Sensata Technologies 5 220808
Calibration of the input frequency range
The ISOSLICE-7 has an LED that shows which mode it is in.
Green run mode
Amber learn range for frequency channel 1 (input 3)
Red learn range for frequency channel 2 (input 5)
In run mode, the frequency ranges selected can be observed without the risk of changing
the calibration. Push and release the Lower button to see the range for frequency channel
1 (input 3). The LED will flash amber. Count the number of times it flashes.
1 flash = 0 to10 Hz
2 flashes = 0 to100 Hz
3 flashes = 0 to1000 Hz
4 flashes = 0 to10000 Hz
In run mode, push and release the Raise button to see the range for frequency channel 2
(input 5). The LED will flash red. Count the number of times it flashes.
Changing the input range for channel 1 (input 3)
In run mode, press the Lower button and hold it for 4 seconds, until the LED changes from
green to amber.
Release the Lower button.
Push and release the Raise button to increase the frequency range
or Push and release the Lower button to decrease the frequency range.
The LED will flash green 1 to 4 times after a button press, indicating the range selected.
When the required range has been selected, push both buttons at the same time and
release. The amber LED will extinguish for ¾ second then change to green, as the
selected range is saved and it returns to run mode. The range is retained over a power
cycle.
Changing the input range for channel 2 (input 5)
In run mode, press the Raise button and hold it for 4 seconds, until the LED changes from
green to red.
Release the Raise button.
Push and release the Raise button to increase the frequency range
or Push and release the Lower button to decrease the frequency range.
The LED will flash green 1 to 4 times after a button press, indicating the range selected.
When the required range has been selected, push both buttons at the same time and
release. The red LED will extinguish for ¾ second then change to green, as the selected
