Ricoh WXC1110 Y0AB Quick start guide

Kaus-PJ1

RICOH PJ RICOH PJ WXC1110

Machine Codes: Y0AB

Field Service Manual

May, 2016

Important Safety Notices

Prevention of physical injury

1. Before disassembling or assembling parts of the main machine and peripherals, make sure that the

power cord of the main machine is unplugged.

2. The wall outlet should be near the machine and easily accessible.

3. If any adjustment or operation check has to be made with exterior covers off or open while the

main switch is turned on, keep hands away from electrified or mechanically driven components.

• To prevent a fire or explosion, keep the machine away from flammable liquids, gases, and

aerosols.

Health safety conditions

This machine, which uses a high voltage power source, can generate ozone gas. High ozone density is

harmful to human health. Therefore, the machine must be installed in a well-ventilated room.

Observance of electrical safety standards

This machine and its peripherals must be serviced by a customer service representative who has

completed the training course on those models.

Safety and Ecological Notes for Disposal

Dispose of replaced parts in accordance with local regulations.

TABLE OF CONTENTS

Important Safety Notices................................................................................................................................... 1

Important Safety Notices............................................................................................................................... 1

Prevention of physical injury................................................................................................................. 1

Health safety conditions........................................................................................................................1

Observance of electrical safety standards.......................................................................................... 1

Safety and Ecological Notes for Disposal................................................................................................... 1

1. Product Information

Overview.............................................................................................................................................................5

Main Unit........................................................................................................................................................ 5

Control Panel.................................................................................................................................................. 7

Connection Ports.............................................................................................................................................8

Remote Control...............................................................................................................................................9

Specifications....................................................................................................................................................11

Product Highlights........................................................................................................................................11

General Specifications................................................................................................................................ 12

Computer Compatibility.............................................................................................................................. 13

Lens............................................................................................................................................................... 14

Supported Multi-Media Formats................................................................................................................ 14

2. Installation

Installation Requirements................................................................................................................................. 19

Environment/Power Requirements............................................................................................................. 19

Machine Space Requirements....................................................................................................................19

Machine Dimensions................................................................................................................................... 19

Main Machine Installation...............................................................................................................................20

Accessory Check..........................................................................................................................................20

Precautions................................................................................................................................................... 21

3. Replacement

Equipment Needed..........................................................................................................................................23

Parts List.............................................................................................................................................................24

Service Parts List........................................................................................................................................... 24

Part Replacement..............................................................................................................................................25

Exterior Cover.............................................................................................................................................. 25

Top Cover............................................................................................................................................ 25

I/O Cover........................................................................................................................................... 27

Bottom Cover.......................................................................................................................................28

Speaker........................................................................................................................................................ 30

FPC Cable.................................................................................................................................................... 30

Multimedia Board........................................................................................................................................31

Keypad......................................................................................................................................................... 32

Engine Module.............................................................................................................................................33

Fans...............................................................................................................................................................34

Main Board.................................................................................................................................................. 36

Adjustable Foot............................................................................................................................................ 37

4. Adjustment

Required Action after Replacing Parts ...........................................................................................................39

Special Tools.................................................................................................................................................... 40

Service Mode ..................................................................................................................................................41

How to enter the Service Mode..................................................................................................................41

Service Mode Settings.................................................................................................................................42

Calibration........................................................................................................................................................43

ADC Calibration.......................................................................................................................................... 43

Environment......................................................................................................................................... 43

Procedure.............................................................................................................................................44

Criteria................................................................................................................................................. 45

G Sensor Calibration...................................................................................................................................45

Factory Reset.................................................................................................................................................... 47

Factory Reset Procedure..............................................................................................................................47

5. Troubleshooting

Troubleshooting................................................................................................................................................49

Main Procedure........................................................................................................................................... 49

No Power Troubleshooting......................................................................................................................... 50

Power Troubleshooting................................................................................................................................51

Image Performance Troubleshooting......................................................................................................... 52

Remote Control Troubleshooting................................................................................................................ 54

LED Lighting Message......................................................................................................................................55

Error Log............................................................................................................................................................56

Checking the Error Log................................................................................................................................56

6. Firmware Update

Overview of the Firmware Update................................................................................................................. 59

System Firmware Upgrade..............................................................................................................................60

Equipment Needed......................................................................................................................................60

DLP Composer Lite Setup Procedure..........................................................................................................60

Firmware Upgrade Procedure....................................................................................................................63

AM8250 Firmware Upgrade......................................................................................................................... 69

Equipment Needed......................................................................................................................................69

USB Driver Upgrade Procedure................................................................................................................. 69

AM8250 Firmware Upgrade Procedure.................................................................................................. 72