c
....
____
I_n_st_8_II_in
....
g_A_dd_i_ti_o_n_81_M_in_i-_F_lo_p
....
P
....
Y_D_iS_k_D_r_iV_8_S
____
)
The optional MZ-1 C30 cable
is
provided
for
connecting additional
mini-floppy
disk drives.
Note:
The maximum number
of
disk drives which
can
be
connected
is
4.
1_
MZ-1
F19
1) Turn
off
the MZ-800 and its peripheral units.
2) Remove the screw on the
left
side
of
the additional disk drive and remove
the cover.
I.--\--
Jumper
(set
at
the
time
of
shipment)
Screw
3)
Reset
the
DRIVE
SELECT jumper on the
circuit
board according
to
the
• drive number. (The drive number
is
set
to
1 at the
time
of
shipment.)
Note:
The jumper setting pattern should
be
one
of
the
4 patterns on the
next
page.
4) Replace the cover and screw
it.
5) Remove the lower connector cover on the rear panel
of
the disk drive
which
is
already connected, and plug the connector
with
the
name label
of
the MZ-1 C30 cable
into
the lower connector. Connect the other
connector
of
the cable
to
the upper connector
of
the additional disk drive.
Fasten
both
connectors
of
the cable
with
screws.
Follow
the
same
procedures when the
third
and
fourth
disk drives are
connected.
- 6 -
