Scion Technology Document 6-004-01-GB Page 3 Of 12 Pages
SETTING UP BY ENTERING A 3 DIGIT CODE
Please refer to the code list further down this manual and look up the 3 digit code which
corresponds to the brand of TV to be controlled. If there is more than one code listed
against the brand start with the first code.
The following handset keys are relevant to this procedure:
Numeric keys
Standby keyMute key
With good batteries installed in he handset, and after identifying the codes applicable to
the TV set brand, follow the steps below.
1) Switch on the TV to be controlled.
2) While pressing and holding down the STANDBY key, hold down the MUTE key. Keep
both keys pressed down for approximately two seconds until the INDICATOR key
flashes once.
3) Use the numeric keys on the handset to enter the 3 digit code corresponding to the TV
to be controlled.
4) Press and release the STANDBY key. The INDICATOR key should blink 3 times,
indicating that the code has been stored in the handset’s non-volatile memory.
5) While pointing the handset to the TV, try all of the functions of the remote control.
6) If the TV set does not respond or responds incorrectly to the commands, repeat steps
1 to using the next code in the list, until a fully-functional code is found.
7) In case none of the codes provide the necessary functionality, please consult the
corresponding page of the Scion’s web site for the latest available TV set code
information.
If the INDICATOR key does not blink 3 times at the end of step 4 an incorrect code has
been entered. In this case, repeat steps 1 to 4.
Once the correct code is found, it should be noted on the label inside the battery
compartment lid for future reference. It should also be noted on the corresponding section
of this manual.
