Phonak CROS II User manual

Phonak CROS II

March 2015

Desktop Fitting Guide

This guide provides you with a detailed introduction to fitting a Phonak CROS II system in Phonak Target 4.1 and later. or fitting of the

hearing instruments, please see the Hearing Instruments Desktop itting Guide.

Preparation of the hearing instruments

For the fitting of CROS II it is recommended to use iCube II as it enables faster fine tuning and instant demonstration of CROS II.

iCube II

No cables to the hearing instrument or CROS II are needed. Insert

the battery before placing the device on the ear. Turn on the

devices by closing the battery compartment.

NO Hlink or HI-PRO

Connect the programing cables to the hearing instruments and the

fitting device. CROS II is not active with the fittng cables

connected.

Connect the instruments

Click [Connect] to start the fitting. The connected devices will appear next to the

fitting device in the dashboard.

The audiogram data from NOAH will be automatically imported into Phonak Target

and taken into account for the pre-calculation.

Confirm that the correct fitting device is shown. To change the

fitting device, use the pull down arrow next to the fitting device

in the dashboard.

Basic tuning

After the connection, fit the hearing instrument as in a monaural fitting. After the

successful fitting, go to the [Basic tuning] screen to adjust the loudness ratio

between CROS II and the hearing instrument.

For a BiCROS fitting, run the feedback test.

The hearing instrument on the better ear can be adjusted in the same way as in a

standard fitting.

Phonak Target™ 2

Device options

Click [Device options] to adjust the individual settings for the CROS volume / volume and program change (depending on the user

controls available).

or CROS II, the volume of the CROS signal can be adjusted separately, if desired.

Finishing the fitting session

You can close the session at any time by clicking [Save & close session] in the top right corner of the screen. The save dialog will confirm

the successful save of the CROS II fitting. After the save, Phonak Target will guide you to the start screen.

The wireless connection between the CROS II transmitter and hearing aid starts automatically once both instruments have been

disconnected from the fitting device and turned on.

Important: When streaming from the accessories, the CROS II streaming will be automatically disconnected. Reconnection will

also be automatic when you stop streaming of the accessory.

CROS II fitting in Junior Mode

Important: CROS II is not recommended for 0-3 years.

In Junior Mode 4-8 years, the default program setup is Roger/DAI + M (Startup program) and Speech in Noise (2

program) with the push

button disabled.

To access CROS II, go to

[

Fine tuning] 

[

Program manager] and set the

position of Calm Situation to the second position and remove the Speech in Noise

program from the program sequence.

Go to [Device options]  [Push button], enable the [SHOR PRESS] to Program

change.

Once saved and disconnected, toggle to the Calm Situation program to connect

CROS II. The Connect beeps will be heard.

In Junior Modes 9-12 and 13-18, the Startup program is Roger/DAI + M and the push button is enabled by default. AutoSense OS is

available via the push button as an additional program. To access CROS II, toggle to AutoSense OS.

Manufacturer:

Phonak AG

Laubisrütistrasse 28

CH-8712 Stäfa

Switzerland

CE mark applied 2015

Other Phonak Hearing Aid manuals

Phonak

Phonak Solo T+ User manual

Phonak

Phonak MSF0001 MicroField User manual

Phonak

Phonak iCube II User manual

Phonak

Phonak ComPilot User manual

Phonak

Phonak Audeo P-R Series User manual

Phonak

Phonak Audeo P-312T User manual

Phonak

Phonak Una CIC/MC User manual

Phonak

Phonak Roger Pen Assembly instructions

Phonak

Phonak ComPilot User manual

Phonak

Phonak Lyric User manual

Phonak

Phonak Nathos User manual

Phonak

Phonak Naida Link M User manual

Phonak

Phonak ComPilot User manual

Phonak

Phonak LYRIC3 User manual

Phonak

Phonak Audeo M-312T Trial User manual

Phonak

Phonak Roger Focus Instruction Manual

Phonak

Phonak Lyric User manual

Phonak

Phonak CROS P-13 User manual

Phonak

Phonak Naida CI Connect User manual

Phonak

Phonak Ambra User manual

Phonak

Phonak B90 User manual

Phonak

Phonak Audeo P-R Fit User manual

Phonak

Phonak roger User manual

Phonak

Phonak Baseo Q15 User manual

Popular Hearing Aid manuals by other brands

Sonic

Sonic Bliss miniBTE user guide

Lexie

Lexie B1 Replacement guide

Widex

Widex FM+DEX User instructions

Siemens

Siemens Triano user guide

Camplicomms

Camplicomms HC-200 user guide

Widex

Widex SUPER 220 S2-VSD user manual

Williams Sound

Williams Sound SoundPlus WIR 237 Manual and user guide

Oticon Medical

Oticon Medical Ponto SoundConnector Instructions for use

Siemens

Siemens Life micon user guide

Starkey

Starkey Destiny Operation manual

Audicus

Audicus The Icon instruction manual

Advanced Bionics

Advanced Bionics Slim HP Standard Instructions for use

Widex

Widex DREAM440 THE DREAM SERIES User instructions

NIKEN

NIKEN NK-401 instruction manual

ON Semiconductor

ON Semiconductor Ezairo 7111 Pre Suite Getting started guide

Sonetik

Sonetik GOHEAR user guide

Widex

Widex FL-9 User instructions

Siemens

Siemens MUSIC Pro Pro IT user guide