Saxby Lighting Flexline Kit Manual

Instruction leaflet

Flexline Kit

52305, 52306

Waste electrical products should not be disposed of with household waste. Please recycle where facilities

exist. Check with your Local Authority or retailer for recycling advice.

Recycling advice

Commissioning

place.

V2 16/04/2021

WWW.saxbylighting.com Saxby lighting. BH17 7BY

For your safety, always switch off the power supply before changing lightbulbs, or cleaning.

Safety information

Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and

satisfactory operation of this product. Please retain these instructions for future reference.

Warning

The power supply is Double Insulated and does not

require connection to an Earth circuit.

The LED strips are Safety Extra Low Voltage and

must not be earthed.

Please read these instructions carefully before

commencing any work.

This unit must be fitted by a competent and qualified

electrician.

Install in accordance with IEE Wiring regulations and

current Building Regulations.

This system operates at Safety Extra Low Voltage

(12V), via a LED driver. Never connect the light fittings

directly to the mains without using a LED driver.

Ensure that the supplied LED driver is used.

The mains plug must be situated indoors (e.g. house,

garage, shed) in order to protect it from the elements.

Do not exceed the LED driver load. LED drivers may

require a minimum load to operate.

Always disconnect the LED driver from the mains

when installing or maintaining this system.

This system contains non-replaceable parts and

cannot be serviced. If damage occurs the part should

be scrapped.

This product cannot be dimmed.

This product is rated at IP20

Waste electrical products should not be disposed of

with household waste. Please recycle where facilities

exist. Check with your local authority or retailer for

recycling advice.

Specification

Dimensions : 8.0mm wide, 2.5mm high, 5m long

Voltage : 240V ~ 50Hz

LED Voltage : 12V d.c.

Lumens : 1260 lm

Layout

which can be stuck to most surfaces.

of 100mm or multiples of 100mm.

ensuring the cables will reach the distance between

the power supply and the Flexline LED position.

cause a hazard. Position cables and Flexline LED's

away from areas where they may be at risk from

being cut, trapped or damaged.

conduit or plastic trunking.

Basic Installation

Specification

The Kit should contain:

indoor mains outlet socket that the system will

connect to. Do not plug-in at this stage.

ensure that the cable can reach when in the desired

position.

lengths, by unplugging the four pin connectors. To

shorten the flexline to a specific length, then it can

be done in multiples of 100mm. Look for the line on

the strip with four copper pads, as shown below.

anywhere else on the strip as this will cause the

Flexline strip to stop working. Please note that once

cut, these strips can only be rejoined by soldering.

connector on the Flexline strip observing the correct

polarity (align arrows as shown below).

This manual suits for next models

Other Saxby Lighting Lighting Equipment manuals

Saxby Lighting

Saxby Lighting SHIELDPRO CCT 90376 User manual

Saxby Lighting

Saxby Lighting IkonPRO RGB LED Kit User manual

Saxby Lighting

Saxby Lighting Reeve Connect Batten Series Manual

Saxby Lighting

Saxby Lighting 75430 User manual

Saxby Lighting

Saxby Lighting 48700 Manual

Saxby Lighting

Saxby Lighting 99562 User manual

Saxby Lighting

Saxby Lighting HeroPro CCT Emergency User manual

Saxby Lighting

Saxby Lighting Scoop Rectangular Recessed Manual

Saxby Lighting

Saxby Lighting 13801 User manual

Saxby Lighting

Saxby Lighting Reeve 2 Manual

Saxby Lighting

Saxby Lighting Sight Twin Spot Manual

Saxby Lighting

Saxby Lighting Lucca Wall User manual

Saxby Lighting

Saxby Lighting SMART IKON User manual

Saxby Lighting

Saxby Lighting ALBA SOLAR POST PIR User manual

Saxby Lighting

Saxby Lighting Odyssey Spike Manual

Saxby Lighting

Saxby Lighting 43787 Manual

Saxby Lighting

Saxby Lighting 10430 Manual

Saxby Lighting

Saxby Lighting Surge PIR Manual

Saxby Lighting

Saxby Lighting Albus CCT User manual

Saxby Lighting

Saxby Lighting Pillo Plus CCT User manual

Saxby Lighting

Saxby Lighting 74824 Manual

Saxby Lighting

Saxby Lighting 103253 User manual

Saxby Lighting

Saxby Lighting Odyssey Bollards ST501228 User manual

Saxby Lighting

Saxby Lighting 51994 Manual

Popular Lighting Equipment manuals by other brands

Brizo

Brizo 8SP-MU-4 manual

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 installation instructions

IKEA

IKEA BJÖRKSPIREA manual

Laserworld

Laserworld Evolution Series ES-400RGB manual

Alien

Alien RG STAR user manual

EuroLite

EuroLite LED B-40 user manual

Qazqa

Qazqa Suplux SL 3 Black 103062 instruction manual

Commercial Electric

Commercial Electric 54568141 Use and care guide

CREE LIGHTING

CREE LIGHTING 304 Series installation instructions

Goobay

Goobay 49867 user manual

ECOMAN ITALIA

ECOMAN ITALIA LED T8 instruction manual

Alkalite

Alkalite Krypton KT-81 user manual

Clas Ohlson

Clas Ohlson GU10 manual

DTS

DTS DELTA 10 F user manual

ring

ring Solar Steplight manual

One Stop Gardens

One Stop Gardens 57696 Owner's manual & safety instructions

Chauvet DJ

Chauvet DJ COREpar UV120 ILS user manual

SIREM

SIREM Swimeo A2 instructions