Stagg Ecopar 630 31 User manual

USER MANUAL

Ecopar 630 31

SLI-Ecopar63031

Please read the instructions carefully before use

SAFETY INSTRUCTIONS

Please read the instructions carefully as they include important

information about the installation, operation and maintenance.

• Please keep this user’s guide for future consultation. If you sell the unit to another

user, be sure that they also receive this instruction booklet.

• All fixtures leave the manufacturer intact. Please note that any damages incurred

by the user is not covered by the guarantee.

• Unpack and check carefully that there is no transportation damage before using the

unit.

• The unit is for indoor use only. Use only in a dry location.

• Use a safety bond when attaching the fixture to a lighting rig. Handle by the

hanging bracket when fixing.

• The unit must be installed in a location with adequate ventilation at least 50 cm

from adjacent surfaces.

• Make sure that no ventilation slot is blocked, otherwise the unit will overheat.

• Before operating, ensure that the voltage and frequency of the power supply match

the power requirements of the unit.

• Make sure all equipment is properly earthed.

• Do not operate the unit if the ambient temperature is higher than 40°C.

• Do not hardwire to any mains dimmer.

• On the first start, there may be some normal operational start-up smell.

• Make sure that there is no flammable material close to the unit while operating, as

it is a fire hazard.

• Examine power wires carefully and replace immediately if there is any damage.

• Never run on for a long time lest shortening lifespan. Avoid any inflammable liquids,

water or metal objects entering the unit. In case it happens, cut off the mains power

immediately.

• Do not operate in a dirty or dusty environment. Clean fixtures regularly.

• Do not allow children unsupervised to operate the fixture.

• Do not touch any wire during operation as there might be a hazard of electric

shock.

• Avoid placing power wires next to other cables.

• Disconnect the mains power before replacing or servicing the fuses.

• Replace fuse only with the same type.

• In the event of a serious operating problem, stop using the unit immediately.

• Never turn on and off the unit time after time.

• The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly

damaged.

• Do not open the unit as there is no user serviceable part inside.

• Never try to repair the unit by yourself. Repairs carried out by unskilled people can

lead to damage or malfunction. Please contact the nearest authorized technical

assistance centre.

• Disconnect the mains power if the fixture is not used for a long time.

• Use the original packaging to transport regarding any warranty issue.

• Do not look directly at the LED light beam while the fixture is on.

• Do not connect more than 7 units to the same power source.

INSTALLATION

The unit should be mounted via its screw holes on the bracket. Always ensure that the

unit is firmly fixed to avoid vibration and slipping while operating. Always ensure that

the structureto which you are attachingthe unit is secure and able to support 10 times

the unit’s weight. Also, always use a safety cable that can hold 12 times the unit’s

weight when installing the fixture.

The equipment must be fixed in an appropriate place by professionals. Keep it out of

the reach of unqualified people.

TECHNICAL SPECIFICATIONS

Flat ECOPAR 6 spotlight with 6 x 30-watt RGB (3 in 1) LED

- LED: 6 x 30 watts

- Protocol: DMX-512, 8 channels

- Functions: Dimmer (0-100 %), strobe (0-20 Hz), auto, sound control, master/slave.

- Display: 4-digit

- Housing: ABS

- Fixation: 2 brackets (to hang or lay the spotlight)

- Input and output: 3-pin DMX and IEC

- Cooling: Low-noise fan

- Use: Indoor

- Power consumption: 200 watts

- Dimensions: 215x210x100 cm (8,5 x 8,3x 3,9")

- Weight: 1.5 kg (3,3 lb)

SETTING UP THE DEVICE

DMX Mode

With the menu button, select the DMX mode (dxxx) and press the enter key to

confirm. Then use the up and down buttons to choose the desired DMX channel (1 –

512) and press the enter key to confirm.

Press the menu button to return to the main menu.

Channel

Range

Function

CH1

0-255

Dimmer

CH2

1-255

Strobe

CH3

1-255

Macro function

CH4

0-255

Macro speed adjust

CH5

0-255

Red

CH6

0-255

Green

CH7

0-255

Blue

Automatic mode

With the menu button, select the automatic mode (Auxx) and press the enter key to

confirm. Then use the up and down buttons to choose between

- Au01 to Au10 and press enter. In this mode, the fixture will play an automatic

sequence.

- So01 and So02 and press enter. In this mode, the fixture will react to the sound

thanks to the integrated microphone.

Strobe Mode

With the menu button, select the Strobe mode (Stxx) and press the enter key to

confirm. Then use the up and down buttons to select the desired mode.

-St00: Auto Master without strobe

-St01 to St16: Strobe Speed from slow to fast

In this mode, the fixture will play flashes at different speeds.

Sound Mode

With the menu button, select the Sound mode (Snxx) and press the enter key to

confirm. Then use the up and down buttons to select the desired preset from Sn01 to

Sn16.

Speed control

With the menu button, select the Speed control mode (Spxx) and press the enter key

to confirm. Then use the up and down buttons to select the desired preset from Sn00

to Sn16.

Thanks to this function, you can adjust the speed of the automatic mode. From slow

to fast.

Colour mode:

With the menu button, select the Red (rxxx) Green (Gxxx) or blue (bxxx) and press

the enter key to confirm. Then use the up and down buttons to increase or decrease

the colour amount (from 001 to 512).

Thanks to this colour mixing mode, you can virtually choose all the desired fixed

colours.

DMX512 CONNECTIONS

The DMX512 is widely used in intelligent lighting control, with a maximum of 512

channels.

Warning

To avoid signal transmission problems and interferences when using fixtures in

chain, use a Stagg N-series professional 3-pin DMX terminator (resistance: 120

ohms; pin2: DMX-; pin3:DMX+).

FIXTURE CLEANING

An internal cleaning must be carried out periodically to optimize the light output. The

cleaning frequency depends on the environment in which the fixture operates: A

damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt

on the fixture’s optics. Clean the fixture with a soft cloth and normal glass cleaning

fluid. Always dry the parts carefully. Clean the external optics at least every 20 days.

For more info and the latest product updates:

staggmusic.com

EMD Music S.A.

Boulevard Général Wahis 16A

1030 Brussels

Belgium

05/2018

Table of contents

Other Stagg Lighting Equipment manuals

Stagg

Stagg HEAD BANGER 10 SLI MHW HB10 User manual

Stagg

Stagg TAGGER 30 User manual

Stagg

Stagg KINGPAR 1 User manual

Stagg

Stagg HEADBANGERXT SLI MHW HBXT User manual

Stagg

Stagg FlatPar 4 User manual

Stagg

Stagg HEADBANGER10 MK3 User manual

Stagg

Stagg Hyperion 5R User manual

Stagg

Stagg HYPERNOVA SDJ-HYPERNOV1 User manual

Stagg

Stagg SLI-MHBHH10 User manual

Stagg

Stagg TRITON SDJ-TRITON User manual

Stagg

Stagg EcoPar6 User manual

Stagg

Stagg HeadHunter10 SLI-MHBHH10 User manual

Stagg

Stagg EcoParXS User manual

Stagg

Stagg Truss34 User manual

Popular Lighting Equipment manuals by other brands

Brizo

Brizo 8SP-MU-4 manual

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 installation instructions

IKEA

IKEA BJÖRKSPIREA manual

Laserworld

Laserworld Evolution Series ES-400RGB manual

Alien

Alien RG STAR user manual

EuroLite

EuroLite LED B-40 user manual

Qazqa

Qazqa Suplux SL 3 Black 103062 instruction manual

Commercial Electric

Commercial Electric 54568141 Use and care guide

CREE LIGHTING

CREE LIGHTING 304 Series installation instructions

Goobay

Goobay 49867 user manual

ECOMAN ITALIA

ECOMAN ITALIA LED T8 instruction manual

Alkalite

Alkalite Krypton KT-81 user manual

Clas Ohlson

Clas Ohlson GU10 manual

DTS

DTS DELTA 10 F user manual

ring

ring Solar Steplight manual

One Stop Gardens

One Stop Gardens 57696 Owner's manual & safety instructions

Chauvet DJ

Chauvet DJ COREpar UV120 ILS user manual

SIREM

SIREM Swimeo A2 instructions