INSTALLATION
Remove all the packaging materials and tape, as well as any protective plastic from
the machine. Clean off any glue residue left over from the protective plastic using
methylated spirit.
Place the Toaster on a firm, level surface in the required position. Adjust the feet if
necessary to level the unit if the surface is slightly uneven.
Fit the entry chute. The entry chute is secured in position by simply placing it over
the upper most pins protruding from the inside face of the toasting cavity so that the
chute is lying at a near 45 degree angle with the chute rest lying along the upper
crumb tray.
The exit chute can be used in two positions. Out of the box, the exit chute is in the
“Front return” position. The chute may be reversed, for pass through operation, by
unscrewing the two screws and refitting it in the reverse position. Replace the
screws in the new position to secure the chute. Note that in the reverse position
the screws are inserted from the inside of the toaster.
Before connecting the toaster to the power supply, ensure that all the controls are
in the “OFF” position.
For models TCR10, plug the toaster into a standard, single phase, 10Amp power
point.
For model TCR15, plug the toaster into a standard, single phase, 15Amp power point.
Always ensure the power cable is not in contact with hot parts of the toaster when in
use, and have any damaged power cord replaced immediately.
OPERATION
The elements and conveyer are switched on simultaneously using the rotary switch
located on the control panel labelled “POWER”. When the toaster is switched on
the pilot lights will illuminate to indicate power to the top and/or bottom elements
depending on the switch position. The conveyor speed controller located on the
control panel labelled “CONVEYOR SPEED” controls the speed of the conveyor
belt
TOASTING
Switch the power on by rotating the “POWER” switch to the required setting. For
toast switch to “top and bottom elements” (Both pilot lights should be lit). The “Top
Elements” and “Bottom Elements” only settings are for use when toasting buns and
garlic breads etc. when only one side requires toasting.
Allow a warm up time of 5 to 10 minutes.
For TCR10 set the conveyor speed control to an initial position of around 5 to 6. On
this setting of 6 for a TCR10 a piece of toast should take approximately 70 sec.
For TCR15 on an initial conveyor speed control setting of 8 to 9, a piece of toast
should take approx 50 seconds to complete toasting.
