INSERTING PAPER
SWITCHING PRINTER ON AND OFF
Open the paper compartment by slightly lifting the
unlocking lever on the paper compartment cover.
Unwind a little paper from the roll so about one inch
protrudes from the paper compartment. Ensure the
paper layers remain tightly wrapped around the roll core.
Place the paper roll in the compartment as shown. Close
the cover by pressing down and it will snap into place.
Note: Use only original labels, available from
Plusoptix or an authorized dealer.
They can be ordered by contacting us or by
visiting plusoptix.com, click the “Support”
dropdown and fill out the “Reordering
labels” form.
VISIT: PLUSOPTIX.COM Version 02/08/2019CALL: +49 - 911 - 59 83 99 - 10
plusoptix.com
For further information concerning Plusoptix products,
references, and studies, please visit our website.
SPECIFICATIONS
After each measurement with the Plusoptix device, any
number of labels for documenting the measurement
results can be printed out. Please note, once you return
to the home screen with the “plusoptiX 12R”, the label
can no longer be printed. In the “plusoptiX 12C” and
“plusoptiX 16”, the label can be printed again after
retrieving it from the database.
Align the Plusoptix device with the IR receiver of the
printer. The distance between device and the printer
should be approximately 1 m (3.3 ft). As soon as you
touch the printer symbol on the screen of the Plusoptix
device, the data is transmitted and a label is printed out.
To confirm the transmission, a blue control lamp lights
up on the IR receiver. Keep the device directed at the
printer until the blue control lamp turns off.
Attention: If the IR transmission is interrupted
while printing, the print-out of the label is
incomplete. To obtain a complete print-out,
simply print the label again.
PRINTING
To switch ON, briefly press the ON button. The printer
starts immediately and is ready for operation as soon
as the status lamp flashes green.
The printer will switch OFF automatically after 10
minutes of non-use. To switch it OFF manually, keep
the OFF button depressed for 3 seconds.
Attention: Use Bacillol 30 tissues, Clorox Healthcare
wipes or Teccare Control tissues to clean the surface
of your Plusoptix device. They are approved to
clean our devices.
CLEANING
If the print quality deteriorates, it is necessary to clean the
printing head, paper sensor, tear-off edge and drive roller.
Open the cover of the paper compartment and remove
the paper roll.
If paper dust has accumulated in the paper compartment,
clean it out with a vacuum cleaner with a fitted brush or
with compressed air.
Clean the paper sensor, printing head and the drive roller
with a fitted brush or compressed air.
Storage
Operation
Dimensions
Power supply
(GSM36P12-P1J)
Rechargeable
batteries
(Panasonic BK –
3MCCE 1,2V)
Temperature
Temperature
Dimensions
Input
Type / Size
0 to + 50°C
+ 10 to + 50°C
159.6 x 89.6 x 45.6 mm
(6.28 x 3.53 x 1.8 in)
110 to 240 V AC
(50 to 60 Hz), 0.8 A
Nickel Metal Hydride
NiMH/AA HR6
Humidity
Humidity
Weight
Output
Power / Quantity
10 to 80%
non-condensing
20 to 80%
non-condensing
0.35 kg
(12.35 oz)
12 V DC, 2.5A
1900 m Ah/4 each
INTERFACE IR RECEIVER
Self-adhesive label in actual size 2.91 x 1.92 in (74 x 49 mm)
3 sec
PAPER SENSOR
TEAR-OFF EDGE
PRINTING HEAD
DRIVE ROLLER
