Singer MT624 User manual
P a g e 1 of 8, V1
SuperbaKnit interface electronic hardware exchange for MT624 & 9000
The picture below shows the Singer MT624 knitting machine.
Place the bed on a table or workbench with the right end hanging free to give access to
the bottom.
P a g e 2 of 8, V1
Remove the screw that holds the small plastic cover piece
P a g e 3 of 8, V1
Slide the cover to the right and remove it completely.
P a g e 4 of 8, V1
After removal of the plastic cover, your machine will look similar to the picture
above.
P a g e 5 of 8, V1
Remove the printed circuit board from the connector.
P a g e 6 of 8, V1
The MT 624 after removal of the PCB.
Now you have to cut the red wire that comes from somewhere under the metal belt,
and runs either to the black connector, or disappears in the cable sleeve whit the
other 4 visible wires.
P a g e 7 of 8, V1
Make sure you do not cut a second red wire that runs from the connector into the
cable sleeve. If the red wire goes to the connector, cut the red wire close to the
connector. If the red wire goes into the cable sleeve, cut the red wire where the red
wire enters the cable sleeve. This gives the maximum length for this piece of wiring.
Then enter this lose end of red wire in the clamp connector. No need to remove
insulation. Put it right in the middle and then snap together the clamp. It usually
needs no tools, just your fingers, to close the clamp.
The result should look as above.
P a g e 8 of 8, V1
Attach the connector at the end on the header in the middle of the new pc board,
and insert the pc board into the black connector. Center the contacts well and make
sure the board is inserted to its maximum position.
It should look now as above.
Now you have to adjust the 2 potentiometers that control the optical sensor
sensitivity. For instructions, please consult the “SuperbaKnit Interface A
Adjustments” document.
Place back the plastic end cover of the bed just in the reversed way as you removed
the cover, and secure the cover with the screw from the bottom side.
This manual suits for next models
1
Other Singer Sewing Machine manuals
Singer
Singer 5528 User manual
Singer
Singer 81K70 Quick start guide
Singer
Singer 1591D200A User manual
Singer
Singer 271K11 User manual
Singer
Singer 79-103 User manual
Singer
Singer Touch & sew 646 User manual
Singer
Singer 6105 User manual
Singer
Singer 96-41 User manual
Singer
Singer 111W103 User manual
Singer
Singer 5130 Series User manual
Singer
Singer 451K2 User manual
Singer
Singer 153W102 Quick start guide
Singer
Singer 147-115 Quick start guide
Singer
Singer 1591D200A Setup guide
Singer
Singer 20UX142 User manual
Singer
Singer 138K1 Setup guide
Singer
Singer 71-112 Quick start guide
Singer
Singer Stylist 457 User manual
Singer
Singer 1412 User manual
Singer
Singer FEATHERWEIGHT II 118 User manual
