Philips FC6094 User manual

FC6094, FC6092, FC6090

ENGLISH 6

 14

 23

 31

 39

 47

 55

 64

 71

 79

 87

 95

 104

 112

 120

 128

General description (Fig. 1)

ABendable crevice tool (FC6092/6090)

BFloor nozzle (FC6094 only)

CCleaning brush

DCrevice tool

EBrush tool

FSocket for car cord (FC6092 only)

GContact points

HConnection for telescopic stick (FC6094 only)

ICharging light with battery-low indication

JExhaust air openings

KOn/off slide

LDust compartment release button

MMotor inlet grille

NFilter holder

O Innerlter

P Outerlter

QDust compartment

RNozzle release button

SNozzle insert

TDetachable nozzle

UNozzle & stick holder (FC6094 only)

VWall mounting bracket

WW. Charging base

XAdapter

YCar cord with car plug (FC6092 only)

ZTelescopic stick (FC6094 only)

Important

Read these instructions for use carefully before using the appliance and

save them for future reference.

Check if the voltage indicated on the appliance corresponds to the

local mains voltage before you connect the appliance.

Do not use the appliance if it is damaged in any way.Take it to an

authorised Philips service centre for repair.

ENGLISH

If the adapter or charging base is damaged, always have it replaced

by one of the original type to avoid a hazard.

FC6092 only: if the car cord or car plug is damaged, stop using the

car cord and have it replaced by one of the original type.

Never suck up water or any other liquid. Never suck up ashes until

they are cold.

Never immerse the vacuum cleaner, the adapter or the charging

base in water.

Remove the adapter from the wall socket before cleaning the

charging base.

Only charge the vacuum cleaner with the adapter and charging

base supplied. During charging, the adapter will feel warm to the

touch.This is normal.

Always switch the vacuum cleaner off after use.

Keep the appliance out of the reach of children.

The voltage on the contact points in the charging base is low (max.

30 volts) and therefore not dangerous.

Never block the exhaust air openings during vacuuming.

Switch the appliance off when recharging it.

To avoid the risk of electric shock, be careful when drilling holes in

the wall to attach the wall mounting bracket, especially close to a

wall socket.

Always use the appliance with the lter unit.

Always use the appliance with the nozzle insert in place.

Noise levels:

FC6090: Lc = 78 dB [A]

FC6092: Lc = 79 dB [A]

FC6094: Lc = 80 dB [A]

Preparing for use



1 Screw the wall mounting bracket to the wall with the screws

supplied with the appliance. (Fig. 2)

2 Attach the charging base to the wall mounting bracket. (Fig. 3)

ENGLISH 7

3 Attach the nozzle & stick holder to the wall mounting bracket

(FC6094 only).

4 Screw the nozzle & stick holder to the wall with the screws

supplied with the appliance.

5 You can also place the charging base on a level and horizontal

surface. (Fig. 4)

6 Slide the brush tool onto the crevice tool and place them in the

charging base. (Fig. 5)

7 FC6094 only: insert the telescopic stick and the oor nozzle into

the nozzle & stick holder (‘click’). (Fig. 6)



Chargetheapplianceforatleast18hoursbeforeyouuseitfortherst

time.

When the charging light starts blinking during operation, the battery pack

is running low and needs to be recharged.

1 Insert the small plug into the charging base and insert the adapter

into the wall socket. (Fig. 7)

The charging light will go on to indicate that the appliance is

charging. (Fig. 8)

Note:The charging light will stay on as long as the appliance is placed on the

charging base and the adapter is in the wall socket.

Note:The charging light does not give any information about the charge level

of the built-in battery pack.



1 Push the on/off slide forwards to switch the appliance on. (Fig. 9)

2 Push the on/off slide backwards to switch the appliance off.

(Fig. 10)

ENGLISH8

3 Leave the adapter in the wall socket and always put the vacuum

cleaner back onto the charging base after use, even if the battery

pack is still almost fully charged.





This appliance comes with the following tools:

1. brush tool for cleaning delicate surfaces

2. crevice tool for cleaning hard-to-reach places

3. bendable crevice tool for cleaning at an angle (FC6092/6090 only)

1 Take the tool you want to use.

2 Attach the tool to the detachable nozzle. (Fig. 11)

Car cord (FC6092 only)

With the car cord you can connect the vacuum cleaner to the cigarette

lighter socket in your car and use it as long as necessary without having to

recharge it.

1 Insert the small plug of the car cord in the socket of the appliance

and insert the car plug in the cigarette lighter socket of your car.

(Fig. 12)

The car cord cannot be used to charge the appliance.

2 Detach the car cord from the appliance by pressing the button on

the small plug.

To prevent damage, do not pull the small plug out of the appliance

without pressing the button.



1 Attach the telescopic stick by pushing it rmly into the back of the

appliance until it locks into position (‘click’). (Fig. 13)

Thetelescopicstickgivesyouextrareachwhencleaninghardoors,

carpets and hard-to-reach areas.

2 Then attach the oor nozzle to the detachable nozzle. (Fig. 14)

Theoornozzlecanbeusedtovacuumhardoorsandcarpets.

ENGLISH 9

Theoornozzleisequippedwithauffcollectorthatremoveshairor

uff.

Note:Pass the uff collector gently over the hairs or uff to be removed. The

hairs or uff will be worked loose from the surface, collected and then sucked

up.

3 Adjust the stick to the length you nd most comfortable during

vacuum cleaning by pushing the ring downwards and pulling the

upper part of the stick upwards. (Fig. 15)

4 To detach the telescopic stick, press the release button on the

back of the vacuum cleaner and pull the stick out of the appliance.

(Fig. 16)

Cleaning

Always remove the adapter from the wall socket before cleaning the

charging base.

Never immerse the vacuum cleaner, the adapter or the charging base in

water.

1 Clean the charging base and the appliance with a damp cloth.



Makesureyouemptythedustcompartmentandcleanthelters

regularly.

Weadviseyoutocleantheltersevery2to4weekstomaintainoptimal

suction performance.

Quick cleaning

Toquicklyemptythedustcompartment:

1 Remove the detachable nozzle by pressing the nozzle release

button. (Fig. 17)

2 Shake the contents of the dust compartment out into a dustbin.

(Fig. 18)

ENGLISH10

Other manuals for FC6094

This manual suits for next models

Table of contents

Languages:

Other Philips Vacuum Cleaner manuals

Popular Vacuum Cleaner manuals by other brands

Bissell

Bissell LittleGreen Proheat 1425 Series user guide

Panasonic

Panasonic MC-YL637S147-AE Service manual

NEFF

NEFF N17XH10 0 Series instruction manual

LG A9 Series owner's manual

Oreck

Oreck Cordless Captura BK51700 Series user guide

Kogan

Kogan KAVACROBVWA user manual

Kränzle

Kränzle VENTOS 50 ID Use and maintenance

EVVO

EVVO Ai35 instruction manual

DeWalt

DeWalt DWH200D instruction manual

Pontec

Pontec Pondomatic Vacuum Cleaner operating instructions

Cleanmaxx

Cleanmaxx PC-P007E instruction manual

Exido

Exido 240-114 manual

RIDGID

RIDGID WD1685AU0 owner's manual

Ezviz

Ezviz RE4P manual

STG global

STG global TANVAC HDV3000 Operator's manual

Shark

Shark ROTATOR PRO COMPLETE NV550 Series manual

Factory

Factory M3340 operating manual

Shop-Vac

Shop-Vac VN92 SERIES user manual