Shure SM35 User manual
SM35
Performance Headset Condenser Microphone
The Shure headworn electret condenser microphone, SM35, user guide.
Version: 2 (2019-L)
Shure Incorporated
3/6
1.
2.
3.
SM35
Performance Headset Condenser Microphone
SM35 Headworn Microphone
The Shure SM35 is a headworn electret condenser microphone, intended for use with a wireless bodypack transmitter in live
stage performances.
Wearing the Microphone
Install the windscreen on the microphone boom.
Place the headband around the back of the head, with the boom on the left side.
Place the microphone at the corner of the mouth. To decrease pops and plosives, avoid placing the microphone directly
in front of the mouth
Shure Incorporated
4/6
Note: Do not store the microphone in damp, enclosed spaces. Allow perspiration to dry completely before storing.
Certifications
Note: Testing is based on the use of supplied and recommended cable types. The use of other than shielded (screened) cable types may degrade EMC per
formance.
The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Fax: +49-7262-92 49 11 4
Specifications
Type
Electret Condenser
Frequency Response
40Hz to 20,000Hz
Polar Pattern
Unidirectional (Cardioid)
Output Impedance
100Ω, @ 1 kHz
Sensitivity
-57.8dBV/Pa, @ 1 kHz, 1000Ωload
Signal-To-Noise Ratio
59.2dB, @ 1 kHz, 1000Ωload
Maximum SPL
151.3dB, 1000Ωload, @ 1 kHz, 1% THD
[1]
[1]
Shure Incorporated
5/6
Dynamic Range
116.5dB, @ 1 kHz, 1000Ωload
Self Noise
34.8dBSPL-A, 1000Ωload
Power Requirements
TA4F +5VDC (nominal), 10V maximum (DC bias)
XLR connector 12 to 52VDC, phantom power
Polarity
TA4F Positivepressureondiaphragmproducesposi-
tive voltage on pin 3 with respect to pin 1
XLR Positivepressureondiaphragmproducesposi-
tive voltage on pin 2 with respect to pin 3
Cable
1.1m (45in.)
Connector
TA4F or XLR
Weight
72g (2.53oz.)
Measurements taken using RPM400 preamp
*All specifications measured with a 48 Vdc phantom power supply. The microphone operates at lower voltages, but with slightly
decreased headroom and sensitivity.
[1]
[1]
[1]
Shure Incorporated
6/6
Table of contents
Other Shure Microphone manuals
Shure
Shure PGA181 PG Alta series User manual
Shure
Shure MV88/A User manual
Shure
Shure Centraverse Series User manual
Shure
Shure WL93 User manual
Shure
Shure Microflex Advance MXA910 User manual
Shure
Shure PG27-USB Installation guide
Shure
Shure 522 User manual
Shure
Shure MXA920 User manual
Shure
Shure 522 User manual
Shure
Shure KSM8 Dualdyne User manual
Shure
Shure MXA310B User manual
Shure
Shure Spher-O-Dyne 533AV User manual
Shure
Shure A910-HCM User manual
Shure
Shure WH30TQG User manual
Shure
Shure PG27-USB Installation instructions
Shure
Shure PG27-USB User manual
Shure
Shure PGA 98H User manual
Shure
Shure BG 4.1 User manual
Shure
Shure WH20 User manual
Shure
Shure Microflex MX400SE Series User manual
