6WM60 / WM70
WM70 TRANSMITTER
Front Panel
1. Left and Right Sig/Clip Indicators
–the LED indicator will light up green
when a signal is being received by
the WM70 transmitter. It will change
to red when the signal level becomes
excessive, just 4dB before clipping.
2. Trim Control – these controls adjust
the level of the signal received via
the Combo inputs on the rear that will
be sent wirelessly.
3. Channel Selector – adjusting this
dial to one of the preset channels
allows the WM70 to know which
frequency to send the wireless in-
formation at. Each preset channel
will transmit both the left and right
signals, so that the WM40-L (or
WM400-L, WM400D-L) and WM40-
R (or WM400-R, WM400D-R) wire-
less receivers (if set to the identical
channel) will receive the signal suc-
cessfully.
4. Stereo/Mono Selector – This will
allow users to change the wireless
signal sent from the WM70 to be al-
ternated between a mono and stereo
signal.
5. On/Off Button – this button turns the
WM70 on and off. An LED will illumi-
nate under this button when it is on.
Rear Panel
6. Left and Right Combo Input – this
jack accepts both balanced and un-
balanced 1/4” and XLR inputs from
line-level sources (such as the main
output of a mixer).
7. Left and Right Antennas – this for
the insertion of the WM70’s left and
right antennas. Insert the antennas
and adjust them to sit in a vertical
position when the device is in use.
Screw the antenna in to lock it into
place.
8. DC In – plug DC end of the supplied
DC power adaptor into this jack, and
the other end into a suitable AC pow-
er source to allow the WM70 to be
powered.
For more information on using the WM wireless systems, please consult the WM-SYS1, 2, 3 or 4 manuals.
