When using solvents and cleaning agents based on halogenated hydrocarbons e.g. 1.1.1-trichlorethylene and methylene
chloride, chemical reactions can occur on the aluminium cup, gun and on galvanized components (small quantities of water
added to 1.1.1-trichlorethyelen produce hydrochloric acid). This can cause oxidation of the components: in extreme cases, the
reaction can be explosive. Therefore only use solvents and cleaning agents for your paint gun which do not contain the
substances named above. Never use acid for cleaning purposes.
Never point paint guns at yourself, at other persons or animals. Solvents and diluting agents can cause burns. Before any
repair work may be carried out, the unit must be disconnected from the compressed air network and pressure must be
released. Before starting to use the paint gun, Particularly after repairs, ensure that screws and nuts are correctly tightened,
and check that gun and hoses do not leak. Defect components must be replaced or repaired, use original spare parts only. No
sources of ignition (e.g. open flames, burning cigarettes, lamps without ex-protection etc.) may be present during painting, as
easily flammable mixtures are generated during the painting process. Occupational safety regulations must be applied when
painting (respirator protection etc.). Appropriate ear protection muffs are required, as a sound level of 90dB(A) can be
exceeded when painting under higher pressure levels.
PLEASE READ BEFORE USE
CAUTION!
WARNGING!
Possible failures in operation
Trouble Cause Repair
1.Gun leaks from fluid tip 1.Foreign substances between fluid tip and
needle prevent sealing
1.Clean fluid needle and fluid nozzle in thin-
ner or use new set nozzle
2. Paint merges from fluid needle - needle
sealing
2. Self tensioning needle sealing damaged
or lost
2. Replace needle sealing
3.Spray pattern in sickle
shape
3.Horn air holes or air circuit clogged 3.Soak in thinner, afterwards clean with
the nozzle - cleaning needle.
4. Drop like or oval shaped
pattern 4. Dirt on fluid pin tip or air outlet 4. Turn air nozzle by 180 degrees.
lf defective pattern remains, clean
fluid tip pin and air circuit.
5. Paint Spray flutters 5. Too little material in cup, fluid nozzle not
tight self-adjusting, needle sealing damaged,
nozzle set dirty or damaged.
5. Refill material, tighten parts, if
necessary clean or replace parts.
6.Material bubbles or boils in paint cup
6.Atomization air flows through the paint channel
to the cup. The paint nozzle is not sufficiently
tightened. Air nozzle is not completely screwed
on, the air nut clogged and the seat is defective
or nozzle insert is damaged.
6.Tighten parts accordingly, clean or
replace.
