1. General remarks and safety instructions
Note for StVo or use on public roads
The sIMPLEk Pro Tunin module, obstructed in a compatible E-Bike, causes the suspension of the
factory-inte rated speed re ardin the support of the motor.
Thus, the use of the sIMPLEk Pro Tunin module, within the scope of the StVO or on public roads, is
forbidden and not accepted.
The use of the sIMPLEk Pro Tunin module is only provided for closed-off public traffics as well as for
private rounds and race courses.
The sIMPLEk-Stick Pro is compatible with the followin E-Bike en ines:
•Bosch (Classic Line, Active Line (Plus), Performance Line, Performance Line (CX))
•Yamaha (PW, PW-SE, PW-X, GIANT SyncDrive)
•Brose
Please note that the technical characteristics of your e-bike may not be desi ned for the use of tunin
measures without further technical adjustments. The use leads to the warranty loss of the e-bike. If the
e-bike concerned has an operatin license, it will be extin uished.
Please put on a suitable helmet at all times!
The usa e of the assembly set leads to the loss of warranty concernin the vehicle.
Re ardin the installation of the E-Bike, please make sure not to dama e any cables while installin the
protection cover of the motor. Thus, you can prevent electrical shorts which could lead to major cable
bruises or fires.
Liabilities for any dama es will not be assumed (directly or indirectly) that may arise by activatin the
completed assembly set.
Use at your own risk!
2. Installation
Before you start with the installation, remove the battery of your E-bikes!
The connection cable is upstreamed in front of the ori inal sensor. For this purpose the motor cover has
to be removed. Dependin on the en ine version you need additional tools.
