Version 07/06 4
3. Fit back axle to frame: slide axle inside frame (fig 4) locating four bolts into the slots
(fig 5). Don’t tighten nuts for the moment.
Note: four locating holes for the battery cage should be uppermost.
4. Fit small rear chain and adjust it: first of all, ensure cogs are lined up. Then, using
chain link tool to insert pin into link from one side until proud (fig 6). After that, swap
link over and push pin back a little to allow free movement of link (fig 7). Finally,
tighten the chain (do not overtighten: leave around 1cm loose), check alignment and
tighten all nuts on rear assembly (14mm).
Note: extra link may be required on 20” model.
5. Assemble front wheel: fit wheel rim protector ensure valve holes are aligned and all
spoke ends covered (fig 8). Fit tyre, inner tube and inflate to 40psi.
Fig 8
Fig 6
Fig 7
Fig 4 Fig 5
