5
Set-Up / Operation
1. Always operate the power mister on a level surface. In the
event the unit is tipped over or tilted more than 35 degrees, a
built-in tip switch will shut off power to the pump and fan.
Power will be restored when unit is returned to the upright
position.
2. Fill cooler or tank with clean, fresh water (ice may be added)
each time the mister is used. Drain remaining water after
each use.
3. Aim the mister downwind for best results. If more than one
mister is used, arrange them in an arc around the area to be
misted.
4. To energize, plug the GFCI safety plug into any 120 VAC
60 Hz grounded outlet. Test GFCI per instructions below.
Turn the mister on using the rocker switch located on the top
of the pump enclosure. Place the switch in the FAN position
for air movement only, or FAN/MIST for air and mist.
5. Use the pull chain located on the back of the fan to choose
fan speed (OFF, LOW, MEDIUM, HIGH). If fan does not
operate when rocker switch is in the FAN or FAN/MIST
position, the pull chain may be OFF.
6. The mist hub located in the center of the fan is equipped with
four nozzles. The output volume of water vapor can be reduced
by replacing one or two of the nozzles with the plugs provided.
7. The unit will mist for approximately five hours on 10 gallons
of water.
GFCI TEST
The ground fault circuit interruptor (GFCI) mentioned above
provides protection from electric shock by examining the product's
electrical circuit for current leakage. It must be tested before each
use to assure safe operation. Follow these steps:
1. Plug into outlet - the indicator will show if power is available.
2. Press the TEST button - indicator will turn off.
3. Press the RESET button. Use product only if GFCI resets.
** DO NOT USE IF TEST FAILS. **
WARNING
ELECTRICAL SHOCK
HAZARD
PINCH HAZARD
TRIP HAZARD
• Serious injury or death is possible.
• Plug these units into properly
grounded receptacles only.
• Disconnect from electric supply
before filling, servicing, or
moving this equipment.
• Test GFCI before using. See
instructions at left.
• Do not carry the unit by the motor,
electric cords, hose line, fan guard
or bracket.
• Do not touch fan motor during use
or directly after; it may be hot.
• Do not operate fan without
guards in place.
• Do not insert anything into fan
guard while fan is operating.
• Unplug unit and dry any wet areas
before resetting a unit that has
tipped over.
• Position all electric cords to lie
flat on the ground or floor.
• Never use during rain, sleet, hail,
snow or any other inclement
weather conditions.
TEST
Fan
ON
Plugs
RESET
OFF
Nozzle (spare)
Fan/
Mist
ON
Pull chain
