AFTER SALES SUPPORT
Phone: 0508 776 546 - Mon-Fri 8:30am –4.30pm Page 9
Using Your Dehumidifier
1. The Power indication light will turn green when the unit is plugged in, regardless
of whether the unit is operating or not.
2. Press button once to start operation. Press it again to stop operation.
3. Press button as follows: Press to set the desired fan speed. It can be adjusted
between high speed and low speed.
4. Press button to set the desired humidity level in the room, which can be set
from 40% to 80% at 5% intervals.
a. After a period of operation, when environment humidity is lower than the
selected humidity by 2%, the compressor will stop and the fan will stop
working 3 minutes later.
b. When environment humidity is equal to or higher than the selected
humidity by 2%, the compressor will restart once the 3-minute
compressor protection time is over.
5. Press button for delayed start or stop setting.
a. When the Dehumidifier is turned on, press the timer button to program
the time when the unit turns off. Each press of the button will change the
timer by 1 hour. The unit will automatically switch off after the pre-
selected time.
b. If you want to cancel the timer programming, press the timer button to
adjust the time at 00.
c. When the dehumidifier is turned off, press the timer button to set the
time you wish the unit to turn on. Each press of the button will change
the timer by 1 hour. The unit will automatically switch on after the pre-
selected time.
d. If you want to cancel the timer programming, press the timer button to
adjust the time to 00.
e. The programmed time remains unchanged if the machine stops working
due to water full or during defrost mode.
Draining the Collected Water
When the drainage tank is full, the tank full indicator light will turn on, the operation
will stop automatically and the buzzer will beep 15 times to alert the user that the
water needs to be emptied from the drainage tank.
