ŸAlways keep the appliance clean and dry.
Do's
ŸClean the drum and roller holder assembly throughly after use and place it
back in the appliance.
ŸDo not repair the grinder by any unauthorized person. For repair the grinder
to nearest authorised service point dealer
ŸAlways keep the grinder clean and dry.
ŸEnsure close supervision when being operated in presence of children and
handicapped person.
FEW TIPS FOR BETTER PERFORMANCE
ŸDo not run your grinder in empty condition.
ŸDo not use any attachments other than those provided by the company.
ŸDo not fit and lift the drum or attachments when the grinder is in operation.
ŸAlways use 3 pin plug for the electric supply. Ensure that the earthing is
proper.
ŸDo not run the motor with extra load. if the motor does not start or it runs at
very low speed, remove the excess materials and run the grinder again.
ŸDo not Grind at low voltage.
ŸPlace the grinder on an even place and at convenient height.
ŸDo not allow the children to handle the grinder.
ŸDo not use fingers, knife or spoon in the drum while the drum is in operation.
DO'S AND DON'TS
ŸKeep the appliance away from heat sources.
ŸDisconnect, the electric cord from the mains, when the appliance is not in
use.
ŸDo not put your hand in the drum while in operations.
ŸDo not keep drum upside down after washing.
Don'ts
ŸDo not use any other attachments except those provided by the
manufacturer.
ŸDo not pour water on appliance for cleaning.
ŸDo not run the grinder empty for more than a minute.
ŸSwitch off and unplug appliance before removing the ground ingrediants.
OPERATION SEQUENCE
ADDITIONAL ATTACHMENTS
Coconut Scrapper
Coconut scrapper scrapes the
coconut to fineness for tastier
chutney, kurma and for other
coconut delicacies.
Atta Kneader
At t a k ne ad er effec t i ve ly
kneads to the right consistency
an d m ake s Rot i es , P ur l s
Chapathies & parathas tastier.
(Capacity maximum 400grm)
Remove roller stones and fix the coconut scrapper on the top of the centre shaft.
Gently fix it in the groove provided. Take one half of the coconut and hold it firmly on
the scrapper, then switch on the grinder. after scrapping is over, remove scrapper
and collect coconut bits from drum assembly
Remove roller stones and place atta kneader in the drum and place the nut setting
on the centre shaft. Add atta in the drum assembly. Pour a little water and switch on
the grinder. Add a little oil and salt to taste. Add water till you get required
consistency.
Place the Drum Assembly on
the Centre Shaft. Gently Rotate
the Drum till it seats properly
Place the Roller assembly
on the centre shaft as shown
in the Figure
Place the Top nut with
spring assembly and fix
it by tightening
Pour a cup of water in
the Drum
Press "ON" switch to
Start the Grinder
Put the Grinding
Items in small quantities
with adequate water
Place the glass lid
while running the machine
After the required
consistency is achieved
switch OFF the Grinder
Remove the Roller
assembly and wipe down
the batter for cleaning
Clean and wash the drum
and Stone assembly
thoroughly
1
6
2
7
3
8
4
9
5
10
