3. Installation
3.3 Connect to power adapter
The router works on DC 12 volt power. The default included power adapter
is AC to DC 12V power adapter. Connect the power adapter on the electric
outlet and plug in the DC jack into the power socket on the router.
The router will turn on automatically.
Except for the original power adapter, the router can also work on 12Volt
power sources including car power adapter. And with the “5V to 12V power
converter” you can power up the modem with regular 5V power bank.
Car adapter and converter are not included. AC to DC 12V adapter
3.4 WAN & LAN ports
The industrial 4G router has built-in 1xWAN and 4xLAN port for connect to a computer or router via RJ45 LAN cable.
4. Configuration
4.1 Connect to the router
4.1.1 Wi-Fi / LAN connection
After connected to the electrical outlet, two 2.4G Wi-Fi hotspot “ezenos-xxxx” and 5.8G Wi-Fi hotspot “ezenos-xxxx-5G” will be
created. The default Wi-Fi settings are without encryption.
Connect to one of the hotspots on a computer, laptop or smartphone. You can also connect to the router with RJ45 LAN cable.
4.1.2 TCP/IP setting
Configure TCP/IP on your connected devices, make sure turn on DHCP or use router address (gateway) 192.168.44.1 and subnet
mask 255.255.255.0.
On iPhone: Goes to Settings / Wi-Fi / Advanced
On Android phone: Goes to Settings / WLAN / Advanced
On Mac: Goes to System preferences / Network / Wi-Fi / Advanced / TCP/IP
On Windows:
Goes to Start / Control panel / Network and internet / Change adapter
setting (on left window panel) / Local area connection /
Properties (right click) / TCP/IPv4 (Internet protocol version 4) /
Properties / General
Choose “Obtain an IP address automatically” and “Obtain DNS server
address automatically”
Click “OK” to exit setting. Click “OK” again in the “Local area connection
properties” to apply the new configuration.
