Plantronics Savi 700 Series User manual
Savi®W710/W720
Multi Device Wireless Headset System
User Guide
Contents
Welcome 4
System Requirements 4
What's in the Box 5
Base and Headset Basics 6
Accessories 7
Customize Your Headset 8
Adjust the Headband 8
Adjust the Mouthpiece 8
Charge Your Headset 10
Desk Phone: Connect and Call 11
Choose Desk Phone Setup 11
Make a Desk Phone Call 12
Mobile: Connect and Call 13
Computer: Connect and Call 14
Connect Your Computer 14
Place a Softphone Call 14
Position Your Base 14
Headset Features 15
Headset Controls 15
Headset Power 15
Headset Battery Level 16
Mute your Headset During a Call 16
Adjust Your Headset Volume 16
Turn On/Off Headset LED 17
Out of Range Warning Tones 17
Base Features 18
Base Buttons 18
Base Subscription Button 18
Set the Range 19
Bluetooth Pairing Button 19
Daily Use 21
Incoming Calls 21
Outgoing Calls 21
Multi-Phone Status 23
Mobile Phone and Headset Audio 23
Combine Audio From Any Two Lines or Channels 23
Conference Up to Three Additional Headsets 23
Advanced Use 25
Install Plantronics Software 25
Plantronics Control panel 25
Devices Tab 25
Device Settings > Base Tab 26
Device Settings > Headset Tab 28
Device Settings > Security Tab 30
Applications Tab 30
Preferences 30
2
About Tab 31
Plantronics Update Manager 31
Troubleshooting 33
Headset 33
Desk Phone 34
Mobile 34
Softphone 34
3
Congratulations on purchasing your new Plantronics product. This guide contains instructions
for setting up and using your Savi W710/W720 Wireless Headset System which has a WO2
base and a WH300/WH350 headset.
Please refer to the separate safety instructions for important product safety information prior
to installation or use of the product.
Computer
• Supported Operating Systems: Windows XP®, Windows Vista®, Windows®7
• Processor: 400 MHz Pentium®processor or equivalent (Minimum); 1 GHz Pentium processor
or equivalent (Recommended)
• RAM: 96 MB (Minimum); 256 MB (Recommended)
• Hard Disk: 280 MB (Minimum); 500 MB or more (Recommended)
• Microsoft Windows XP-Service Pack 3 (SP3) or later (Recommended) Microsoft Windows Vista-
Service Pack 1 (SP1) or later (Recommended)
Display
• At least 800 x 600, 256 colors
• 1024 x 768 high color, 32-bit (Recommended)
Browser
• Internet Explorer®V6 or better must be on the user’s system (Required)
Welcome
System Requirements
4
WH300 headset (monaural) WH350 headset (binaural)
Base and charge cradle
USB cable Telephone interface cable Power supply
What's in the Box
5
Base
1Power jack 8Computer button
2Handset lIfter jack 9Mobile phone button
3Telephone interface cable jack 10 Desk phone button
4USB port 11 Bluetooth pairing button/LED
5Desk phone speaking volume 12 Subscription button/LED
6Desk phone configuration switch 13 Charging LED
7Desk phone listening volume
Headset
1Headset LED 4Mute button
2Volume up button 5Volume down button
3Call control button 6Microphone
Base and Headset Basics
6
1Electronic hookswitch cable (EHS cable) Electronically and automatically takes your desk
phone handset off hook. Enables remote call control with your headset.
2HL10 lifter Automatically lifts handset and returns it to the cradle. Enables remote call
control with your headset.
Accessories
7
Optimize the comfort and fit of your headset.
1To adjust the headband, lengthen or shorten the band until it fits comfortably. Position the
headset receivers so that the foam cushions sit comfortably over the center of your ears.
2On the WH300, position the stabilizer T-bar above your ear.
3For a tighter fit, gently pull the opposite ends of the headset inward as shown.
1Carefully bend and shape the boom with both hands as shown. Avoid bending or twisting the
boom near the microphone or earpiece.
2Position the click-stop turret and boom so that the microphone is two finger-widths from the
corner of your mouth.
Customize Your Headset
Adjust the Headband
Adjust the Mouthpiece
8
3Make sure the front of the microphone faces your mouth. If necessary, twist the microphone
slightly so it’s in the proper position. Do not use forceful twisting motions or try to turn the
microphone completely around.
9
1Align the charging cradle pins with the base and press firmly until the cradle rests evenly on the
base.
2Plug one end of power supply into power jack on back of the base and other end into working
power outlet.
3Place the headset in the charge cradle. The charging LED will flash green when charging the
headset and turn solid green when the headset is fully charged. Charge for at least 20 minutes
prior to the first use. A full charge takes 3 hours.
NOTE This product has a replaceable battery. Use only the battery type supplied by Plantronics.
Charge Your Headset
10
Other manuals for Savi 700 Series
1
This manual suits for next models
2
Table of contents
Other Plantronics Headset manuals
Plantronics
Plantronics CS70 Series User manual
Plantronics
Plantronics Savi W440-M User manual
Plantronics
Plantronics EXPLORER 300 User manual
Plantronics
Plantronics Savi 440 User manual
Plantronics
Plantronics MX150PC User manual
Plantronics
Plantronics Explorer 100 Series User manual
Plantronics
Plantronics Blackwire C320 User manual
Plantronics
Plantronics MX200 User manual
Plantronics
Plantronics VOYAGER 510-USB User manual
Plantronics
Plantronics Voyager Edge Series User manual
Plantronics
Plantronics ENCORE H91 User manual
Plantronics
Plantronics DuoSet H141 User manual
Plantronics
Plantronics Savi Office WO200 User manual
Plantronics
Plantronics T10 User manual
Plantronics
Plantronics CS70N Use and maintenance manual
Plantronics
Plantronics EXPLORER 230 User manual
Plantronics
Plantronics C565 User manual
Plantronics
Plantronics EncorePro HW530 User manual
Plantronics
Plantronics Audio 310 USB Reference guide
Plantronics
Plantronics SAVI W440 - SAFETY BOOKLET User manual
