Simu TSA 4 Installation manual
Hz Key Chain Transmitters 2 and 4 channels
Read all instructions carefully before use.
Hz Key Chain Trans
®
1) Program the motor using a
standard transmitter as per the
quick reference guide
2) Press the programming button
on the standard transmitter until
the motor jogs up/down
3) Touch the programming
contact on the back of the Key
Chain Transmitter with a metal
conductor (paper clip). The LED
on the front will start to flash
Programming
Contact
Paper
Clip Flashing LED
4) Press the desired front button
while the LED is still flashing. The
motor will jog. This button will now
control the motor.
Repeat steps 1 through 4 for other buttons to other motors if desired.
Note: Only program one motor per button. The 2 channel key chain can be used
to control 2 motors maximum and the 4 channel can control 4 motors maximum
Programming Instructions
PGR
PROGRAMMING
Hz Key Chain Transmitters 2 and 4 channels
Read all instructions carefully before use.
Hz Key Chain Trans
®
Programming Instructions
REPLACING THE BATTERY
LOCKING/UNLOCKING TSA 4
A - Enabling the locking function - Once a locking code has been entered the TSA 4 will automatically lock the buttons after 2
minutes without a command to prevent unintended operation. The buttons can be unlocked as per section B.
1) Press the lock button
for 5 seconds
2) Enter a 4 key code 3) Validate the code by
pressing the lock button
4) Enter the same 4
key code again
5) Validate the code by
pressing the lock button
ATTENTION - The battery must be installed correctly with regards to the polarity. The battery must be installed with the + side facing away from the
transmitter board. Do not expose battery to high temperatures or water. Do not throw batteries in fire or water. Dispose of batteries correctly
B - Unlocking the remote - After unlocking the remote, the buttons will remain active for 2 minutes before locking again.
1) Enter your 4 key
code
2) Validate the code by
pressing the lock button
3) The transmitter buttons are unlocked for normal use for 2 minutes.
After 2 minutes the transmitter will automatically lock the buttons again
C - Disable the automatic lock function
1) Press the lock button
for 5 seconds
2) After 5 seconds the locking
LED will go out. The locking
Function is now disabled.
This manual suits for next models
1
Table of contents
Other Simu Transmitter manuals
Simu
Simu COLOR Hz User manual
Simu
Simu HZ WALL 1 CHANNEL User manual
Simu
Simu HZ MOBILE 1 CANAL User manual
Simu
Simu Hz COLOR MULTI User manual
Simu
Simu 2006020 User manual
Simu
Simu TIMER EASY User manual
Simu
Simu LiveIn2 User manual
Simu
Simu 2008806 User manual
Simu
Simu TIMER EASY User manual
Simu
Simu 5C User manual
Popular Transmitter manuals by other brands
Dejero
Dejero EnGo 3x manual
Rosemount
Rosemount 4600 Reference manual
Speaka Professional
Speaka Professional 2342740 operating instructions
trubomat
trubomat GAB 1000 instruction manual
Teledyne Analytical Instruments
Teledyne Analytical Instruments LXT-380 instructions
Rondish
Rondish UT-11 quick start guide
