Sony CDX-530RF - Compact Disc Changer System Product guide

SON3t: 3-_7.700.11/1)

Compact Disc

Changer System

Installation/Connections

CDX-530RF

Parts list

The numbers in the list are keyed to those in the

instructions.

® ®

x4 x4

CD changer

• Choose the mounting location carefully,

observing the following:

-- Do not install the unit where;

• the ambient temperature exceeds 55 _C

(131 _).

• it will be exposed to direct sunlight or hot

air from a heater.

• it will be exposed to rain, water, or high

humidity.

• it will be exposed to a lot of dust.

• it will be subject to excessive vibration.

-- The fuel tank should not be damaged by

the tapping screws,

-- There should be no wire harnesses or

pipelines under the place where you are

going to install the unit.

-- The spare tire, tools, or other equipment in

or under the trunk should not be interfered

with or damaged by the screws or the unit

itself.

Notes

• Be sure to use only the supplied mounting

hardware for a safe and secure installation.

• Make holes of€3.5 mm (5/3_In.) only after making

sure there isnothing on the other side of the

mounting surface,

Wired remote

• Avoid mounting it where it may:

-- hinder normal driving activities.

-- jeopardize the passengers.

-- be exposed to hot air from the heater.

-- be exposed to direct sunlight.

• After installing the unit, make sure the whole

unit can be operated by the wired remote.

Connections

Caution

• This unit is designed for negative ground 12 V

DC operation only.

• Before making connections, disconnect the earth

terminal of the car battery to avoid short circuits.

•Connect the yellow and red power input leads

only after all other leads have been connected.

• Be sure to connect the red power input lead to the

positive 12 V power terminal which is powered

when the ignition switch is in the accessory

position.

•Run all earth wires to a common earth point.

•When finished making all the connections,

press the reset button of the CD chnager. (See

"Reset button" below.)

•The use of optical instruments with this product

will increase eye hazard.

Reset button

After the installation and connections are completed, after the batteries have been changed, be sure to

press the reset button with a ball*point pen, etc.

Connectiondiagram

from the car antenna*

Speaker system Caraudio

*An adaptor {optional) may be necessary Foryour

car and car audio system. In such a case, consult

your dealer.

Antenna connector*

0.5 m

0,5 m

Relay box

_lm

Fuse

5,5 mFuse

_5.5 m

5,5 m

Relay box

_lm

Black

Fuse 0

5,5 m Fuse

--5.5 m

5,5 m

to ametal point on the car

First connect the black earth lead, then connect the yellow

and red power input leads.

to the +12 V power terminal which ispowered at all times

Be sure to connect the black earth lead first.

to the +12 V power terminal which ispowered when the

ignition key mNitch is in the accessoryposition

Be sure to connect the black earth lead first.

*An adaptor (optional) may be necessary foryour

car and car audio system. In sucha case, consult

your dealer.

6rn

Wired Remote

5.5 m

5,5 rn

Insert the connector until it

locks.

Relay box

WARNING

Plug the connector into the jack

on the left side of the CD changer.

Make sure that the catch of the

connector is secured in the hole

next to the jack.

Fuse replacement

If the fuse blows, check the power connection and

replace the fuse. If the fuse blows again after

replacement, there may be an internal malfunction.

Warning

Use a fuse with the specified amperage rating.

Use of a higher amperage fuse may cause serious

damage.

Installing the wireless remote

Use the supplied velcro tapes (_), and mount the wireless remote in a suitable location where it will not

interfere with your driving.

to where it isgoing to be mounted

Relay box

®5,5 m

CDc_n_r

ARNING

ug the connector into the jack

the left side of the CD changer.

ake sure that the catch of the

nnector is secured in the hole

xt to the jack.

_to where it isgoingto bemounted

Wired remote (RM-X87)

Note

The supplied wireless remote (RM-X89) can be

operated almost like the wired remote (RM-X87).

DISC +/-

Changing the transmitting

frequency

Because this unit processes CD playback sound

through an FM tuner, there may be interference

no,he during CD playback. In such a case, change

the frequency of the modulated RF signal

transmitted from the unit. The initial setting is

883 MHz.

1 Press _for two seconds until

frequency appears.

2 Press _or _repeatedly to

select the frequency.

Each time you press _ or (]_!_E), the

frequencies change as follows:

:88.3 MHz _ 89.9 MHz --* 89.7 MHz

89.5 MHz ---*89.3 MHz --*

89.1 MHz _ 88.9 MHz --* 88.7 MHz

--* 88.5 MHz _ 88.3 MHz

:88.3 MHz .--* 88.5 MHz --_ 88.7 MHz

--_ 88.9 MHz _ 89.1 MHz ---*

8g.3 MHz .--* 89.5 MHz ---*89.7 MHz

-+ 89.9 MHz _ 88.3 MHz

3 Press _for two seconds.

Using on the wireless remote

1 Press _for two seconds until

frequency appears.

2 Press _or _repeatedly to

select the frequency.

3 Press _for two seconds.

Notes

•Whenyou changethe transmitting frequency on the

unit, be sureto tune your FM tuner to the newly

selectedone,

•Press_on the wiredremote before changingthe

frequency if the power of the unit isturned off.

Changing the output level

You can select the output level from the unit.

Normally the unit is used at the initial output

level; change the level if necessary.

1 Press _for two seconds.

2 Press _momentarily.

[LEYEL 3IInitialSetting

3 Press _or _repeatedly to

select the output level.

To decrease the output level

To increase the output level

_:[ LEI,'EL 5

4 Press _for two seconds.

Using on the wireless remote

1 Press _for two seconds.

2 Press _again momentarily.

3 Press _or _to select the

output level.

4 Press _for two seconds.

Note

When`youselectlevel4 or 5, the CDplaybacksound

maybe distortedor youmay hearsomenoise.In such

a case,selecta lower output levelon the unitand turn

down the overallvolumeon `yourcaraudio.

Installation

How to install the CD changer

•When you install the CD changer, be careful not to damage wiring or equipment on the other side of the

mounting surface.

• The brackets (_) provide two positions for mounting, high and low. Use the appropriate screw holes

according to your preference.

Horizontal installation

Align with the marked position.

Vertical installation

velm_L

Alignwith the marked position.

Other manuals for CDX-530RF - Compact Disc Changer System

Table of contents

Other Sony CD Player manuals

Sony

Sony CFD-DW83 - Cd Stereo Am/fm Cassette Recorder User manual

Sony

Sony D-NE700 User manual

Sony

Sony CD Walkman D-F525 User manual

Sony

Sony WX-GT80UI User manual

Sony

Sony XDCAM XDJ-1000 User manual

Sony

Sony DVP-SR401HP User manual

Sony

Sony D-NE715 - Portable Cd Player User manual

Sony

Sony CDP-D12 Dimensional drawing

Sony

Sony CD Walkman D-EJ885 User manual

Sony

Sony CDP-C745 User manual

Sony

Sony D-140 User manual

Sony

Sony CDX-GT360MP User manual

Sony

Sony XDCAM PDW-1500 User manual

Sony

Sony CDP-CX151 User manual

Sony

Sony CDP-C460Z User manual

Sony

Sony STR-DH800 Use and maintenance manual

Sony

Sony CFDG700CP - Xplod Boombox User manual

Sony

Sony CDX-CA760X - Fm/am Compact Disc Player User manual

Sony

Sony CDP-CX300 - MegaStorage 300-CD Changer User manual

Sony

Sony DVP-CX777ES Quick setup guide

Sony

Sony CDX-L300 Installation/Connection User manual

Sony

Sony S300 - CFD Boombox User manual

Sony

Sony Hi-MD Walkman MZ-RH910 User manual

Sony

Sony CDX-F5700 - Fm/am Compact Disc Player User manual

Popular CD Player manuals by other brands

RCA

RCA RP-7923 instruction manual

Pioneer

Pioneer DEH-P3550MP XM Operation manual

Philips

Philips AZ1207 owner's manual

Philips

Philips CD582 user manual

Philips

Philips AZ 6821 operating manual

Lasonic

Lasonic MSU-2020 user manual

THOMSON

THOMSON RCD150 user manual

Denon

Denon DCD-1420 Service manual

Panasonic

Panasonic SJ-MR100 operating instructions

Onkyo

Onkyo DX-7210 instruction manual

Denon

Denon DVM-4800 Service manual

JBL

JBL MR-32 Operation manual

RCA

RCA RCD152 Specifications

Technics

Technics SL-PS770A Service manual

Clarion

Clarion compact disc owner's manual

Philips

Philips Expanium AZ 1538 user manual

Rotel

Rotel RCD 975 owner's manual

Pioneer

Pioneer CLD-D790 Service manual