— 32 —— 7 —
Connect to MP3 or CD player
Connect the output of MP3 or CD player or other audio sources withAUX. IN connector. The
volume can be adjusted by the master volume control knob on the module. The input signal
can be mixed with the drum signal, strike the pads according to the rhythm of the input signal.
Connect with computer
1. Connect the computer via USB cable when it’s powered off
2. Turn on the computer and then turn on the device, when the connection is successful,
you can receive and send MIDI information.
TROUBLE SHOOTING
Reason or solutionProblem
No sound /
sound is too low
No sound on the
external drum pad
No sound on the
external drum pad
No sound on
DEMO SONG
There is no sound
output connected to
MIDI communication
devices
1、Make sure the volume knob is set correctly and adjust
the volume knob
2、Check whether the audio cable between the audio source and
the power amplifier or other playback equipment is connected
correctly. Replace the cable to test.
3、If you are connecting to the audio device through the mixer,
please insert a good earphone into the headphone output jack of
the audio source. If there is sound, please check whether the cable
is normal, the Settings and connections of the mixer and audio
equipment normal?
1、Please make sure that the connecting wire between the drum pad
and the host machine is connected correctly and in place.
2、Check whether setting "LOCAL" to "OFF". If setting to "OFF",
there is no sound output on the drum pad.
3、Check whether the corresponding drum volume is set to 0.
Whether the metronome volume is 0
Please make sure the volume of DEMO SONG is not 0
1、Check whether the USB cable used to connect is damaged.
2、Verify whether the communication channel is set correctly. The
communication channel set by the audio source is 10 channels by
default. If the audio source is set to other channels, other MIDI
devices should also be set to corresponding channels.
ECNJG2106168
