
Installing the cooktop
Let’s get your new ceramic
cooktop ready to use!
Quick Start Guide
Model: STR-GCC60
Preparation
Cooking
1
1
6
6
2
2
3
4
43
5
5
2
3
Switch on one cooking zone at a time and let it heat up
for 5 minutes at the maximum setting.
Place a saucepan filled half full with cold water on each
zone as you burn it off, one zone at a time.
Any odour or smoke on first use can be disregarded
safely. It will disappear with repeated use. Ensure good
ventilation.
Touch the ON/OFF control to switch on the cooktop.
All indicators will show [ – ].
Place a pan on the cooking zone you want to use.
The pan and cooking zone diameters should match.
Make sure the bottom of the pan and the surface of the
cooking zone are clean and dry.
Select a heat setting by touching the [ - ] or [ + ] control
for the cooking zone you want to use. You must do
this within one minute, otherwise the cooktop will
automatically switch off.
When you have finished cooking, turn the cooking zone
off by touching the [ - ] control until [ 0 ] is shown, or by
touching the [ - ] and [ + ] controls at the same time.
Turn the whole cooktop off by touching the
ON/OFF control.
IMPORTANT! This cooktop must be professionally installed to an appropriately earthed
wiring system by a licensed electrician, following the instructions in the supplied
instruction manual.
Please ensure you make the manual available to the electrician. Do not try to install the cooktop yourself!
Doing so will expose you to danger and could invalidate any warranty or liability claims.
Consult the full instruction manual for comprehensive installation, usage and cleaning instructions and
important safety advice. This Quick Start Guide only contains basic usage instructions.
NOTE: Before using the cooktop for the first time, heat up each cooking zone to help eliminate any ‘new’ smell
that exists and evaporate any humidity that may have formed on the heating elements during transit.
1
Nearly done! Just a bit more on the
other side of this page...
7
7
8
8