SELECTING THE CORRECT FRAME:
1. The frame dimensions below show the measurements for when the frames have been “compressed” and pushed into
the ground. The measurements shown are the finished Width x Height from the ground when installed.
2. The side legs of the frames are vertical (or close to) when installed. “Compressing” the Cloche Frames aids strength
and wind resistance for the cloche tunnel.
3. If you are re-ordering more cloche frames from Redpath/Kerilea –please supply the model number of the sized frame
you require to get an exact match. If you do not know this –please supply the measured length of the curved frame
from tip-to-tip and also the “compressed” frame width measurement and the height from ground level to the top of the
frame, with the frame pushed into the ground up to the spring clip, pre-punched holes.
4. Redpath/Kerilea accepts no responsibility if the incorrect sizes are selected.
Frame Dimensions/Profiles
*Note: Cloche will not protect from severe frosts or sub-zero conditions. Extra layers or an alternative protection system may be needed.
MAINTENANCE
When not in use (out of season) remove the frames from the ground, wash and spray/wipe with oil to prevent the steel
corroding. Store in a dry area. The standard cloche film supplied by Redpath Kerilea is a one season only plastic. Call
Redpath on Free phone 0508 733 728 to order your Redpath/Kerilea products.
