Shinco SDZ1-70P/P User manual
Attention:
To prevent any internal damage, it is very important to
keep refrigeration units (like this one) upright throughout
their journey. Please leave it standing upright and outside
the box for 24 HOURS before plugging it in.
Your dehumidifier comes with two types of water pipes.1.one is a thin pipe with an inner diameter of 5 mm and a
length of 2 meters.
(This pipe is suitable for the drainage function of the pump)
2.One is a thick tube with an inner diameter of 9mm and a
length of 1 meter.
(This pipe is suitable for gravity drainage)
Thank you very much for choosing our SHINCO
dehumidifier to take care of you and your family!
Content
1
Important Notice...............................................02
Important Safety Instructions..........................03
Location & How it works ..................................05
Product Overview..............................................06
Operation Instruction........................................07
Removing Collected Water................................09
Care and Cleaning & Storage.............................11
Troubleshooting................................................12
Technical Data...................................................13
Warranty...........................................................14
Thank you a lot for choosing Shinco's dehumidifier, let it be a member of
your family to protect the health of the whole family.
Please read the manual carefully before you use the dehumidifier, it will
help you operate the machine better, so as to achieve the best effect and
extend the life of the machine.
IMPORTANT NOTICE BEFORE FIRST USE:
•To prevent any internal damage, it is very important to keep refrigeration units (like
this one) upright throughout their journey. Please leave it standing upright and outside
the box for 24 HOURS before plugging it in.
•Please check if there is any damage around the machine, if the machine is damaged.
Please contact customer service immediately.
IMPORTANT NOTICE FOR FIRST TIME USE:
•When you open the machine,the machine will turn on in automatic mode, and the
default dehumidification is 50% which means when the room humidity drops to 50%,
the machine will automatically shut down.
•The dehumidifiers are lightweight and easy to move. They are designed to extract
unwanted humidity while saving money due to their power saving logic. They feature
an intelligent humidistat where the desired relative humidity can be adjusted in
increments of 5% between 30% and 80% ensuring your room is not dried too much
and power is not wasted.
•The "Compressor" circuit has an automatic 3 minutes time delayed start if the unit is
turned off and on quickly. This prevents overheating of the compressor and possible
circuit breaker tripping. Make sure the tank is fitted correctly otherwise unit will not
turn on.
•When the unit is started, the fan begins to pull moisture-laden air across the
dehumidifying coils. The coils condense or draw moisture from the air, and air flows
through the top louvers into the room as dry, warm air. Moisture removed from air is
collected in a bucket on the rear of the dehumidifier. Therefore, it is normal for the
dehumidifier to discharge hot air.IMPORTANT NOTICE
2
•Carefully read the instructions before operating the unit.
•This appliance is for indoor use only and intended for use in a domestic environment only.
Any other use is not recommended by the manufacturer and may cause fire, electrical shocks
or other injury to user or property.
•If you are in any doubt about the suitability of your electrical supply, have it checked and if
necessary, modified by a qualified electrician.
•This dehumidifier has been tested and is safe to use. However, as with any electrical
appliance,use it with care.
•Disconnect the power before dismantling, assembling or cleaning.
•Avoid touching any moving parts within the appliance.
•Never insert fingers, pencils or any other objects though the guard.
•This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities. It is also not intended for use by those with a lack of
experience and knowledge, unless they have been given supervision or instruction,
concerning the use of the appliance by a person responsible for their safety.
•Do not leave children unsupervised with this appliance.
•Do not clean the unit by spraying it or immersing it in water.
•Never connect the unit to an electrical outlet using an extension cord. If a power outlet is not
available, one should be installed by a qualified electrician.
•Never operate this appliance if the cord, power adapter or plug is damaged. Ensure the
power cord is not stretched or exposed to sharp objects/edges.
•A damaged power supply cord should be replaced by the manufacturer or a qualified
electrician in order to avoid a hazard.
•Any service other than regular cleaning or filter replacement should be performed by an
authorised service representative. Failure to comply could result in a voided warranty.
•Do not use the appliance for any purpose other than its intended use.
•Do not tilt the unit while in use. The unit is design to work only in vertical position.
•This dehumidifier must always be stored and transported upright, otherwise irreparable
damage may be caused to the compressor; if in doubt we suggest waiting at least 24 hours
before starting the unit.
•Avoid restarting the dehumidifier unless 5 minutes have passed since being turned off. This
prevents damage to the compressor.
•Never use the plug as a switch to start or turn off the dehumidifier. Use the provided POWER
button located on the control panel.
•Always place the unit on a dry and stable surface.
•Do not dry laundry above the unit to prevent water entering the dehumidifier. Place the
laundry at least 1 meter away from your dehumidifier.
Important Safety Instructions
Warning
3
•Before moving the appliance,the water tank should be emptied.
•The handle on the appliance is designed to aid in its movement and should not be used to
support the full weight of the dehumidifier. When carrying the unit, it should be kept upright
and sufficiently supported from its base.
•The appliance must be placed in a room without sources of ignition (for example: open
flames, an operating gas appliance or an operating electric heater).
•Do not use or store the appliance in an unventilated space with an area smaller than 43 sq.ft
(4m2 )per unit.
•If the appliance is installed, used or stored in an unventilated room, the room must be such
as to prevent stagnation of possible leaks of refrigerant gas as there could be a danger of fire
or explosion once the refrigerant comes into contact with electric heaters, stoves or other
sources of ignition.
•Do not use the product and contact the retailer for advice, if damage has occurred to the unit
which may have compromised the refrigerant system.
•Any repairs or maintenance must only be carried out on the unit by a suitably qualified
engineer.Before opening and servicing the unit,the authorized engineer must be in
possession of a copy of the manufacturer’s service manual and must follow the safety
information contained within it to ensure all hazards are minimized.
•The refrigerant system should not be perforated or punctured.
•Do not place the unit next to heat sources (e.g. electrical fires, fireplaces, etc.)
•Avoid mishandling the dehumidifier. Dropping, throwing the unit can cause damage to its
internals and increases the risks of operating it.
•Do not store or use gasoline, petrol, paint, solvents or other flammable vapours or liquids in
the vicinity of this dehumidifier or any other appliance.
•This dehumidifier must not be used in spaces where there is a high concentration of gases,
solvent or other volatile organic compounds; in very dusty environments; in any domestic,
commercial or industrial environment where the air composition is flammable.
ELECTRICAL INFORMATION
•Be sure the dehumidifier is properly grounded. To minimize shock
and fire hazards, proper grounding is important. This power cord is
equipped with a three-prong grounding plug for protection against
shock hazards.
•Your dehumidifier must be used in a properly grounded wall
socket. If your wall socket is not adequately grounded or
protected by a time delay
fuse or circuit breaker, have a qualified electrician install the
proper socket.
•Avoid fire hazard or electric shock. Do not use an extension cord
or an adapter plug. Do not remove any prong from the/power
cord.
4
Location & How it works
•A badly positioned dehumidifier will have little
effect. In positioning the dehumidifier,please
ensure circulation of air is not restricted around
the unit. Maintain a minimum clearance of 20 cm
(8 in) on the sides and back of the dehumidifier
and 50cm (19.7 in) on the top of the dehumidifier
to allow for proper air circulation.
•The recommended ambient operating
temperature is between 5°C (41°F) and 35°C (95°
F).The unit will not work properly if the
temperature is out of this temperature range, or
the performance of the unit will fall greatly.
•TO REDUCE NOISE LEVELS:
Place a piece of carpet or a rubber mat under the unit to reduce any vibrations while the unit
is running. Our dehumidifier uses compressor technology to extract water from the
environment.
Location
How it works
How does the dehumidifier work?
It helps to think of your dehumidifier like a vacuum
cleaner: it sucks in air from your room, removes the
moisture, and then blows the air back into the room
again.
First, humid air is pulled into the Shinco dehumidifier
through the grill on the back of the unit. The warm,
moist air is pulled across freezing-cold pipes where
water from the moist air collects (kind of like water
gathering on a glass of iced tea during a hot summer
day.) As the water collects on the pipes, it drips down
into the drain bucket for later removal. While the water
is collecting in the drain bucket, the now moisture-free
air is reheated so it can be blown out the top of the
unit and back into the room.
5
Product Overview
6
Operation Instruction
1. Plug the power cord into a properly grounded 115 volt AC outlet.
2. To turn the unit on, press the ON/OFF button. The unit will run
in the factory setting of AUTO mode and low fan speed. And the default
dehumidification is 50%.And the unit will display the RH,if the room humidity
drops to 50%, the machine will automatically shut down.
3. Press to switch between automatic mode(when it reaches the humidity
you set, the unit will stop working)and continuous mode （ it will always
dehumidify without stopping）.When unit is in operation,you can press
for 3 seconds to lock all the buttons on the control panel in case children will
play on it. Re-press it for3s, you can cancel the function.
4.If you switch to the auto mode,you have to set your ideal humidity by
pressing the .The humidity level can be set within a range of 30% RH
(Relative Humidity) to 80% RH (Relative Humidity) in 5%increments. If you
switch to continuous mode,regardless of the relative humidity in the room,
the compressor starts, the fan runs at high speed by default, and the wind
speed can be adjusted.
Attention:Press this button for 3s to start or shut the Pump function.(Please connect
continuous pipe with an inner diameter of 5mmbefore starting pump function.)
7
5.You can also press to change the fan speed to HIGH or LOW. The
indicator light will show the setting you have selected. A higher fan speed will
result in quicker moisture removal.
6.Then to run the dehumidifier for a preset amount of hours, press ."0"
blinks on the display. Set the time you wish the appliance to operate between
1 and 24 hours. And you can set time to turn on this machine by pressing this
button in standby.
8.Before storing the unit , pls dry inside of the dehumidifier by
pressing .This will prevent mold from forming during storage.
Auto Shut Off
When the bucket is full and/or the humidity setting is reached, the
dehumidifier will be shut off automatically.
Wait 3 minutes before resuming operation
To avoid any damage to the dehumidifier, the dehumidifier will not start
operation following a complete cycle until after three (3) minutes. Operation
will automatically start after three (3) minutes.
Auto Defrost
When frost builds up on the evaporator coils, the compressor will cycle off
and the fan will continue to run until the frost disappears.
Auto-Restart
If the dehumidifier shuts off unexpectedly due to power being cut, the
dehumidifier will restart with the previous function setting automatically
when the power resumes.
Note: SMART FUNCTIONS
7.If "Water full" lights up and the display shows "FL", the water tank needs
to be emptied (see "Removing Collected Water") ．After reinstalling the
emptied water tank, the dehumidifier restarts automatically after three
mins.
8
Table of contents
Other Shinco Dehumidifier manuals
