Simrad NSO evo3 User manual
ENGLISH
NSO evo3
Installation Manual
www.simrad-yachting.com
Preface
Disclaimer
As Navico is continuously improving this product, we retain the right to make changes to the
product at any time which may not be reflected in this version of the manual. Please contact
your nearest distributor if you require any further assistance.
It is the owner’s sole responsibility to install and use the equipment in a manner that will not
cause accidents, personal injury or property damage. The user of this product is solely
responsible for observing maritime safety practices.
NAVICO HOLDING AS AND ITS SUBSIDIARIES, BRANCHES AND AFFILIATES DISCLAIM ALL
LIABILITY FOR ANY USE OF THIS PRODUCT IN A WAY THAT MAY CAUSE ACCIDENTS, DAMAGE
OR THAT MAY VIOLATE THE LAW.
This manual represents the product as at the time of printing. Navico Holding AS and its
subsidiaries, branches and affiliates reserve the right to make changes to specifications
without notice.
Governing language
This statement, any instruction manuals, user guides and other information relating to the
product (Documentation) may be translated to, or has been translated from, another
language (Translation). In the event of any conflict between any Translation of the
Documentation, the English language version of the Documentation will be the official
version of the Documentation.
Copyright
Copyright © 2018 Navico Holding AS.
Warranty
The warranty card is supplied as a separate document. In case of any queries, refer to the
brand website of your unit or system: www.simrad-yachting.com.
Compliance Statement
This equipment complies with:
•CE under 2014/53/EU Directive
•The requirements of level 2 devices of the Radio communications (Electromagnetic
Compatibility) standard 2008
•Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
The relevant Declaration of conformity is available in the product's section at the following
website: www.simrad-yachting.com.
Industry Canada
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil
ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
Warning
The user is cautioned that any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Preface | NSO-evo3 Installation Manual 3
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that the interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna
•Increase the separation between the equipment and receiver
•Connect the equipment into an outlet on a circuit different from that of the receiver
•Consult the dealer or an experienced technician for help
Countries of intended use in the EU
AT - Austria
BE - Belgium
BG - Bulgaria
CY - Cyprus
CZ - Czech Republic
DK - Denmark
EE - Estonia
FI - Finland
FR - France
DE - Germany
GR - Greece
HU - Hungary
IS - Iceland
IE - Ireland
IT - Italy
LV - Latvia
LI - Liechtenstein
LT - Lithuania
LU - Luxembourg
MT - Malta
NL - Netherlands
NO - Norway
PL - Poland
PT - Portugal
RO - Romania
SK - Slovak Republic
SI - Slovenia
ES - Spain
SE - Sweden
CH - Switzerland
TR - Turkey
UK - United Kingdom
Internet usage
Some features in this product use an internet connection to perform data downloads and
uploads. Internet usage via a connected mobile/cell phone internet connection or a pay-per-
MB type internet connection may require large data usage. Your service provider may charge
you based on the amount of data you transfer. If you are unsure, contact your service
provider to confirm rates and restrictions.
4Preface | NSO-evo3 Installation Manual
Trademarks
Navico®is a registered trademark of Navico.
Simrad®is used by license from Kongsberg.
FLIR® is a registered trademark of FLIR.
HDMI®and HDMI™, the HDMI Logo, and High-Definition Multimedia Interface are trademarks
or registered trademarks of HDMI Licensing LLC in the United States and other countries.
Mercury®is a registered trademark of Mercury.
NMEA®and NMEA 2000®are registered trademarks of the National Marine Electronics
Association.
SD™and microSD™are trademarks or registered trademarks of SD-3C, LLC in the United
States, other countries or both.
SmartCraft VesselView®is a registered trademark of Mercury.
Suzuki®is a registered trademark of Suzuki.
Wi-Fi®is a registered trademark of the Wi-Fi Alliance®.
Yamaha®is a registered trademark of Yamaha.
Navico product references
This manual refers to the following Navico products:
•Broadband Radar™ (Broadband Radar)
•Broadband Sounder™ (Broadband Sounder)
•DownScan Overlay™ (Overlay)
•GoFree™ (GoFree)
•Halo™ Pulse Compression Radar (Halo Radar)
•StructureScan® (StructureScan)
About this manual
This manual is a reference guide for installing units.
Some features may not be activated or available for screenshots in the manual. As a result,
screenshots of menus and dialogs may not match the look of your unit.
Important text that requires special attention from the reader is emphasized as follows:
ÚNote: Used to draw the reader’s attention to a comment or some important information.
Warning: Used when it is necessary to warn personnel that they should
proceed carefully to prevent risk of injury and/or damage to equipment/
personnel.
Preface | NSO-evo3 Installation Manual 5
Contents
7 Introduction
7Parts included
8 Front controls
8 Connectors
9 Card reader
10 Installation
10 Installation guidelines
10 Bezel fitment and removal
11 Cable retainer installation
11 Panel mounting
11 Bracket mounting
12 Wiring
12 Wiring guidelines
12 Power connector details
15 USB connector details
15 NMEA 0183 connector details
16 NMEA 2000 connector details
17 J1939 connector details
18 Ethernet connector details
18 Video in connector details
19 HDMI connector details
20 Software setup
20 First time startup
20 Software setup sequence
20 Accessing the settings dialog
20 System settings
21 Alarms settings
21 Radar settings
24 Echosounder settings
27 Autopilot settings
27 Fuel settings
29 Wireless settings
31 Network settings
36 3rd party support
36 C-Zone
37 Mercury
37 Suzuki Marine
37 Yamaha engine integration
38 Appendix
38 Accessories
39 Supported data
43 Technical specifications
45 Dimensional drawings
6Contents | NSO-evo3 Installation Manual
Introduction
Parts included
AC
D
H
I
J
B
ENGLISH
Installation Manual
bandg.com
ENGLISH
Installation Manual
bandg.com
ENGLISH
Installation Manual
bandg.com
ENGLISH
Installation Manual
bandg.com
F
G
E
A Display unit
B Suncover
C Bezels
•1 set black bezels
•1 set silver bezels
D Power cable, fuse, fuse holder and connector block
E RJ45 to 5-pin Ethernet adapter cable
F NMEA 0183 connector block
G Documentation pack
H Cable retainer kit
I NMEA 2000 starter kit
J Panel mounting kit
1
Introduction | NSO-evo3 Installation Manual 7
Front controls
B C
A
A Touch screen
B Power key
•Press and hold: turns the unit ON/OFF
•Short press once: displays the System Controls dialog
•Repeat short presses: toggles through preset dimming levels
C WheelKey - user configurable key, refer to "ConfigureWheelKey" on page 20.
Default without an autopilot connected to the system
•Short press: toggles between panels on split screen
•Long press: maximizes active panel on split screen
Default with an autopilot connected to the system
•Short press: opens the autopilot controller and puts the autopilot in standby
mode
•Long press: toggles between panels on split screen
Connectors
A B C
C
D
DD
E F G
G
HJI
A NMEA 2000 - NMEA 2000 data
B J1939 - J1939 engine data
C USB - mouse, keyboard or mass storage
D NETWORK 1-3 - Ethernet network
E SD - microSD card reader
F HDMI OUT - HDMI video output
G VIDEO IN - composite video input
H HDMI IN - HDMI video input
I NMEA 0183 - NMEA 0183 data
J POWER - 12 - 24 V DC input, external alarm and power control
8Introduction | NSO-evo3 Installation Manual
Card reader
A memory card can be used for detailed chart data, software updates, transfer of user data,
and system backup.
ÚNote: Do not download, transfer or copy files to a chart card. Doing so can damage chart
information on the chart card.
If the card reader has a protective door it should always be securely shut immediately after
inserting or removing a card, in order to prevent possible water ingress.
Introduction | NSO-evo3 Installation Manual 9
Installation
Installation guidelines
Choose the mounting location carefully, make sure that there are no hidden electrical wires
or other parts behind the panel before you drill or cut. Ensure that any holes cut are in a safe
position and will not weaken the boat’s structure. If in doubt, consult a qualified boat builder,
or marine electronics installer.
Don´t:
•Mount any part where it can be used as a hand hold
•Mount any part where it might be submerged
•Mount any part where it will interfere with the operation, launching, or retrieving of the
boat
Do this:
•Test the unit in its intended location to ensure satisfactory wireless performance. Metal
and carbon materials are known to impact the performance in a negative way. A well
placed external wireless module can be added to overcome poor performance
•Consider the optimum viewing angles
•Consider the overall width and height requirements
•Consider access to the card reader
•Leave sufficient clearance to connect all relevant cables
•Check that it is possible to route cables to the intended mounting location
ÚNote: Where flush mounted, the enclosure should be dry and well ventilated. In small
enclosures, it may be required to fit forced cooling.
Warning: Inadequate ventilation and subsequent overheating of the unit
may cause unreliable operation and reduced service life. Exposing the unit
to conditions that exceeds the specifications could invalidate your warranty.
Refer to the technical specifications in the "Appendix" on page 38.
Bezel fitment and removal
ÚNote: The unit in the illustration is an example only.
2
10 Installation | NSO-evo3 Installation Manual
Other manuals for NSO evo3
2
Table of contents
Other Simrad Monitor manuals
Simrad
Simrad MO16-T User manual
Simrad
Simrad MO Series User manual
Simrad
Simrad M5000 Series User manual
Simrad
Simrad NSO evo3 User manual
Simrad
Simrad NSS evo2 User manual
Simrad
Simrad NSS evo3 User manual
Simrad
Simrad IS42J User manual
Simrad
Simrad NSO evo2 User manual
Simrad
Simrad M5000 Series User manual
Simrad
Simrad NSE8 User manual
Simrad
Simrad NSO evo3 User manual
Simrad
Simrad NSO19 evo3s User manual
Simrad
Simrad IS35 User manual
Simrad
Simrad IS20 Combi User manual
Simrad
Simrad NSE8 User manual
Simrad
Simrad NSE8 User manual
Simrad
Simrad NSE8 User manual
Simrad
Simrad NSX User manual
Simrad
Simrad NSO evo3S User manual
Simrad
Simrad is42 User manual
