Salton SGH10 Installation guide

INSTRUCTIONS AND WARRANTY

MODEL NO. SGH10

SALTON GAS HEATER

Thank you for purchasing the SALTON Gas Heater. Each unit is manufactured to ensure safety

and reliability and has been approved by the LPGSASA. Before using the unit for the first time,

please read the instruction manual carefully and keep it for future reference.

WARNING:

Use only LPG with this heater.

I.e. Liquefied Petroleum Gas

This appliance can be used with a gas cylinder of up to 15 kg, fitted with a left hand thread.

The heater will only work when fitted with the supplied regulator.

Amalgamated Appliances recommend the use of LPG from AFROX or TOTAL.

IMPORTANT SAFEGUARDS

When using any appliance, precautions should always be followed. Please read the instructions

carefully as they are there for your benefit and safety.

The heater must be turned “ON” and “OFF” at the gas cylinder only.

Never attempt to open any part of the heater or dismantle the controls. The supplier cannot

accept responsibility for any possible unit failure, should this instruction have been ignored.

Never use the heater if it is damaged in any way.

Never use a naked flame (matches, lighter, candle) to look for gas leaks.

Before using a new cylinder of gas, check with the gas filler that all the gas has been

removed before filling with LPG. Do not use a cylinder that has been previously filled with

Nitrogen. Any traces of Nitrogen will cause the heater not to start or the pilot light not to

operate.

The gas cylinder must always be in an upright position. Do not turn the cylinder upside down

in order to empty it completely.

Always disconnect the appliance from the gas cylinder when not in use for long periods of

time.

This appliance consumes oxygen when in use. Always ensure adequate ventilation for the

effective performance of the appliance as well as the safety of the people in the area in which

the heater is being used.

The flexible gas hose must be checked periodically for signs of cracking.

If the hose needs to be replaced, ensure that the replacement hose complies with BS3212 or

SABS 1156-2 standards and is approved for use by the LPGSASA.

Do not use this appliance outdoors and always use the heater in an upright position. Always

face the heater to the centre of the room.

Do not cover the heater with any type of cloth, clothing, foreign objects or block the airflow in

any way.

Ensure that the appliance is not too close to curtains or fabric or any other flammable

material.

Do not move the heater while it is in operation. Ensure that the flame is properly extinguished

before moving.

If a gas leak is suspected (there is a smell of gas), turn the gas OFF at the cylinder

immediately. DO NOT DISCONNECT THE REGULATOR.

Replacement of the regulator must only be carried out by an authorised dealer and must be

replaced with the same type and standard of regulator that complies with SABS 1237.

This appliance is intended for household use only. Do not use for any purpose other than its

intended function.

Close supervision is required when any appliance is used near children

Do not use the heater to cook or heat food or fats.

Do not leave the heater unattended when “ON”.

Do not use the heater unless the safety guard in front of the ceramic panels is firmly in place.

Be aware that the appliance will remain hot for some time after use.

Do not operate the heater if it is damaged, or after the appliance malfunctions. Return the unit

to the factory or supplier for examination, repair or adjustment.

In the event of BURN BACK (i.e. when the flame burns back into the jet), immediately

turn the gas supply off at the cylinder. Ensure the flame is extinguished; thereafter you

can relight the heater as described below. Should the situation repeat itself, we

recommend that you contact the supplier or an approved service centre.

OPERATING INSTRUCTIONS

IMPORTANT CAUTION

Turn the gas “ON” and “OFF” at the gas cylinder control valve only.

The Rotary Control Button does NOT turn the gas off.

1. Unpack the heater and remove all protective wrapping.

2. Ensure that the hose is in perfect condition and then proceed as follows:

Unclip the gas cylinder-retaining panel from the back of the heater body.

Place the full LPG cylinder beside the rear of the heater and attach the regulator to the outlet

valve. Ensure that the valve is clean and free of any obstructions or foreign matter.

Ensure that the lock nut on the regulator is fully tightened by hand. Do not use a spanner to

tighten.

Turn the gas supply on at the cylinder’s Control Valve.

Before first use it is advisable to check the connection between the gas cylinder and the

regulator for gas leaks as described below. Never use an open flame to test for gas leaks.

If there are no gas leaks, place the gas cylinder into the rear of the heater body making sure

that the cylinder is placed in such a manner that the hose is not trapped or blocked in any

way.

Fit the rear heater panel back onto the body ensuring that it is clipped on to both sides of the

heater.

TO TEST FOR GAS LEAKS

Extinguish all naked flames (open flames).

Turn the heater “OFF” at the cylinder.

Check all the hose connections.

Slowly turn the gas ON and brush all the connections with a cloth moistened with soapy water

or detergent.

A gas leak will form bubbles in the areas where the solution has been applied.

If a gas leak is detected, turn the gas cylinder control valve OFF and inform the nearest

service agent.

Do not use the heater again until an approved/authorised service agent has inspected it.

Do not smoke or bring naked flames near the gas heater whilst testing for gas leakage.

IGNITION PROCEDURE

The regulator must be securely and fully fastened on to the gas cylinder.

To turn the gas “ON” – carefully open the Control Valve on the gas cylinder to a maximum of

one and a half turns.

Turn the heat selection knob on the top panel of the heater to the first position, to point at the

single drop and star symbols (  ).

Push the ignition button down and hold it down for 6 to 10 seconds. The gas will flow through

the pipe to the heater, and the heater will ignite with a “Da-da” sound. Release the ignition

button after another 10 seconds.

Check if the flame at the bottom of the centre panel is burning. If not, press the ignition button

again and hold it down for 6 to 10 seconds.

The heater is now turned onto Level 1, with one ceramic panel heating. Select your required

heating level by turning the heat selection knob:

oOne drop and the star (  ) : Level 1 –the centre panel heating

oTwo drops () : Level 2 –two panels heating

oThree drops () : Level 3 –three panels heating

TURNING THE GAS HEATER “OFF”

Turn the heat control knob to the one drop and star position: (  )

Immediately turn “OFF” the gas at the gas cylinder’s control valve.

The flame at the bottom of the centre panel should automatically extinguish itself. Should

it not do so, check that the gas cylinder is OFF.

CHANGING THE GAS CYLINDER

Take the heater outside and remove the rear panel.

Take out the gas cylinder and place it on the ground next to the heater. Unscrew the

regulator –MAKE SURE THAT THE CYLINDER VALVE IS CLOSED BEFORE

ATTEMPTING TO DISCONNECT THE REGULATOR.

Before connecting the refilled cylinder, check that the nose seal on the regulator is not

damaged and is still in good condition. If in doubt, take the regulator to an authorised dealer

to be checked.

Fit the new gas cylinder into the rear of the heater body. Ensure that the cylinder is placed in

such a manner that the hose is not trapped or block in any way.

Fit the rear heater guard back on to the body securing the clips on both sides.

MAINTENANCE AND SERVICING INSTRUCTIONS

There is very little maintenance required on this appliance. Important points to remember are:

Always check that the regulator seal is undamaged when changing the gas cylinder.

Always check that the hose is in good condition before using, and that it is securely clamped

on to the appliance and the regulator.

It is recommended that the hose be replaced every two years whether it has been used or

not. When replacing the hose, make sure that it is with a hose that complies with SABS 1156-

2 or BS 3212. These are available mainly from Hardware Stores and from the manufacturer

and are orange in colour. Remember when replacing the hose to replace the hose clamps at

the same time.

With the exception of the hose and the regulator, there are no user fitted parts available for

this heater. Should the heater not be functioning properly, an authorised service agent must

check it, and if replacement parts are required, they will ensure that the correct parts are

supplied and fitted correctly.

It is recommended to have your heater checked at your local hardware store at the beginning

of every season.

WARNING

Never immerse the unit in water or let water come into contact with the burners.

Wipe the exterior of the heater with a soft cloth moistened with a mild detergent.

Do not use metal or furniture polish on the heater.

If the elements appear dusty then clean them using a soft brush or dry cloth.

Only clean the heater when it is cold and not in use.

Do not use abrasive cleaners, which will damage the paint surface.

When not in use, store the heater by covering it and placing in a cool, dry and dust free area.

If you need to return the appliance for a credit after consulting the supplier, make sure that:

1. The unit is packed carefully back into its original packaging.

2. Proof of purchase is attached.

PLEASE AFFIX YOUR PROOF OF PURCHASE/RECEIPT HERE

IN THE EVENT OF A CLAIM UNDER WARRANTY THIS RECEIPT MUST BE

PRODUCED.

1. W A R R A N T Y

2. Tedelex Trading (Pty) Limited (“Tedelex”) warrants to the original purchaser of this product

(“the customer”) that this product will be free of defects in quality and workmanship which

under normal personal, family or household use and purpose may manifest within a period of 1

(one) year from the date of purchase (“warranty period”).

3. Where the customer has purchased a product and it breaks, is defective or does not work

properly for the intended purpose, the customer must notify the supplier from whom the

customer bought the product (“the supplier”) thereof within the warranty period. Any claim in

terms of this warranty must be supported by a proof of purchase. If proof of purchase is not

available, then repair, and/or service charges may be payable by the customer to the supplier.

4. The faulty product must be taken to the supplier's service centre to exercise the warranty.

5. The supplier will refund, repair or exchange the product in terms of this warranty subject to

legislative requirements. This warranty shall be valid only where the customer has not broken

the product himself, or used the product for something that it is not supposed to be used for.

The warranty does not include and will not be construed to cover products damaged as a result

of disaster, misuse, tamper, abuse or any unauthorised modification or repair of the product.

6. This warranty will extend only to the product provided at the date of the purchase and not to

any expendables attached or installed by the customer.

7. If the customer requests that the supplier repairs the product and the product breaks or fails to

work properly within 3 (three) months of the repair and not as a result of misuse, tampering or

modification by or on behalf of the customer, then the supplier may replace the product or pay

a refund to the customer.

8. The customer may be responsible for certain costs where products returned are not in the

original packaging, or if the packaging is damaged. This will be deducted from any refund paid

to the customer.

TEDELEX TRADING (PTY) LTD (JOHANNESBURG)

JOHANNESBURG TEL NO. (011) 490-9000

CAPE TOWN TEL NO. (021) 552-5161

DURBAN TEL NO. (031) 792-6000

www.amap.co.za

Table of contents

Other Salton Gas Heater manuals

Salton

Salton SGH12 User manual

Popular Gas Heater manuals by other brands

Superior

Superior BGE18NV Installation and operation instructions

Dru

Dru Room-sealed atmospheric gas-fired heating... user manual

klover

klover TKR 35 user guide

Rothenberger Industrial

Rothenberger Industrial 035984 instruction manual

New Buck Corporation

New Buck Corporation 34 user manual

Hargrove

Hargrove Timberland Glow Operation and installation guide

Kinder

Kinder Cameo BF Installation and maintenance instructions

Qlima

Qlima GH 438 B-2 Directions for use

Desa

Desa 125-R owner's manual

Gasmate

Gasmate AH100 Series instructions

Medallion

Medallion MBP20TLB OWNER'S OPERATION AND INSTALLATION MANUAL

Clarke

Clarke DEVIL 910SS User instructions

Superior

Superior BGE18NR Operation instructions

Brant Radiant Heaters

Brant Radiant Heaters QTD Series User instruction

L.B. White

L.B. White Therma Grow HW220 Owner's manual and instructions

Sealey

Sealey LP35.V5 instructions

Italkero

Italkero Falo Evo User manual and assembly instructions

Desa

Desa 30LP owner's manual