Pro-Ject Audio Systems Stereo Box DS User manual
INSTRUCTIONS FOR USE
Pro-Ject Stereo Box DS
© Audio Trade GmbH · Pro-Ject Stereo Box DS · Revision 2013.8.15
2
Dear music lover,
thank you for purchasing a PRO-JECT AUDIO amplifier.
In order to achieve maximum performance and reliability you should study these instructions for use carefully.
!
Warning of a hazard for the user, the unit or possible misuse.
Important notice.
Safety instructions
!
AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the
voltage in your area meets the voltage requirements printed on the power supply. The power cord is
used to disconnect the unit from the mains. Make sure that the power cord is easily accessible at all
times. Never handle the device, the power cord/power supply while your hands are wet or damp.
Avoid letting liquids enter the device or the power supply. Never place any item containing liquid,
such as a flower vase on or near the device. Never spill any liquid on the device or the power supply.
Never place any naked flame sources, such as lighted candles on or near the device. The product shall not
be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions
Connectors
In USB
24V
!
Make all connections, except the connection to the computer, whilst the unit is disconnected from the
power supply.
Take care to connect the left and right channels correctly. The right channel is usually marked red, the
left channel black or white.
The red speaker terminals carry the positive signal (+), the black speaker terminals the negative
signal (–). Make sure the polarity of the connection is correct at each end of the cables.
Only connect one loudspeaker with an impedance not less than 4 ohms per channel.
Never use any other power supply than the one supplied with the unit.
Inputs
Line level sources such as CD player radio or TV can be connected to the input sockets marked 1- 4.
USB input
A computer, used as a source, can be connected to the USB input.
Connection to the speakers
The output terminals accept loudspeaker cables terminated with 4mm Banana plugs, spades connectors
or naked wire.
Mains power connection
Connect the low voltage plug from the power supply to the 24V= socket of the amplifier before connecting
the power supply to the mains.
© Audio Trade GmbH · Pro-Ject Stereo Box DS · Revision 2013.8.15
3
Remote control
1
ON/OFF
short press turns the unit on, long press takes it back into standby.
Powered on, a short press activates and deactivates mute
0
_
VOL
and
0+
VOL
adjust the sound volume
CH+
CH-
VOL+
VOL-
ON/OFF
0
_
CH
and
0+
CH
select the inputs
Front panel controls
+
-
Stereo Box DS
To switch on from standby or to standby
on the front turns the unit on or back into standby. The display shows STANDBY when the unit is in standby.
While switching off, the unit saves the settings for input, volume and mute, to be set automatically after next
power on.
Dimming the display
Press and hold the buttons and will change the display brightness - full, half and one third.
Input selector
Pressing the Input Select buttons and selects the inputs 1- 4in turns. The selected input will be shown in
the display.
Volume
Adjust the volume (95 steps) to the desired level using the buttons and . The volume level will be shown in
the display. -95dB indicates min., 00dB max..
Mute
While the unit is powered on, 0
ON/OFF
activates and deactivates mute .
© Audio Trade GmbH · Pro-Ject Stereo Box DS · Revision 2013.8.15
4
Connecting to a Computer
Connect the USB-input of the amplifier (unit must be switched on) to a free USB-socket on your computer
and turn it on/make sure it is powered on. The amp will be automatically recognised by the computer. There is
no need to install a driver manually.
Please note: Connection should be made to an USB-socket of your computer directly. Connecting to
USB-hubs or switches can cause problems.
Potential incorrect use and fault conditions
No signal on one or both channels:
No connection between headphone and headphone amplifier ore amplifier. This could be due
to a faulty plug, broken wire or solder joint or simply loose plug/socket connection.
Headphone does not work:
Headphone volume control is at minimum.
Amplifier Tape-Monitor circuit is not activated.
Replacing batteries
Proceed as follows:
Unlock and slide open the battery case cover
Replace the battery.
Make sure the battery is the right way round !
Close the battery case cover
Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.
© Audio Trade GmbH · Pro-Ject Stereo Box DS · Revision 2013.8.15
5
Technical specifications Pro-Ject Stereo Box DS
Power output: 2 x 35W/60W at 8 ohms/4 ohms (both channels driven)
Frequency response: 20Hz - 20kHz (-0,1dB, +0,2dB)
Channel separation: >65dB at 20kHz
Noise floor: >100dB (A weighted)
THD: 0,1% at 10W
Gain: 33dB
Line-level inputs: 4 pairs RCA/phono sockets
Input sensitivity: 350mV
Input impedance: 100kohms
USB-input: Mini B socket. USB cable supplied
USB signal: Digital serial data protocol USB 1.1
D/A converter: Texas Instruments PCM2706. 16-Bit /48kHz Delta Sigma,
128-times oversampling
Supported audio format: PCM (LPCM). No support for formats like Dolby®Digital or DTS™
Sampling rates: 44,1kHz and 48kHz
Speaker connectors: 4mm banana plugs, spades connectors or naked wire
Outboard power supply: 24V/5A DC, suitable for your country's mains supply
Power consumption: 5A DC, <1W in standby
Replacement battery remote control: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Dimensions W x H x D (D with sockets): 103 x 72 x 104 (122)mm
Weight: 670g without power supply
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright
PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright © 2012. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
Table of contents
Other Pro-Ject Audio Systems Amplifier manuals
Pro-Ject Audio Systems
Pro-Ject Audio Systems Amp Box SE Mono User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Record Box USB User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Power Box RS Amp User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Box RS User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Remote Box S2 User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Pro-Ject Phono Box S User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems AMP BOX DS User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Pro-Ject Head Box II User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Tube Box SE II User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Phono Box II User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Phono Box RS User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Pre Box User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Box-Design MaiA S3 User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems power box ds User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Tube Box II User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Tube Box DS2 User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Head Box SE II User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Tube Box SE II User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Pro-Ject Tube Box S User manual
Pro-Ject Audio Systems
Pro-Ject Audio Systems Tube Box DS User manual
