Latch/bolt
ADJUSTMENT TAB B
(use this side if latch fits too tightly into strikeplate)
ADJUSTMENT TAB A
(standard position)
Self Adhesive cover plate
AM60 - ITP
AM60 - ITP installation tool pack (sold separately)
FIG. B
8. Insert latch assembly into the door edgebore hole (8a) and
secure in place with screws provided. Be careful not to over
tighten screws as this may cause the flanged housing cups to
deform and/or cracking in timber. Note: screwheads must fit
below, or perfectly flush to the surface of the latch/strikeplate,
to allow coverplates to adhere properly to surface (FIG. A). Now
install chosen door handles as per manufacturers instructions.
10. Affix the 'self-adhesive' s/steel coverplates to the faces of
the latch and strikeplate for a more attractive 'concealed fix'
finish. (optional).
Note: make sure metal faces of latch and strikeplate are free
from dust /oil etc before affixing coverplates, to insure
maximum adhesion strength.
9. Insert the strikeplate assembly (incl. strikebox/drilling template)
into the prepared jamb 'cutout' so that the latch/bolt rests against
Adjustment Tab A when in the locked/latched position (FIG. C).
Secure in place with screws provided.
Test door operation and if necessary 'bend out' adjustment tab
with the AM60 ITP screwdriver (FIG.B), to reduce latch/bolt rattle.
7. Example of 'door preparation' completed - ready for the
latch/bolt to be installed.
