SmartLock UNRD Series User manual
Pace the Marking Gauge over the Tube,
using the guideline. Mark a line on the
Larger Tube and the Smaller Tube .
12
Visit www.smartlockfitting.com for video guide
Union Reducer
Model Type Code: UNRD
4Remove the Larger Positioning Strip.
3Ensure the marked line is visible on
the Larger Tube.
1
2Insert the Larger Tube into the
Larger Nut until the Tube stops.
*Must start with the Larger Tube.
1
1
2
Installation Guide
214-304-2083
www.smartlockfitting.com
1. CLOSELY FOLLOW INSTALLATION GUIDE TO PREVENT ANY
INSTALLATION MISTAKES.
2. DO NOT REMOVE POSITIONING STRIP PRIOR TO ASSEMBLY.
3. DO NOT REUSE FITTING.
4. DO NOT USE TUBE WITH DAMAGES 2 INCHES FROM THE
TUBE END.
5. DO NOT BEND TUBE AFTER CONNECTION IS MADE.
6. DO NOT USE OTHER THAN FOR INTENDED PURPOSE.
!CAUTION
Marking Gauge
Larger Nut
Smaller Positioning Strip
Smaller Tube
Larger Positioning Strip
Body Smaller Nut
Larger Tube
1
5Hold the Body then hand tighten
the Larger Nut.
2
7Ensure the marked line is visible on
the Smaller Tube.
8Remove the Smaller Positioning Strip.
6Insert the Smaller Tube into the
Smaller Nut until Tube stops.
10
With the 1st wrench hold the Body.
With the 2nd wrench tighten first the
Larger Nut then the Smaller Nut.
Torque values are avaiable on the website if desired.
*Must wrench tighten the Larger Nut first.
Wrench tighten until there are no gaps
and the Larger Nut, Body, and
Smaller Nut are completely flush.
*If the marked lines are
visible, fitting and tube
are seated properly.
11
9Hold the Body then hand tighten
the Smaller Nut.
2
Table of contents
Other SmartLock Lock manuals
SmartLock
SmartLock 301 User manual
SmartLock
SmartLock LOCK-ONE User manual
SmartLock
SmartLock LOCKONE User manual
SmartLock
SmartLock Y797 User manual
SmartLock
SmartLock DEADBLOT Service manual
SmartLock
SmartLock S31 User manual
SmartLock
SmartLock VISION User manual
SmartLock
SmartLock H50-TYW User manual
SmartLock
SmartLock VISION User manual
SmartLock
SmartLock W-0309 User manual
