Philips FC9108 User manual
R
e
a
c
h
&
C
l
e
a
n
T
M
R
e
a
c
h
&
C
l
e
a
n
T
M
13cm
Specialist
Specialist
FC9108
2
3
12
3
4
25
10
97
8
6
24
11
13
12
14
26
22
23
20
21
21
5
16
15
17 18 19
4
ENGLISH 6
15
5
FC9108
Important
◗Only use Philips s-bag`double-layer paper dustbags (type
FC8021).
◗Check if the dustbag has been placed correctly.
◗Never use the vacuum cleaner to suck up water or any other
liquid. Never suck up ashes until they are cold.
◗When the vacuum cleaner is used to suck up fine dust, the pores
of the dustbag may become clogged, causing the passage of air
through the dustbag to become obstructed.As a result, the
dustbag-full indicator will indicate that the dustbag needs to be
replaced, even though the dustbag is not full at all.
◗Never use the appliance without the Motor Protection Filter.This
could damage the motor and shorten the life of the appliance.
General description
1 On/Off button
2 Cordwinder button
3 Opening dustcover
4 Clean comfort cassette
5 Hinging handle
6 Opening filtercover
7 Swivel opening
8 Front grip
9 Dustbag full indicator
10 Power Slide
11 Rearwheels
12 Castor wheel
13 Park position
14 Storage position
15 Accessory bridge
16 Small nozzle
17 Crevice tool
18 Small brush
19 Button coupling
20 Reach & Clean nozzle
21 Brush indications
22 Turning switch mechanism hard/soft floors
23 Parking ridge
24 Plug
25 Triple motor inlet filter
26 Type plate
ENGLISH6
Connecting accessories
Hose
C1To connect the hose, push it firmly into the appliance (you will
hear a click).
C2To disconnect the hose, push the buttons on the swivel and
pull the hose out of the appliance.
Tube
Button coupling
C◗Connect the tube to the handgrip by pressing the spring-loaded
lock button on the handgrip and inserting the handgrip into the
tube. Fit the spring-loaded lock button into the opening in the
tube ("click").
C◗To disconnect the tube from the handgrip, press the spring-loaded
lock button and pull the handgrip out of the tube.
◗Use the same method to connect and disconnect the other
accessories.
ENGLISH 7
Telescopic tube
1Connect the tube to the handgrip ("click").
C2Adjust the tube to the length you find most comfortable during
vacuum cleaning.
Reach & Clean nozzle
C◗The Reach & Clean nozzle can be used on either carpets or hard
floors.The nozzle can be put in 4 different positions, allowing you
to also vacuum clean hard-to-reach places in an easy way.The
nozzle can be turned 360 degrees clockwise as well as anti-
clockwise.
C◗To adjust the nozzle to the type of floor and the area to be
cleaned, put your foot on the indicated positions and then turn
the tube until the nozzle is in the required position.
C1With the nozzle positioned breadthwise and the brush strip
folded out, you can clean large hard floor areas.Turn the nozzle
until the brush strip pops out of the nozzle housing and the
nozzle is positioned breadthwise.
C2With the nozzle positioned lengthwise and the brush strip
folded out, you can vacuum clean small hard floor areas.Turn
the nozzle 90 degrees clockwise until it is positioned
lengthwise with the brush strip still folded out of the nozzle
housing.
ENGLISH8
C3With the nozzle positioned breadthwise and the brush strip
folded in, you can vacuum clean large soft floor areas.Turn the
nozzle 90 degrees clockwise again to position the nozzle
breadthwise and to make the brush strip disappear into the
nozzle housing.
C4With the nozzle positioned lengthwise and the brush strip
folded in, you can vacuum clean small soft floor areas.Turn the
nozzle 90 degrees clockwise again until it is positioned
lengthwise with the brush strip still folded in.
Crevice tool, small nozzle and small brush
C1Connect the crevice tool, the small nozzle or the small brush
directly to the handgrip or to the tube.
Accessory holder
C1The accessory holder can simply be snapped onto the
handgrip.
◗There are two ways to store accessories in the accessory holder.
C◗The crevice tool and small nozzle can be stored in the accessory
holder by pushing them into the holder.To detach them, pull them
out of the holder.
ENGLISH 9
C◗Please be aware of the way in which the small nozzle must be
placed in the accessory holder.
C◗Instead of the small nozzle, the small brush can be stored in the
accessory holder by pushing it into the holder.To detach it, pull it
out of the holder.
Vacuum cleaning
C1Pull the cord out of the appliance and put the mains plug in the
wall socket.
C2Switch the appliance on by pushing the on/off button on top of
the appliance with your foot.
C3To carry the appliance, put the handle in upright position and
lift the appliance by the handle.
ENGLISH10
Other manuals for FC9108
1
Table of contents
Other Philips Vacuum Cleaner manuals
Philips
Philips SmartPro FC8794/01 User manual
Philips
Philips FC9306/02 User manual
Philips
Philips FC8336/01 User manual
Philips
Philips FC8524/09 User manual
Philips
Philips SpeedPro Max Aqua FC6903 User manual
Philips
Philips FC6901/01 User manual
Philips
Philips MiniVac FC6132 User manual
Philips
Philips HR8353 User manual
Philips
Philips FC8768 User manual
Philips
Philips 2000 series User manual
Philips
Philips Performer Active FC8653/01 User manual
Philips
Philips FC6149 User manual
Philips
Philips FC8802/01 User manual
Philips
Philips MiniVac FC6048/01 User manual
Philips
Philips FC8443 User manual
Philips
Philips FC8229/61 User manual
Philips
Philips FC9571 User manual
Philips
Philips FC8957 User manual
Philips
Philips Impact-plus FC 8388 User manual
Philips
Philips XD3030 Manual
