Senville SENTF-19JRA User manual
145x210mm k
42”(107 cm) Oscillating
Tower Fan
visit us at senville.com
Assembly
2
3
4
User servicing instructions
6
5
7
7
7
1. Do not leave the fan running unattended.
2. Keep electrical appliances out of reach of children or inrm persons. Do not let them use the
appliances without supervision.
3. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of
electric shock, this plug is intended to t in a polarized outlet only one way. If the plug does not
t fully in the outlet, reverse the plug. If it still does not t, contact a qualied electrician. Do not
attempt to defeat this safety feature.
4. If the supply cord is damaged, it must be replaced by manufacturer or its service agent or a
similarly qualied person in order to avoid a hazard.
5. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Young children should be supervised to ensure that they do not play with the
appliance.
6. After the fan is assembled, the rotor blade guard shall not be taken oagain.
- Prior to cleaning, unplug the fan.
- The rotor guard shall not be dissembled/opened to clean the rotor blades.
- Wipe the fan enclosure and rotor blade guard with a slightly damp cloth.
7. WARNING—To reduce the risk of re or electric shock, do not use this fan with any solid-state
speed control device.
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
visit us at senville.com
8. This product employs overload protection (fuse). A blown fuse indicates an overload
or short-circuit situation. If the fuse blows, unplug the product from the outlet. Replace
the fuse as per the user servicing instructions (follow product marking for proper fuse
rating) and check the product. If the replacement fuse blows, a short-circuit may be
present and the product should be discarded or returned to an authorized service
facility for examination and/or repair.
9. Do not operate any fan with a damaged cord or plug. Discard fan or return to an
authorized service facility for examination and/or repair.
4
1
2
3
5
1. Body
2. Pole
3. Base
4. Plastic nut
5. Power cord
Note: All the pictures in this manual are
for explanation purposes only.
Your product may not be exactly
as shown.
10. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or
similar coverings. Do not route cord under furniture or appliances. Arrange cord
away from trac area and where it will not be tripped over.
visit us at senville.com
1. Take out the two parts of the base from packing box. Then, align the centres of
the two parts of the base and place them in a crossed form. Align the holes with
the pegs and rotate to connect the two pieces.
2. Take out the pole from the packing box, and align the pole with the threaded structure
at the bottom of the body. Then rotate the pole clockwise to tighten the pole to the body.
3. Attach the fan body to the base with the plastic nut.
ASSEMBLY
visit us at senville.com
I. Remote Controller (Fig.1)
a. KEY INSTRUCTION
1. “ ” ON/OFF KEY
Press the ON/OFF button to turn the fan on.
Press again to turn the fan o.
2. “ ” SPEED KEY
When the fan is on, press this button to progress
through the three speeds:
low ( ), medium ( ), high ( ), then back to low again.
3. “ ” MODE KEY
Press the mode button to progress through the three modes:
continuous ( ), natural ( ), sleep ( ) then back to
continuous again. The display will indicate what mode the fan is in.
4. “ ” OSC/LOUVER KEY
When the fan is on, press this button to start or stop the fan
oscillating. The display will indicate whether the fan is oscillating
or not.
5. “ ” TIMER KEY
Press the timer button to select the length of time before the fan automatically shuts o.
The timer can be increased in one hour increments from one to 7 hours.
Fig.1
Fig.2
Remote controller
Battery
cover
1.5 V, AAA
Battery
LED Display
b. BATTERIES
(Battery not included in the packaging)
(1) Slide the battery compartment cover open.
(2) Insert the batteries, ensuring that the
batteries are placed as shown in Fig.2.
(3) Slide the battery cover back into place.
NOTES: Use manganese or alkaline batteries
of type "AAA". DO NOT use rechargeable batteries.
Set 1 hour, displays; set 2 hours, displays; set 3 hours, displays; ... set
7 hours, displays.
visit us at senville.com
c. BATTERY WARNINGS
1. Do not dispose of batteries in re; batteries may
explode or leak.
2. Do not mix old and new batteries.
3. Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
d. REMOTE CONTROLLER OPERATION
Point the remote controller at the receptor on body of the fan and press the desired
button. The remote controller will work at distances of up to roughly 16' (5 m) and
at an angle of 30ºto the right and left of the receptor.
The batteries must be removed from the remote controller when it is disposed of, and
the batteries must be disposed of safely.
II. Buttons on fan body / Panel indication (Fig.3)
The buttons on the body such as ON/OFF,SPEED, MODE,
TIMER, OSCILLATION have the same functions as those
of the corresponding keys on the remote controller.
Fig.3
USER SERVICING INSTRUCTIONS
1. Grasp plug and remove from the receptacle or other outlet device. Do not
unplug by pulling on cord.
2. Open fuse cover. Slide open fuse access cover on top of attachment plug
towards blades.
3. Remove fuse carefully. Push the fuse from the other side or turn fuse holder
over to remove fuse.
4. Risk of re. Replace fuse only with 2.5 A, 125 V fuse.
5. Close fuse cover. Slide closed the fuse access
cover on top of attachment plug.
6. Risk of re. Do not replace attachment plug.
It contains a safety device (fuse) that should
not be removed. Discard product if the
attachment plug is damaged.
Note:
1. Do not force the fuse when replacing to reduce the risk of damage.
visit us at senville.com
7
1. Be sure to unplug from the electrical supply source before cleaning.
2. Plastic parts should be cleaned with mild soap and a damp cloth or sponge.
Thoroughly remove soap lm with clean water.
3. Be sure not to allow water or other liquid to enter motor.
unplug the fan.
visit us at senville.com
visit us at senville.com
145x210mm k
Ventilateur tour
oscillant de 42 po (107 cm)
Numéro sans frais : 1 866 827-4985
Guide d’utilisation
visit us at senville.com
Consignes d’utilisation en toute sécurité
Liste des pièces
Assemblage
Instructions d’utilisation
Consignes d’entretien aux utilisateurs
Consignes d’entretien
Nettoyage
Garantie
2
3
4
5
6
7
7
7
TABLE DES MATIÈRES
CONSIGNES D’UTILISATION EN TOUTE SÉCURITÉ
AVERTISSEMENT :
1. Ne laissez pas le ventilateur en marche sans surveillance.
2. Gardez les appareils électriques hors de portée des enfants et des personnes handicapées.
Ne les laissez pas utiliser les appareils sans surveillance.
3. Ce ventilateur est muni d’une che polarisée (une lame est plus large que l’autre). An de
réduire les risques de décharge électrique, cette che est conçue pour s’insérer d’une
seule façon dans une prise polarisée. Si la che ne s’insère pas complètement dans la
prise, inversez la che. Si la che n’entre pas complètement dans la prise, veuillez faire
appel à un électricien qualié. Ne tentez pas d’annuler ce dispositif de sécurité
4. Si le cordon d’alimentation est endommagé, il doit être remplacé par le fabricant, un
centre de service agréé ou une personne qualiée an d’éviter tout risque.
5. Cet appareil n’est pas destiné à être utilisé par des personnes (y compris des enfants) dont
les capacités physiques, sensorielles ou mentales sont limitées, ou qui ne disposent pas
des connaissances ou de l’expérience nécessaires, à moins qu’elles n’aient été formées et
encadrées à utiliser l’appareil par une personne responsable de leur sécurité. Les jeunes
enfants doivent être surveillés pour s’assurer qu’ils ne jouent pas avec l’appareil.
6. Une fois le ventilateur assemblé, le protège-pale de rotor ne doit plus être retiré.
– Débranchez le ventilateur avant de le nettoyer.
– Le protège-pale de rotor ne doit pas être désassemblé ou ouvert pour le nettoyage des
pales du rotor.
– Essuyez le boîtier du ventilateur et le protège-pale de rotor au moyen d’un chion
légèrement humide.
7. AVERTISSEMENT — Pour réduire le risque d’incendie ou de décharge électrique, n’utilisez
PAS ce ventilateur avec un dispositif de commande de vitesse transistorisée.
VEUILLEZ LIRE ET CONSERVER CES CONSIGNES DE SÉCURITÉ IMPORTANTES
visit us at senville.com
Table of contents
Languages:
Popular Fan manuals by other brands
ELTA FANS
ELTA FANS H03VV-F installation guide
Hunter
Hunter 20714 Owner's guide and installation manual
Emerson
Emerson CARRERA VERANDA CF542ORB00 owner's manual
Hunter
Hunter Caraway Owner's guide and installation manual
Panasonic
Panasonic FV-15NLFS1 Service manual
Kompernass
Kompernass KH 1150 operating instructions
