
Maintenance and Cleaning
8
It is very important careful and regular maintenance of the device into perform
accordance with the recommendations made in this manual so that it can run
efficiently for a long time.
- The cleanliness of the reflector (reflecting mirror) and quartz glass tubes must
be checked at least once a month by the user. The cleaning and maintenance
instruction must be applied if dirty.
- According to the amount of dust in the place of use, the said checks should be
performed more often.
- Power cable and plug must be checked while cleaning the device. If there is a
deformation in the power cord or the plug, it must be taken to the authorized
service.
- Reflector, wire and body deformation must be visually inspected while
cleaning the device. If there is a deformation, authorized service must be called
for things to do.
- It is recommended that the reflector is changed every two years for the device
to run more efficiently. Reflector must be changed by the authorized service.
A clean reflector ensures the maximum level of heating efficiency.
Cleaning
Attention! Regular and careful cleaning performed by the user will ensure that
your device will run more efficiently and prolong its life.
- Your device must be turned off before starting to clean, its power cord must be
unplugged from the socket for safety and wait until it cools down.you must
- If the reflector (reflecting mirror) and quartz glass tube is dirty, it must be
cleaned from the outside with dry air without opening the protective cage wire of
the device, if possible.
- The outer surface of the device must be cleaned with a soft cotton cloth or a
soft brush.
- Never use corrosive or melting liquids to clean the heater. These materials
may damage the plastic parts.
- Do not clean your device using vapor cleaners.
Please check the points below before calling the technical service about the
problems you might encounter with your device.
Problems:
Device does not run.
Solutions:
Check whether the plug is plugged into the socket correctly.
Ensure the device is in vertical position. (Your device has balance safety.)
Ensure that the running switch and the thermostat of the device are in
-correct, open position.
Check whether there is a problem in the house's electrical installation.
Ensure you follow the using instructions.
If the problem persists, contact the nearest simfer authorized service.
Troubleshooting