RTS Digital Matrix Intercom RT-2M User manual
RT-2M (90007891000) Quick Start Guide
NOTE: See the entire system diagram on reverse side.
RS-232 Cable Pinout Step 1. Cable the Trunk Supervisor/TrunkEdit PC to the
RT-2M.
NOTE: In Trunk Supervisor, you must designate
the intercom and port number the RT-2M
sends the test signal over.
To cable the Trunk Supervisor/TrunkEdit PC to the
RT-2M, do the following:
1. Using the included cable, connect a COM port on
the Trunk Supervisor computer to the RS-232
Interface connector on the rear panel of the RT-2M.
Step 2. Cable the RT-2M to the Frame.
To cable the RT-2M to the Frame, do the following:
1. Using the appropriate connector defined below, connect the
RT-2M to the Frame:
2. Connect the other end of the connector to the trunking
connection port as defined in the Trunk Supervisor software.
CONNECTOR CONNECTION
RJ-12 •Plug pins 2 and 5into the Ch 1 input connector terminals.
•Plug pins 3 and 4into the Ch 1 output connector terminals.
DB-9 •Plug pins 7 and 8 into the Ch 1 input connector terminals
•Plug pins 4 and 5 into the Ch 1output connector terminals.
INCLUDED PARTS:
•RT-2M Unit
•DB-9 Cable
LIT000306000 Rev. A 11/2008
This manual suits for next models
2
Other RTS Intercom System manuals
RTS
RTS SAP612 User manual
RTS
RTS Zeus II User manual
RTS
RTS SSA-424 User manual
RTS
RTS Zeus User manual
RTS
RTS WMS300 Instruction manual
RTS
RTS Cronus User manual
RTS
RTS BP-319 User manual
RTS
RTS XCP-16-DB9-T Quick start guide
RTS
RTS Digital Matrix Intercom RVON-8 User manual
RTS
RTS CIF-612 Instruction manual
RTS
RTS User Station MCE-325 User manual
RTS
RTS 4010 User manual
RTS
RTS SSA-424A User manual
RTS
RTS EKP-32 User manual
RTS
RTS Bus Expansion Card Instruction Manual
RTS
RTS WKP-1 User manual
RTS
RTS User Station MCE-325 User manual
RTS
RTS XCP-40-DB9 Quick start guide
RTS
RTS XCP-24 Quick start guide
RTS
RTS BP-319 User manual
