Seorim Technology AKR-301 User manual
1
AKR-301 Full Manual V.1.0
Miniature DVR
AKR-301
User’s Manual
2
AKR-301 Full Manual V.1.0
※
The contents of the manual can be modified without prior notice to customers
GENERAL SAFETY AND PRECAUTIONS
This AKR-301 is manufactured to meet international safety standards. Review the following safety
precautions to avoid injury and prevent damage to the AKR-301 or any products connected to it.
1. Use a correct power source. Do not connect this product to a power source that supplies more than
the specified voltage (DC12V), as this will cause damage to the unit.
2. Never insert anything metallic into the AKR-301 as this can cause electric shock.
3. Do not operate in wet & dusty conditions. Keep product surfaces clean and dry. Avoid placing the
AKR-301 in areas like a damp basement or a dusty hallway.
4. Do not expose this product to rain or use near water. If the product gets wet, unplug it and contact an
authorized dealer immediately.
5. To clean the outside case of the AKR-301, use a lightly dampened cloth (no solvents).
6. Do not operate if you suspected to unit is faulty. If there are any unusual sounds or smells coming
from the AKR-301, immediately unplug it and contact an authorized dealer or service centre.
7. Do not attempt to remove the top cover.
Warning: Removing the AKR-301’s cover can cause an electrical shock.
8. Handle AKR-301 carefully to avoid damaging the product. Dropping your AKR-301 on any hard
surface may cause the unit to malfunction. If the AKR-301 doesn’t work properly due to physical
damage, contact an authorized dealer for repair or exchange.
9. The unit has a lithium battery preinstalled.
10. The standard lithium cell 3V battery located on the motherboard should be replaced if the time clock
does not hold its time after the power is turned off.
3
AKR-301 Full Manual V.1.0
TABLE OF CONTENTS
Chapter 1: Packing Contents
CONTENTS IN THE PACKAGE 05
Chapter 2: Getting To Know Your AKR-301
AKR-301 06
Chapter 3: Remote Controller
REMOTE CONTROLLER PANEL 08
Chapter 4: Getting Started
OVERVIEW OF SET UP PROCEDURES 09
Chapter 5: Hardware Installation
SD Memory INSTALLATION 10
CONNECTING THE AKR-301 TO YOUR TV SET OR MONITOR 10
ALARM INSTALLATION 11
Chapter 6: AKR-301Menu
1. ACCESS TO OSD MENU 12
2. MAIN MENU 12
3. SYSTEM SETUP
3.1 DAYLIGHT SAVING
3.2 VIDEO OUTPUT
3.3 BRIGHTNESS
13
4. RECORDING SETUP
4.1 VIDEO QUALITY
4.2 FRAME RATE
4.3 PRE RECORDING TIME
4.4 POST RECORDING TIME
4.5 AUDIO RECORDING
4.6 DISK OVERWRITE
14
5. EVENT SETUP
5.1 MOTION DETECTION
5.2 SCHEDULE SETUP
15
4
AKR-301 Full Manual V.1.0
6. SEARCH LIST
6.1 SEARCH FACTOR
16
7. SUB MENU 17
7.1 PASSWORD CHANGE
7.2MEMORYSYNC
17
17
Appendix:
TECHNICAL SPECIFICATIONS 18
RECORDING TIME TABLE 19
5
AKR-301 Full Manual V.1.0
Chapter 1: Packing Contents
▶Contents in the package
AKR-301 Main Unit Remote Control AV-OUT Cable
12V Power Supply Installation CD Quick Guide
SD Card (Option) USB SD Reader (Option)
6
AKR-301 Full Manual V.1.0
Chapter 2: Getting To Know Your AKR-301
▶ AKR-301
This chapter briefly describes the functions of each connection and LED on AKR-301. For more details on
the set-up and operation of AKR-301, refer to Chapter 6, AKR-301 MENU.
1Recording LED
This light indicates while AKR-301 is recording.
2Power LED
This light indicates when the AKR-301 is powered up.
3AV-OUT
Connect AV-OUT monitor cable.
4Power
Connect 12V power supply.
5Focus Handle
Adjust focus. (Focus Near / Focus Far)
6CCD Lens
1/3” Sony New Structure Super HAD Color CCD
7Recording Button
① ②
③
④
⑥
⑦
⑧
⑨
⑤
⑩
⑪
7
AKR-301 Full Manual V.1.0
The button to record video.
8Bracket Hole
The hole to connect wall mount bracket (Soon Be Available)
9SD Memory Slot
Insert SD Card into the data storage slot.
10 Remote Controller Receiver
The remote control must be pointing at the AKR-301 and be in line of sight to work.
11 Reset
Pressing the reset button will return the AKR-301 setting to factory default.
8
AKR-301 Full Manual V.1.0
Chapter 3: Remote Control
1 REC: Starts AKR-301 recording.
2 MENU: Enters the AKR-301 ‘MENU’ mode.
3 UP/ DOWN buttons to chooses menu fields and changes values.
4 Plays recorded video forward. Plays recorded video backward.
5 REW: Fast Rewind button
6
FF: Fast forward button
7
PLAY: The button to start video playback.
8
STOP: The button to stop playback or recording.
9
PAUSE: The button to pause video playback.
10
MUTE: The button to pause audio.
11 ENT: The button to choose or change a menu option or values in a menu field.
12
SEARCH: The button to find recorded files in SD Memory.
13
MODE: Exit Menu Mode
9
AKR-301 Full Manual V.1.0
Chapter 4: Getting Started
OVERVIEW ON SET-UP PROCEDURES
Below is an overview of the installation steps required get your AKR-301 unit working.
Each step is explained in detail in Chapter 5 - Hardware Installation.
(1) Insert a SD MEMORY.
(2) Connect the AKR-301 to a TV set or monitor by using AV-OUT cable.
(3) Connect the power.
(4) Turn the power on.
(5) Start TV Monitoring and recording.
GeneralOperatingAdvice:
●Make sure that a SD Memory card is inserted.
(See Chapter 5 -Hardware Installation)
●The firmware used in AKR-301 is compatible with your computer’s operating system (i.e. Windows).
Therefore, you can take the SD memory card from this AKR-301 and install it in your computer to view
recorded video. (Refer to the AKR Player manual.)
●AKR-301 offers you the flexibility to choose a recording frame rate (maximum rate: 30 frames per second).
The faster frame rate the greater the SD Memory storage capacity required. Reducing the frame rate
(minimum rate: 1 frame per 10 seconds) will allow a greater recording duration.
●When first powering up AKR-301, the unit enters the default operational state: “VIEW mode”.
In this mode, AKR-301 does not record nor play the recorded stream, but only shows the current images from
the camera.
●The default recording values for the AKR-301 are 30 frames per second (25 frames in PAL) with normal
video quality. If you use 1GB SD Memory, AKR-301 can record for approximately 2 hours.
●If the power is inappropriately turned off while AKR-301 is in the record mode (i.e. power failure), it will re-
enter the record mode automatically when power is re-established.
Refer to Chapter 5 - Hardware Installation for more information on installation procedures.
10
AKR-301 Full Manual V.1.0
Chapter 5: Hardware Installation
SD MEMORY INSTALLATION
①Format SD Memory
Most SD cards are pre-formatted to FAT32. If not, insert the
card into the SD card slot on your PC and format it there.
※In case there is no card slot on your PC, use and external
card reading device.
②Insert SD Memory into SD slot
on AKR-301
After formatting, take the SD Memory card from your PC and
insert it into SD slot on AKR-301.
③Backup recorded files in SD Memory
When SD Memory storage is full, the recorded files can be
backed up in your PC. Insert SD card in your PC and move
the files of SD card into the HDD of our PC. You can also
check each recorded file through AKR Player.
※It is recommended that only SanDisk or Transcend SD cards are used, these are compatible with AKR-301.
※Be sure to turn off AKR-301 first when you take out SD card from the slot.
CONNECTING THE AKR-301TO YOUR TV SET OR MONITOR
①Video Output Connection (For TV / monitor screen display)
To display images from the AKR-301, connect the video output signal to your monitor or Television. Any
Television with a VIDEO INPUT terminal is suitable for displaying the images. The diagram above shows
the video signal connections.
Table of contents
Other Seorim Technology DVR manuals
Seorim Technology
Seorim Technology Micro DVR AKR-200 User manual
Seorim Technology
Seorim Technology AKR-200 Instruction Manual
Seorim Technology
Seorim Technology AKR-100 User manual
Seorim Technology
Seorim Technology F1-110 User manual
Seorim Technology
Seorim Technology AKR-200 User manual
Seorim Technology
Seorim Technology AKR-100 User manual
