Shure SM35 User manual

Table of contents

Popular Microphone manuals by other brands

IK Multimedia

IK Multimedia iRig Stream MIC PRO user manual

DAPAudio

DAPAudio RM-101 user manual

AKG

AKG CHM 21 User instructions

Sennheiser

Sennheiser evolution wireless series EM 100 instruction manual

Sony

Sony C-48 operating instructions

GIGAMEDIA

GIGAMEDIA GGM PAMICUHFG user manual

auna PRO

auna PRO MIC-900 manual

AKG

AKG D 3800 User instructions

MAIIN SOUND

MAIIN SOUND IIN style instruction manual

Earthworks

Earthworks TC25 user manual

Sennheiser

Sennheiser evolution D1 user manual

Alesis

Alesis MicLink Wireless user guide

DSPPA

DSPPA D6234 manual

Monacor

Monacor IMG STAGELINE ECM-300B manual

Ansr Audio

Ansr Audio Scan16 user manual

JLab

JLab GO TALK manual

Renkforce

Renkforce TY-109 operating instructions

Trust

Trust 31008 Quick installation guide

SM35Performance Headset Condenser Microphone

SM35 Headworn Microphone

The Shure SM35 is a headworn electret condenser microphone, intended for use with a

wireless bodypack transmitter in live stage performances.

Wearing the Microphone

1. Install the windscreen on the microphone boom.

2. Place the headband around the back of the head, with the boom on the left side.

3. Place the microphone at the corner of the mouth. To decrease pops and plosives, avoid

placing the microphone directly in front of the mouth

Note: Do not store the microphone in damp, enclosed spaces. Allow perspiration to dry

completely before storing.

Specifications

Type

Electret Condenser

Frequency Response

40 Hz to 20,000 Hz

Polar Pattern

Unidirectional (Cardioid)

Output Impedance

@ 1 kHz

2400 Ω

Audio Output Level

-59.0 dBV/Pa

Signal-To-Noise Ratio [1]

@ 1 kHz

55 dB

Maximum SPL [1]

1000 Ω load, 1 kHz@ 1%THD

153.0 dB

Dynamic Range [1]

@ 1 kHz, 1000 Ω load

114.0 dB

Equivalent Output Noise [1]

typical, A-Weighted

39 dB

Power Requirements

Connector Type

TA4F XLR connector

+5

V

DC (nominal), 10

V maximum (DC bias)

12 to 52

V

DC, phantom power

Polarity

Positive pressure on diaphragm produces positive voltage on pin 3 with respect to pin 1

Cable

1.1 m (45 in.)

Connector

TA4F or XLR

Net Weight

72 g (2.53 oz.)

[1] Measurements taken using RPM626 preamp

*All specifications measured with a 48 Vdc phantom power supply. The microphone

operates at lower voltages, but with slightly decreased headroom and sensitivity.

Certifications

Note: Testing is based on the use of supplied and recommended cable types. The use of

other than shielded (screened) cable types may degrade EMC performance.

The CE Declaration of Conformity can be obtained

from: www.shure.com/europe/compliance

Authorized European representative:

Shure Europe GmbH

Headquarters Europe, Middle East & Africa

Department: EMEA Approval

Jakob-Dieffenbacher-Str. 12

75031 Eppingen, Germany

Phone: 49-7262-92 49 0

Fax: 49-7262-92 49 11 4

Email: [email protected]