Sound Town PAC180-6 User manual
2021 SOUNDTOWN // Features and specifications are subject to change and or improvement without notice.
PAC180-6, PAC360-6
PUBLIC ADDRESS AMPLIFIER WITH BLUETOOTH
USER MANUAL
IMPORTANT SAFETY INSTRUCTIONS FEATURES
IN THE PACKAGE
12
EN
1. Read all safety and operating instructions before using this product.
2. All safety and operating instructions should be kept for future reference.
3. Read and understand all warnings listed on the operating instructions.
4. Follow all operating instructions to operate this product.
5. This product should not be used near water, i.e. Bathtub, sink, swimming pool, web basement etc.
6. Only use dry cloth to clean this product.
7. Do not block any ventilation openings, it should not be placed flat against a wall or placed in a built-in
enclosure that will impede the flow of cooling air.
8. Do not install this product near any heat sources, such as, radiators, heat registers, stove or other apparatus
(including heat producing amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The side
blade or the third prong are provided for your safety if the provided plug does not fit into your outlet, consult
an electrician for replacement of the obsolete outlet.
10. Protect the power cord being walked on or pinched particularly at Plugs, convenience receptacles and the
point where they exit from the apparatus. Do not break the ground pin of the power supply cord.
11. Only use attachments specified by the manufacturer.
12. Use only the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus.
When a cart is used use caution when moving cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Care should be taken so that objects do not fall and liquids are not spilled into the unit through the ventilation
ports or any other openings.
15. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged
in any way; such as, power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into
the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally or has been
dropped.
16. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
17. When the MAINS plug, or an appliance coupler is used as the disconnect device, the disconnect device should
remain readily operable.
18. Protective Ground Terminal: The apparatus shall be connected to an AC main socket with a protective earth
ground connection.
2 MIC (1 Priority MIC) and 3 LINE inputs
1 LINE output
BLUETOOTH, USB, FM input with LCD display
Level indicator, power and clip indicator
Treble / Bass control & effect (Echo & Delay)
Over current, short circuit protection
70V / 100V outputs
Low impedance 4~16 ohm outputs
6 zone outputs (70V) with individual volume control
1 PAC amplifier
1 Power cable
1 Remote control
1 User Manual
1 Warranty Card
FRONT PANEL REAR PANEL
16 17 18
19
20
21
13 4
12
13 14
5 6
78 9
10
11
34
EN
1. MP3 PLAYER: Bluetooth, USB, FM and recorder (with LCD display)
2 x 1/4" jack are provided for microphone inputs, MIC 2 is priority mic.2. MIC SOCKET:
2 rotated knobs to adjust the level of 2 microphone input signals.3. MIC LEVEL CONTROL:
3 rotated knobs to adjust the level of 3 line input signals. (MP3 & LINE 3 share the4. LINE LEVEL CONTROL:
same level control).
To increase or decrease the high frequency of the input signal.5. TREBLE:
To increase or decrease the low frequency of the input signal.6. BASS:
To adjust the volume of echo effect.7. ECHO:
To adjust the delay depth.8. DELAY:
Individual volume control for 6 zone, each knobs adjustable in 5 steps.9. 6 ZONE VOLUME:
The LED illuminates when the amplifier is turned on; the LED flashes when10. INDICATOR: ‘POWER’ ‘PROT’
fault is detected such as short-circuited or over heat, need to turn off the amplifier immediately; LED3-segament
indicates the master output level. The LED lights up when the amplifier is nearing clipping, an occasional‘CLIP’
flickering is acceptable, if it’s lit continuously, adjust the level control and reduce the output volume. Failure to do
so may lead to premature failure of your speaker.
Push the button for a CHIME.11. CHIME:
To turn on/off the amplifier.12. POWER SWITCH:
MP3 PLAYER WITH BLUETOOTH AND RECORDER
Press to switch the signal source from BLUETOOTH/USB/FMA. MODE:
B. PLAY/PAUSE.
Short press to jump to previous song; press and hold to enterC. PREV:
rewinding state.
Short press to jump to next song; press and hold to enterD. NEXT:
forwarding state.
Short press once to start recording, press again to endE. RECORD:
recording.
Internal mic. for recording.F. MIC:
Infrared sensor for remote control.G. IR:
input socket.H. USB
13. LINE1, LINE2, LINE3 INPUT: 3 x RCA connectors are provided for 3 line level signal inputs.
One RCA connector is provided for signal output (mixed output).14. LINE OUT:
This is the common post, for whichever 70V/100V/4~16ohm connection,15. COM OUTPUT SOCKET:
need to connect the negative ends to the 'COM' post.
For a 4~16 ohm low impedance speaker, connect16. LOW IMPEDANCE OUTPUT BINDING POST:
the positive ends to the '4~16 ohm' red post and the negative ends to the 'COM' post.
To provide 70V voltage output, for your speaker with 70V transformer,17. 70V OUTPUT BINDING POST:
connect the positive ends to the '70V' red post and the negative ends to the 'COM' post.
To provide 100V voltage output, for your speaker with 100V18. 100V OUTPUT BINDING POST:
transformer, connect the positive ends to the '100V' red post and the negative ends to the 'COM' post.
To provide 70V voltage output dividing into 6 different zone.19. 6 ZONE OUTPUT BINDING POST:
This switch is supplied for moving the amplifier from 110 voltage (U.S. Standard)20. Voltage selection:
to 230 voltage (European Standard). The switch needs to be set on proper voltage for your area.
This receptacle is for connecting the included IEC power cable. It is important to supply21. AC INPUT:
the proper AC line voltage to the unit. Do not connect to intermittent or faulty power.
2
SPECIFICATIONS
56
EN
How can we help you?
CONTACT OUR US-BASED SUPPORT TEAM
Simple or complex, your questions are important to us. For service, support
or more information, please contact the Sound Town support team:
Email: [email protected]
MODEL
OUTPUT POWER
OUTPUT TYPE
MIC INPUT
LINE INPUT
FREQ. RANGE
DISTORTION
S/N AUX
RATIO MIC
VOLTAGE
DIMENSION
PACKING SIZE
N.W.
G.W.
PAC180-6
180W RMS
70V/100V/4~16Ω
3mV, 600Ω
200mV, 10kΩ
50Hz~20kHz
0.5% (1kHz)
88 dB
116 dB
110V/230V
19" x 15.3" x 3.5" (2U)
21.9" x 18.3" x 7.5"
22 Lbs
24.5 Lbs
PAC360-6
360W RMS
70V/100V/4~16Ω
3mV, 600Ω
200mV, 10kΩ
50Hz~20kHz
0.5% (1kHz)
88 dB
116 dB
110V/230V
19" x 15.3" x 3.5" (2U)
21.9" x 18.3" x 7.5"
26 Lbs
28 Lbs
This manual suits for next models
1
Other Sound Town Amplifier manuals
