Sungrow SH6.0RT Installation guide

© 2021 Sungrow. All rights reserved. Subject to change without notice. Version 1.1

Sungrow Deutschland GmbH | Balanstr. 59 | 81541 München | www.sungrowpower.com

3-phase Hybrids-FAQ

Replacement or expansion of residential energy

storage battery module

Applicable to: SBR HV Batteries

Scenario:

1. If the customer needs to add more battery modules (for example, add two

battery modules to an existing SBR096).

2. If one battery module is faulty and new battery module needs to be

replaced.

3. If two battery modules need to be removed.

Solution:

For scenarios 1 and 2, the battery modules in use need to be charged or discharged

to SOC of the new battery. New battery’s SOC can be estimated with knowing

manufacturing date and storage time. (see below table)

© 2021 Sungrow. All rights reserved. Subject to change without notice. Version 1.1

Sungrow Deutschland GmbH | Balanstr. 59 | 81541 München | www.sungrowpower.com

Assume for example that the SOC of the new battery module is 20%, and the

battery on user site is 70%, please proceed as follows:

Select Compulsory Mode in the Energy Management Parameters and set Charge

as a charging command.

Apply the settings.

Set the SOC Upper Limit to 100% and the SOC Lower Limit to 20 % (calculated

value for the new battery). Apply the settings. By charging the battery to 100%, a

calibration is performed to improve the accuracy of SOC.

(This takes some time, can be omitted and the target SOC value can be directly set

and charged or discharged to the target SOC.)

© 2021 Sungrow. All rights reserved. Subject to change without notice. Version 1.1

Sungrow Deutschland GmbH | Balanstr. 59 | 81541 München | www.sungrowpower.com

After charging to 100%, select discharge and Apply the settings. The battery will

automatically discharge to 20% and stop.

Now the battery SOC on user site is the same as SOC of the new battery module

20%, so the installer can install the new battery module.

After replacement, stop Compulsory mode and reset Upper and Lower SOC Limit

to its original values. (default: SOC upper limit 100%, SOC lower limit 10%

For scenario 3, we can remove two modules directly, because the power of the five

modules is the same. If we remove two battery modules, the remaining three

battery modules will also work normally.

For further information, please download the user manual here.

© 2021 Sungrow. All rights reserved. Subject to change without notice. Version 1.1

Sungrow Deutschland GmbH | Balanstr. 59 | 81541 München | www.sungrowpower.com

This manual is intended for professional technicians who are responsible for

installation, operation, maintenance and troubleshooting of inverters, and users

who need to check inverter parameters. The inverter must only be installed by

professional technicians.

The professional technician is required to meet the following requirements:

•Know electronic, electrical wiring and mechanical expertise, and be familiar

with electrical and mechanical schematics.

•Have received professional training related to the installation,

commissioning and troubleshooting of electrical equipment.

•Be able to quickly respond to hazards or emergencies that occur during

installation, commissioning and troubleshooting.

•Be familiar with local standards and relevant safety regulations of electrical

systems.

•Read this manual thoroughly and understand the safety instructions related

to operations.

This manual suits for next models

2

Table of contents

Other Sungrow Inverter manuals

Sungrow

Sungrow SG36KRL-M User manual

Sungrow

Sungrow SH5.0RT User manual

Sungrow

Sungrow SG125HV User manual

Sungrow

Sungrow SG15KTL-M User manual

Sungrow

Sungrow SG1100UD Series Instruction Manual

Sungrow

Sungrow SH RS Series Installation guide

Sungrow

Sungrow SG3125HV-20 User guide

Sungrow

Sungrow SH5K User manual

Sungrow

Sungrow SG9.0RS User manual

Sungrow

Sungrow SH4K6 Owner's manual

Sungrow

Sungrow SG2.0RS-S User manual

Sungrow

Sungrow SG250HX-IN-20 User manual

Sungrow

Sungrow SG110CX User manual

Sungrow

Sungrow SG250HX-IN User manual

Sungrow

Sungrow SG4K6TL-M User manual

Sungrow

Sungrow SH3K6-30 User manual

Sungrow

Sungrow SC50HV User manual

Sungrow

Sungrow SG8KTL-EC User manual

Sungrow

Sungrow SH5K-30 User manual

Sungrow

Sungrow SG36KTL-M Operator's manual

Sungrow

Sungrow PowCube 4.8 Installation guide

Sungrow

Sungrow SG125CX-P2PV User manual

Sungrow

Sungrow SG110CX User manual

Sungrow

Sungrow SG110CX User manual

Popular Inverter manuals by other brands

Fourgroup

Fourgroup Easy use and Programming Handbook

Velleman

Velleman PI300M user manual

WilTec

WilTec 61897 Operation manual

SMA

SMA SUNNY BOY STORAGE 2.5 Quick reference guide

Simplicity

Simplicity LANDLORD 316 product manual

Santak

Santak SMAX 3000 user manual

ATON

ATON RA.Store-3 user manual

ZIEHL-ABEGG

ZIEHL-ABEGG FXET4AMQ operating instructions

Tektronix

Tektronix CFG250 Operator's manual

Champion

Champion 200989 Operator's manual

Vanner

Vanner 20-500 Series owner's manual

GE

GE GEP user manual

Astrel Group

Astrel Group Power Reducer Installation and instruction manual

MULTIQUIP

MULTIQUIP GDP-5H Operation and parts manual

GoWISE

GoWISE PS1007 user manual

Promate

Promate PM13500D ES Operator's manual

Mastervolt

Mastervolt WHISPER 3.5M3000 RPM user manual

Mitsubishi Electric

Mitsubishi Electric FR-A7AZ instruction manual