Sharp EC-S5170 User manual
1
OPERATION MANUAL
VACUUM CLEANER
EC-S5170
EC-T5180
EC-T5180A
EC-T5180B
MODELS
• IMPORTANT SAFETY INSTRUCTIONS .... 2
• PARTS IDENTIFICATION ........................... 4
• SPECIFICATIONS........................................ 4
• OPERATING INSTRUCTIONS ................... 6
• MAINTENANCE INSTRUCTIONS .............. 10
• REPLACEMENT INSTRUCTIONS .............15
• BEFORE REQUESTING SERVICE ...........18
• DESCRIPTION OF ACCESSORIES .......... 19
• CONSUMER LIMITED WARRANTY ..........20
• SPANISH DIGEST .......................................21
CONTENTS PAGE
Thank you very much for buying SHARP
Before using your SHARP vacuum cleaner, please
read this operation manual carefully to obtain the
optimum performance from your vacuum cleaner.
S5170/t5180(Layout) 2001.12.20, 8:07 AM1
2
WARNING /
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical vacuum cleaner, basic precautions should always be followed
including the following:
Read all instructions carefully before using this vacuum cleaner.
To reduce the risk of fire, electric shock, or injury:
10
11
12
1
2
3
4
5
6
7
8
9
Do not use outdoors or on wet surfaces.
Do not leave vacuum cleaner unattended when plugged in. Unplug from outlet
when not in use and before user-servicing.
Close supervision is necessary when used by or near children.
Do not allow this vacuum to be used as a toy.
Use only as described in this manual. Use only manufacturers recommended
attachments.
Never operate this vacuum cleaner if it has a damaged cord or plug, if it is not
working properly, if it has been dropped, damaged, exposed to weather or
dropped into water.
Return the vacuum cleaner to a Sharp Authorized Servicer in the United States
for examination and repair.
Do not pull or carry this vacuum cleaner by the power cord. Do not use the power
cord as a handle, close a door on the cord, or pull the cord around sharp edges
or corners. Keep cord away from heated surfaces.
Do not run the vacuum over the cord. Running over the cord may damage the
insulation resulting in an electrical short. If the insulation is damaged, immedi-
ately remove the plug from the electrical outlet and bring the vacuum to a Sharp
Authorized Servicer.
Never disconnect the plug by pulling on the cord. To disconnect from an outlet,
grasp the plug, not the cord.
Never operate this vacuum cleaner with any air opening blocked. Keep the air
openings free of dust, lint, hair and any other similar material.
Never drop or insert any object into any opening.
Keep hair, face, fingers and loose clothing away from all openings, the agitator
and any moving parts.
Do not use this vacuum cleaner to pick up the following objects:
a. flammable objects: lit cigarettes, hot ashes, lit matches, toner or similar
materials.
b. sharp objects: razor blades, broken glass, needles, pins, nails or similar
materials.
c. very fine dust: plaster, cement, cooking flour, etc.
S5170/t5180(Layout) 2001.12.20, 8:07 AM2
3
SAVE THESE INSTRUCTIONS
This vacuum cleaner is intended for household use only.
To reduce the risk of electric shock, this vacuum cleaner
has a polarized plug (one blade is wider than the other). This
plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to install the
proper outlet. Do not change the plug in any way.
13
Never operate this vacuum cleaner without the dirt compartment and filters in place.
Empty the dirt compartment before reaching the “Max Fill Line” and clean the filters
often.
Before removing the plug from the outlet, turn all controls to the “OFF” position.
Use extra caution when cleaning on stairs.
Never handle plug, cord or vacuum cleaner with wet hands.
Never touch the underside of the vacuum cleaner when it is plugged in. The rotating
agitator may cause injury.
Do not use in presence of flammable or combustible liquids or fumes.
Do not place heavy objects on the vacuum cleaner.
Do not step on the hose or pull the hose forcibly.
Do not pick up objects such as waste paper, plastic sheets, tissue paper or
wrappings which may clog the hose and filters. Do not pick up a large amount of
dust at once. This may clog the filters and rapidly reduce the performance of the
vacuum cleaner.
Do not expose this vacuum cleaner to high temperatures while operating or during
storage.
Store this vacuum cleaner in a dry place.
Use the carrying handle on the back of the body to carry this vacuum cleaner.
Before servicing this vacuum cleaner, allow all parts to cool.
14
15
16
17
18
19
20
21
22
23
24
25
This vacuum contains a motor protection system to max-
imize the motor life. It is designed to shut off to avoid
overheating in case of a blockage or clogged filter. If the protection device is
activated, the vacuum stops without turning off the switch. If this happens, turn off
the vacuum and unplug the cleaner.
Please empty the dirt compartment, clean the net filter with water and check the main
filter. After approximately 30 minutes the motor will have cooled and the vacuum will
be ready to use. Operating this vacuum with clogged or dirty filters may cause the
vacuum to overheat. Please clean the filters regularly.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
CAUTION:
S5170/t5180(Layout) 2001.12.20, 8:07 AM3
4
REAR
PARTS IDENTIFICATION
SPECIFICATIONS
FRONT
FEATURES
MODEL
INPUT
(Amp) POWER
CONTROL CORD
LENGTH
HEAD LIGHT
12.0 24 Ft
YES NO
12.0 35 Ft
YES YES
EC-S5170
EC-T5180
EC-T5180A
EC-T5180B
Extension Wands and
Crevice Tool
Cord Clip
Dirt Compartment
Max Fill Line
Handle Release
Head Light
Bumper
Power Control
(EC-T5180 series only)
Handle Screw
Main Filter (Inside)
Suction Hose
Rug / Floor Selector
Pedal
Head Cover
Extra Hose (EC-T5180 series only)
S5170/t5180(Layout) 2001.12.20, 8:07 AM4
5
Operate vacuum cleaner only at the voltage specified on the nameplate.
WARNING:
REAR
Dirt Compartment
Dirt Compartment
Handle (Lower)
Dirt Compartment
Handle (Upper)
Bumper
Exhaust Filter (Inside)
Max Fill Line
Power Cord
Upholstery Tool with
Detachable Brush
Name Plate
ON/OFF Switch
Cord Storage Hook
Carrying Handle
S5170/t5180(Layout) 2001.12.20, 8:07 AM5
6
OPERATING INSTRUCTIONS
First remove the handle screw.
Then slide the base of the handle to
the body of the vacuum cleaner as
shown. (Fig. 1)
1
HOW TO ATTACH THE HANDLE TO VACUUM CLEANER
Fig.1 Fig.2
Line up the hole on the handle with the
hole on the side of the vacuum cleaner
and insert the screw. (Fig. 2)
Be sure the screw is tightened securely.
2
Insert the power cord in the clip
located on handle as shown. (Fig. 3)
1
HOW TO WIND POWER CORD
Wrap excess cord around the cord
storage hooks to prevent dragging and
any interference with cleaning. (Fig. 4)
2
Fig.3
HOW TO RELEASE POWER CORD
Fig.5
Rotate the upper cord storage hook
downward for quick cord release. (Fig. 5)
Fig.4
Handle
Handle screw Handle screw
Handle
Clip Upper cord
storage hook
Upper cord storage hook
Lower hook
Slide
S5170/t5180(Layout) 2001.12.20, 8:07 AM6
7
HOW TO RELEASE THE HANDLE
Upright Position
Fig.6
Fig.7
Fig.8
Place foot on the left side of the nozzle head and pull the
handle to release.(Fig.6)
Push the handle forward so it is locked in upright position. In
this position, agitator brush stop autmatically by "Agitator
Safety Mechanism".
NOTE: Agitator Safety Mechanism
The brush is stopped by Agitator Safety Mechanism to
prevent damage of rug or floor during operation in upright
position.
HOW TO OPERATE "RUG" /"FLOOR"SELECTOR PEDAL
The Rug / Floor selector pedal is located at the right side of
the head.
Select the pedal position for appropriate ate flooring. (Fig.7)
"RUG" POSITION
In this position, agitator brush is rotating and vacuums from
the main duct for rug and carpet cleaning.
"FLOOR" POSITION (Bare Floor Position)
In this position, agitator brush is stopped and
vacuums from the front channel of the nozzle head
for barefloor or flat surface cleaning.(Fig.8)
Front channel for barefloor or flat
surface cleaning
"RUG" POSITION
"FLOOR" POSITION
Agitator Main Duct for rug
and carpet cleaning
S5170/t5180(Layout) 2001.12.20, 8:07 AM7
8
Fig.9
ON/OFF SWITCH
At the back lower left of vacuum cleaner. The ON/OFF
switch is located. (Fig.9)
OPERATING INSTRUCTIONS
POWER CONTROL SWITCH
A slide switch allows selection of cleaning power
from low "L" to high "H". To increase the suction
power; slide the switch toward the "H" position.
To decrease the suction power, slide the switch
toward the "L" position. (Fig.10)
HIGH:
LOW:
Greatest suction power for heavy
vacuuming jobs. Medium power levels are
positioned between "H" and "L".
Low suction power for delicate cleaning jobs.
Fig.10
HIGH
LOW
POWER
ON/OFF Switch
(EC-T5180 series only)
S5170/t5180(Layout) 2001.12.20, 8:07 AM8
9
CREVICE TOOL
For door tracks, narrow spots, etc.(Fig.12)
Fig.11
Fig.12
HEAT PROTECTION SYSTEM
This vacuum cleaner has a special thermostat that protects the motor from overheating. If the
vacuum cleaner suddenly shuts off, turn off the vacuum and unplug the cleaner. Check the
vacuum cleaner for a possible source of overheating such as a full dirt compartment or
clogged filters. If these conditions are found, empty the dirt compartment and clean the filters
(see pages 10 and 11) or replace if necessary (see page 15). To maintain the best
performance of your vacuum cleaner, we recommend emptying the dirt compartment before
the dirt reaches the “Max Fill Line”and clean the filters.
HOW TO USE THE ON BOARD TOOLS
EXTENSION WANDS
For reaching ceilings, curtains, etc.(Fig.13)
Combine these wands at the end of suction
hose. (Fig.14-1)
When connecting two wands, match the
illustrated mark to each other.(Fig.14-2)
SUCTION HOSE
For using ON BOARD tools, remove the
suction hose from the nozzle head. (Fig.11)
UPHOLSTERY TOOL WITH DETACHABLE
BRUSH
Use the brush for upholstered furniture, table
tops, books, lamps, baseboards, etc. (Fig.16)
Use without the brush for draperies,
mattresses, clothing, carpeted stairs, etc.
(Fig.15)
Fig.13
Fig.14-1
Fig.15 Fig.16
Pull to Detach brush
from tool
Turn to adjust cleaning angle
Fig.14-2
S5170/t5180(Layout) 2001.12.20, 8:07 AM9
10
1
2
OPEN CLOSE
MAINTENANCE INSTRUCTIONS
1
2
Unplug this vacuum cleaner from the electrical outlet before servicing.
Fig.17
DIRT COMPARTMENT
The dirt compartment assembly consists of the following parts:
HOW TO REMOVE AND REPLACE DIRT COMPARTMENT
Press down dirt compartment release button
to remove dirt compartment from vacuum
cleaner. (Fig.19)
Hold lower handle on dust cup and turn top
handle grip slightly to left Remove net filter
assembly from dirt compartment. (Fig.20)
Fig.18
Dirt Compartment Release
Filter Compartment
Upper Handle
Air Duct
Net Filter Assembly
Lower Handle
Dirt Compartment
Rectangular Groove
Filter Clamp
Top Handle Grip
Filter Compartment
Main Filter
Fig.19
Fig.20
Net Filter
Assembly
Air Duct
Dirt Compartment
Filter Cover
Max Fill Line
OPEN/CLOSE marks are at the
side of the Filter Compartment.
S5170/t5180(Layout) 2001.12.20, 8:07 AM10
This manual suits for next models
4
Table of contents
Other Sharp Vacuum Cleaner manuals
Sharp
Sharp EP703C User manual
Sharp
Sharp EC-A1RAS User manual
Sharp
Sharp EC-LH17-WH User manual
Sharp
Sharp EC-6312P User manual
Sharp
Sharp EC-C1819-R User manual
Sharp
Sharp EC-SC85H-H User manual
Sharp
Sharp EC-T2860 User manual
Sharp
Sharp EC-SC95U-H User manual
Sharp
Sharp EC-C1219-S User manual
Sharp
Sharp EC-CB18 User manual
Sharp
Sharp EC-LS18 User manual
Sharp
Sharp EC-SC75H-H User manual
Sharp
Sharp EC-12TWT9 User manual
Sharp
Sharp EC-SA86B User manual
Sharp
Sharp EC-NS16 User manual
Sharp
Sharp EC-S2142 User manual
Sharp
Sharp EC-A1RHK User manual
Sharp
Sharp EC-SC95H-H User manual
Sharp
Sharp EC-A1RA User manual
Sharp
Sharp EC-T2840 User manual
