output port,
in order to avoid the laser damage eyes.
This equipment is belong to the precision of
communications equipment, please keep the ground
work of the equipment. Grounding device is a special
grounding screw on the side panel, when installation
should use the special earth lead, the earth lead must
be 2.5 mm2,, the resistance under 5 ohms.
The transmitting end of T1 / T2 / T3 / T4 lamp
corresponding optical interface TX1 / TX2 / TX3 / TX4,
with five-digit industrial input terminals in T1 / T2 / T3 /
T4 as well.
The receiving end of RX1 / RX2 / RX3 / RX4 indicator
corresponding optical interface RX1 / RX2 / RX3 / RX4,
with five-digit industrial input terminals in T1 / T2 / T3 /
T4 as well.
The transmitting end of the TX1 / TX2 / TX3 / TX4 RX1
and the receiving end /RX2 / RX3 / RX4 corresponding
connection as much as possible.
Applied Range
Electric Power System, Transportation, Energy Monitoring
and Industrial Control, etc.
Products List
Item No. Description and Specifications
CJ-TF22
TTL Fiber Optic Converter, support 2 ways
TTL signal, 0-500K speed rate, MM dual
fibers ST connector, DC24V redundant
power supply.
CJ-TF44
Encoder TTL Fiber Optic Converter, support
4 ways TTL signals, 0-500K speed rate, MM
dual fibers ST connector, DC24V redundant
power supply.
CJ-TF220
HTL Fiber Optic Converter, support 2 ways
HTL signal, 0-500K speed rate, MM dual
fibers ST connector, DC24V redundant
power supply.
CJ-TF440
Encoder HTL Fiber Optic Converter, support
4 ways HTL signals, 0-500K speed rate, MM
dual fibers ST connector, DC24V redundant
power supply.
Remark: Default connector is ST connector. FC, SC and
faster distance customized.
