Potensic U47 User manual
Operation Guide
U47
2
Catalog
Instruction for Drone and Controller 3
Installing & Removing Spare Parts 7
Pre-Flight Checklist 10
Pre-Flight Operation Instructions 11
Functions 14
Using App 16
Spare Parts 17
Precaution about taking photos 16
Troubleshooting 19
3
Propeller A
Power Switch
Propeller B
Left Protection
Ring
Propeller B
Propeller A
Camera
Drone Battery
Front LED
(Green)
Front LED
(Green)
Drone Bottom
Housing
Rear LED
(Red)
Rear LED
(Red)
Right Protection
Ring
Drone Cover
Housing
Instruction For Drone And Controller
Drone
Left
Right
Front
Rear
Specifications
Drone Size
Drone Weight
Propeller Diameter
267x245x59mm
147g
113mm Streaming Video Range/Radius About 30m
About 50m
160~180 mins
Flying Time 8~10 mins
Drone Battery 3.7V 1000mAh
Flying Height About 15m
Charging Time for Drone Battery
Flying Distance/Radius
4
19
18
19
18
09
26
08
25
07
05
03
02
01
090807
01
07
23
24
08
12
22
05
06
05
03
10
01
21
20
19
18
19
18
16 15
08
14
13
07
12
05
11
06
05
03
10
05
06
05
04
03
02
01
06
28
17
27
Exploded View
5
No. Name No. Name
1 Propeller plug
17
2 A Propeller
18
Drone bottom Housing
3 Rotary gear
19
Landing gear lampshade
4Right rear light board
(red light/white plug)
20
Shock proof tape5 Copper cup
21
6 Motor frame
22
Lens press B
7 Main shaft steel pipe
23
lens organic plate
8 Steel pipe fixer
24
Power button
9 Propeller A motor
25
Left rear light board(red light/red plug)
10 B Propeller
Right front light board
(green light/red plug) 26
Drone cover Housing
11
Propeller B motor 27
Left front light board(green light/white plug)
28
Battery cover
Left protection ring
Right protection ring
12
Dash receiver13
Receiving plate holder14
Camera plate15
Battery adapter plate16
Controller
Power Indicator
Phone Holder Slot
Throttle Stick Direction Stick
Headless Mode
One Button Take
Off / Landing/
Emergency Stop
Button
Power Switch
Photo
Video
Notice: Taking photo and recording video are available after connecting with
smart phone.
6
Controller Button Functions
Battery Installation
Open the battery cover on the back side of the controller, insert 4 AA batteries
by following the polarity indicators. ( Picture 1/2, battery is not included)
1.Make sure the electrodes are correct. 3.Do not mix different kinds of batteries.
2.Do not mix up the new batteries with
old ones.
4.Do not charge the non rechargeable
battery.
Notice:
High/Medium/Low Speed
Mode (Press Down)
Trimmer Mode Button
(Press Down)
Alkaline Battery
Picture 1 Picture 2
Battery Cover
High / Medium / Low Speed button:
Left Stick:
Right Stick:
Power Switch:
Press to right switch to High /Medium/ Low Speed.
Move the Stick to forward / backward / left / right to fly the drone up / down / turn left / turn right.
Move the Stick to forward / backward / left / right to fly the drone forward / backward / left / right.
Trimmer Mode Button:
Press down the left stick and turn to the required trimmer direction,
then it will adjust the direction accordingly. Release the stick to exit trimmer mode.
Press the power switch to turn on the controller, and press again to turn off.
Heading Hold Mode:
Press to enter Heading Hold Mode. Press again to exit Heading Hold Mode.
Take Off / Landing / Emergency Stop Button:
automatically. Press again and the drone will land automatically. Press and hold the button for
more than 1 second for an emergency landing, the drone propellers will stop and it will land
immediately.
Press once and the drone will take off
Video:
Press down the button, start to record video.
Photo:
Press down the button, start to photograph.
7
Drone Battery
Phone Installation Instruction
Li-Po Battery Disposal & Recycling
Wasted Lithium-Polymer batteries must not be placed with household
trash. Please contact local environmental or waste agency or the
supplier of your model or your nearest Li-Po battery recycling center.
Charging Instruction for Drone Battery
Parts installation
* For faster charging, it is recommended to use an adapter with 5V 2A output current
(not included) to charge the battery
Notice：Make sure that the button on phone is not clamped.
Power BankPhone Charger Computer Charging Car Charger
1. Connect the drone battery with USB cable first and then choose one of the
methods as below picture shown to connect with USB plug.
2. The red indicator will be on while charging and the light will turn green when
the battery is fully charged.
Picture 3 Picture 4 Picture 5 Picture 6
1. Take out the phone holder and insert into the controller(Picture 3).
3. When take out the phone clip, you need to press the clip buckle behind the phone
clip at the same time, so that the buckle can be closed and removed easily.
2. Unfold the phone holder ( Picture 4/5), put the phone into the holder,
then release the clamp, and the phone will be fixed on the holder( Picture 6).
8
Aim at the
hole position
Propeller installation diagram
When installing, put the propeller hole aims to the drone shaft hole, and then press
down until bottom, tighten it with screw, and then put on propeller cover( Pic 8);
when disassembling, loose the screw and then pull out the propeller.
Notice: When installing, please make sure correct propeller in its right place,
otherwise the drone can not work well.
Picture 9
Picture 10
Picture 8
Warning: When pick up the motor, please don’t damage the LED board.
Motors Replacement Diagram
1. To remove the motor, remove the screw from the lampshade first，then take
the lampshade out, unplug the motor connector from LED board and then take
the defective motor out ( Picture 9) .
2. To install the motor, put the motor into motor holder( make sure the motor
press down and also the gears are pairing) and plug the required motor
connector into the LED board socket. Put on the motor cover and fix it with screw.
Notice: The rotation direction of the motor should be the same, or it will not work.
Tips: The motor is consumable. If it was damaged, please buy a new motor for
replacement.
After plugging in the connector, sort out
the wires according to the arrow, and
make sure the motor wires keep away
from the middle shaft.
9
When loading, aim the buckle 1 of the protection ring at the position 1 on the
bracket and push it to the bottom (Picture 11),then aim the protective ring clasp 2
at the position 2 on the bracket and press down to the right position(Picture 12).
When unloading, first pull up position 2, then pull out position 1 outwards(Picture)
Picture 11 Picture 12
Picture 13
Button Placement 1
Buckle 1
Push Here
Button Placement 2
Button Placement 2
Buckle 2Buckle 2
Diagram of loading and unloading of protective frame
When installing, push the battery to the end(Picture 14);
When disassembling,you need to squeeze up and down of the battery buckle and
just take out the battery box.
Battery installation diagram
Picture 14 Picture 15
Sticker face up
Battery buckle
Button Placement 2 Button Placement 1
Pull Outward
Force Bearing Point
10
Front
Rear
Positive / Negative wire pad
+-
Camera board socket
Pre-Flight Checklist
1. Ensure that the drone battery and controller batteries are fully charged.
2. Ensure that the left stick of the controller is in the middle position.
3. Strictly follow the instructions in sequence for turning on and turning off the
controller and drone. Turn on the controller power first and then turn on the
drone power before flying; Turn off the drone power first and then turn off the
controller power when fishing flying. Improper on/off sequence may cause the
drone to fly out of control and could threaten your safety or the safety of
others.
Please cultivate a correct habit of tturning on and turning off.
4. Ensure the connection between the battery and motor is solid. Vibration during
use may cause a bad connection and the drone could become difficult to
control.
5. Improper operation may cause the drone to crash, which may cause motor
defects affecting flying ability. If this occurs, go to the local distributor to buy
new replacement parts,so that the drone will be resorted to it's optimum status.
Receiver board wire diagram
Table of contents
Other Potensic Drone manuals
Potensic
Potensic Dreamer Pro User manual
Potensic
Potensic P7 User manual
Potensic
Potensic T25 User manual
Potensic
Potensic ATOM SE User manual
Potensic
Potensic ATOM SE User manual
Potensic
Potensic F186 DH User manual
Potensic
Potensic Dreamer Mini User manual
Potensic
Potensic D88 User manual
Potensic
Potensic D58 User manual
Potensic
Potensic Dreamer 1 User manual
