Premium PVC1402 User manual
1
IMPORTANT SAFEGUARDS
When using electrical appliances,basic safety precautions should always be followed,
including the following:
1. Read all instructions.
2. Make sure that your outlet voltage corresponds to the voltage stated on the vacuum
cleaner’s rating label.
3. Do not leave vacuum cleaner unattended when is plugged in. Unplug from outlet when
not in use and before servicing.
4. For indoor use only, to reduce the risk of electric shock, do not use outdoors or on wet
surfaces.
5. Close adult supervision is necessary when this appliance is used near children. Children
should not use this appliance.
6. Use only as described in this manual.Use only manufacture’s recommended
attachments.
7. Do not use with a damaged cord or plug, if vacuum cleaner is not working as it should,
has been dropped, damaged, left outdoors, or dropped into water, ask for service in an
authorized service center.
8. Do not do any following actions: pull or carry on from the cord, use cord as a handle,
close a door on cord, or pull cord around sharp edges or corners. Do not run vacuum
cleaner over cord. Keep cord away from hot surfaces.
9. Do not unplug by pulling on cord. To unplug, grasp the plug instead of cord.
10. Do not handle plug or vacuum cleaner with wet hands.
11. Do not put any object into openings. Do not use with any opening blocked. Keep free
of dust, lint, hair and anything that may reduce airflow.
12. Turn off all controls before unplugging.
13. Use extra care when cleaning on stairs.
14. Hold plug when rewinding onto cord reel. Do not allow plug to whip when rewinding.
15. Unplug before connecting the hose.
16. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot
ashes.
17. Do not use without dust bag and/or filter in place.
18. If the supply cord is damaged, it must be replaced by the manufacturer or its service
2
agent or a similarly qualified person in order to avoid any hazard.
19. Do not place an appliance on or near a hot gas or on a heated oven.
20. Assure that the ventilation slits of the appliance are not covered or blocked.
21. Keep hair, loose clothing, fingers and all parts of body away from openings and
moving parts.
22. Do not use to pick up flammable or combustible liquids, such as gasoline, and do not
use in areas where they may be present.
23. The use of accessories not recommended by the manufacturer may cause injuries to
persons.
24. Keep the appliance and its cord out of reach of children.
25. Do not operate the appliance for other than its intended use.
26. Save these instructions.
SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
3
SCHEME OF PARTS
/RFN%ORFN
$LU,QWDNH
3ODVWLFBSLSH
+RVH
+DQGOHERG\
+DQGOHSXVKEXWWRQV
)ODW6XFWLRQ6SRXW
)ORRU%UXVK
3RZHU6ZLWFK
%RG\+DQGOH
%LJ:KHHO
Front Cover
Filter
(within cover)
4
HOW TO USE
Always remove the plug from the power socket before fitting or removing accessories!
1. Attach plastic pipe to hose handle (see fig.1).
Fig.1
2. Fit floor brush to plastic pipe (see fig.2).
3ODVWLFBSLSH
)ORRU%UXVK
Fig.2
NOTE: Vacuum with fitting floor brush is ideal for daily cleaning of carpets and hard
floors (see fig.3).
Fig.3
3. To fit the extension hose, insert extension hose into the air intake on the top of
appliance. Press until it clicks into position (see fig.4).
Plastic pipe
5
Fig.4
NOTE:
1) To remove the extension hose, unplug from the power socket, then release the
extension hose from the air intake.
2) Do not use the hose to suck up water.
3) Do not immerse the hose in water for cleaning.
4) Hose should be checked regularly and must not be used if damaged.
4. Before using appliance, pull a sufficient length of cable from the appliance and insert
the plug into the power socket. A yellow mark on the power cable shows the ideal cable
length. Do not expand the cable beyond the red mark.
NOTE:
To rewind the power cable, press the rewind button beneath the body handle with one
hand and guide the cable with the other hand to ensure that it does not whip causing
damage.
Cord rewind button
6
5. Turn power Button ON to start the appliance and control dust suction.
The flat suction spout can be used for radiators, crevices, corners, baseboards and
between cushions (see fig.5).
Fig.5
PRECAUTIONARY MEASUREMENT
If the opening that sucks in the air, the suction pipe or the telescopic wand stick on pipe is
blocked, you should switch off the vacuum cleaner immediately and clear the blocked part
before you attempt to start the vacuum cleaner again.
1. Do not operate the vacuum cleaner too close to heaters or radiators, cigarette butts etc
(see fig.6).
ON/OFF Button
7
Fig.6
2. Before you insert the plug into the wall socket, make sure your hand is dry (see fig.7).
Fig.7
3. Before you start using the vacuum cleaner using floor brush, please remove large or
sharp objects from the floor in order to prevent any damage to the paper filter (see
fig.8).
Fig.8
4. When you want to pull the plug from the wall socket, grab the plug, never the power
cable (see fig.9).
Fig.9
8
NOTE: If anything gets damaged, both the plug and the cable must be repaired by a
qualified repairman or electrician.
CLEANING AND MAINTENANCE
To change the dust bag
NOTE:
1) Always operate the cleaner with dust bag installed.
2) If you forget to attach a dust bag or install it incorrectly, the front cover may not close
completely.
Follow these steps (see fig.10):
ķOpen the front cover by pushing the lock block upward.
ĸRemove the dust bag from the bag support.
ĹReplace paper bag when it is full of dirt.
ĺPlace a new paper bag into the unit.
ĻClose the cover by pushing down until it is locked.
Fig.10
To clean filter
NOTE:
1) Filter should be cleaned at least twice a year or when it becomes visible soiled.
2) Always operate the cleaner with filter installed.
3) Otherwise, reduced suction or motor damage may be caused.
4) Disconnect from electrical outlet, before cleaning filter.
9
5) Do not use a washing machine to rinse filter.
6) Do not use hair drier to dry it.
Follow these steps (see fig.11):
ķPull dust bag upward.
ĸRemove filter.
ĹRinse filter in lukewarm water and air-dry filter completely.
ĺPlace filter back in position.
Fig.11
To change the micro-exhaust filter
Follow these steps (see fig.12):
ķOpen the Air-Outlet Cover.
ĸTake the soiled filter out and change for a new one.
ĹClose the Air-Outlet Cover.
Fig.12
Table of contents
Languages:
Other Premium Vacuum Cleaner manuals
