Premier Mounts iPad IPM-100 User manual
Installation Instructions Page 1
iPad™ IPM-100 Mounting Frame Installation Instructions
9531-056-001-01
Parts List
IPM-100
IPM-100 - Front Piece
(Qty 1)
M5 Security Allen Wrench
(Qty 1)
M4 x 8mm Security Screw
(Qty 4)
3130 East Miraloma Avenue
Anaheim, CA 92806 USA
USA and Canada
Phone: 1.800.368.9700
Fax: 1.800.832.4888
Other Locations – Phone: (001).714.632.7100; Fax: (001).714.632.1044 ©Premier Mounts 2011
The IPM-100 mounting frame securely holds the Apple iPad™ or
iPad2™ (not included) in place and prevents access to all control
buttons except the home button. It fastens easily to any of Premier
Mounts’ wall or table mounts (sold separately) using the VESA
100x100mm mounting pattern. The IPM-100 provides exibility and
security for the optimal hands-free experience.
• All trademarks are the property of the respective trademark owners.
IPM-100 - Back Piece
(Qty 1)
iPad2™ Kit
Adhesive-Backed
Bumper (Qty 8)
Adhesive Foam
Tape (Qty 2)
Step 1
Are you installing an iPad™ or iPad2™ to the IPM-100?
If an iPad™, skip to step 5 on page 2.
If an iPad2™, continue to step 2 below.
Step 2
C
C
C
C
1½˝
1½˝
Step 4
Attach four (4) adhesive-backed
bumpers to locations “C” on the inside
of the back piece.
Locations “C” are 1½˝ away
from the center of each bump
on the back piece.
Make sure the metal bumps on
the back piece are protruding
on the opposite side of the
adhesive-backed bumpers.
Continue to step 5 on page 2.
Attach two (2) strips of adhesive foam
tape to locations “A” inside the front
piece.
Locations “A” are inside the
outer edges of the front piece.
Attach four (4) adhesive-backed bumpers to
locations “B” inside the front piece.
Locations “B” are over the centers of
the inside slots.
Step 3
Inside of Front Piece
B
B
B
B
A
A
Page 2 Installation Instructions
IPM-100
Place the iPad™ and its attached
dock connector into the front piece.
Step 6
Thread the USB end of the dock
connector through the slot of the
back piece.
Step 7
Thread the USB end of the
dock connector through
this slot.
Make sure the bumps of the
VESA mounting holes on the
back piece are facing away
from the iPad™.
Step 5
Attach the dock connector to the iPad™. Use the M5 security Allen wrench
and four (4) M4 x 8mm security
screws to fasten the back piece to
the front piece.
Step 8
Attach the IPM-100 to the desired mount (not included). Refer to
the mount’s installation manual.
Step 9
Other Premier Mounts Tablet Accessories manuals
