8
User GuideRG-1000e Remote Gateway R2.2.2 v2
2 System structure
The system of control station remote management consists of the following components:
· RG-1000e
· Radio connected to the RG-1000e
· SmartPTT software based on the Client–Server technology
The RG-1000e is connected and interacts with the SmartPTT server-based application that is used for controlling
it. For establishing an IP network connection, the RG-1000e is equipped with the 10BASE-T/100BASE-TX
Ethernet interface with the cable type autodetection. To provide interaction between the system components, the
RG-1000e and the radioserver are assigned static IP addresses and TCP and UDP/RTP port numbers. They are
used for sending radio control commands and audio transmissions from the dispatch console. The RG-1000e can
be used in the following cases:
· As a remote dispatcher's workplace outstation in digital networks without repeaters (Direct Mode
communication).
· In conventional or trunking MOTOTRBO networks where direct IP connection to repeaters is unavailable.
· In MOTOTRBO networks where connection to repeaters is established according to the hybrid scheme (data
calls are performed via the NAI interface of the repeater, voice calls are performed via the control station.
· In conventional or trunking non-MOTOTRBO networks where the RG-1000e is connected to control stations
and\or repeaters using GPIO lines.
The system offers the following advantages:
· You can organize a dispatch system in the networks where direct connection of the dispatch system to the
MOTOTRBO repeaters via an IP network is unavailable.
· You do not have to instal the radioserver in close proximity to the control stations within the radio network
coverage area.
· You can avoid interference and induced noise between the control stations located close to each other.
When planning the system, it must be taken into account that the packet delivery delay in the IP network leads to
the corresponding delay in radio responses to control commands and voice calls.
