Philips HP 4494 User manual

HP 4490/94/96

English Page 6

• Keep pages 4, 5, 50 and 51 open when reading these operating instructions.

Français Page 10

• Pour le mode d'emploi: dépliez les pages 4, 5, 50 et 51.

Deutsch Seite 13

• Schlagen Sie beim Lesen der Gebrauchsanweisung

Seiten 4, 5, 50 und 51 auf.

Nederlands Pagina 16

• Sla bij het lezen van de gebruiksaanwijzing de pagina's 4, 5, 50 en 51 op.

Italiano Pagina 19

• Prima di usare l'apparecchio, aprite le pagine 4, 5, 50 e 51

e leggeteattentamente le istruzioni per l'uso.

Español Página 22

• Desplegar las páginas 4, 5, 50 y 51 al leer las instrucciones de manejo.

Português Página 25

• Durante a leitura do modo de emprêgo, desdobre e

verifique as pág. 4, 5, 50 e 51.

Dansk Side 28

• Hold side 4, 5, 50 og 51 opslået mens De læser brugsanvisningen.

Norsk Side 31

• Slå opp på side 4, 5, 50 og 51 før De leser videre.

Svenska Sid 34

• Ha sidan 4, 5, 50 och 51 utvikt när ni läser bruksanvisningen.

Suomi Sivu 37

• Pidä sivut 4, 5, 50 ja 51 auki samalla kun luet käyttöohjetta.

Türkçe Sayfa 40

•Kullanım kılavuzunu okuduπunuzda 3., 4., 50. ve 51. sayfaları açınız.

Fitting a plug

Connections - Applicable to U.K. only

Important

The wires in this mains lead are coloured in accordance with the

following code: BLUE - NEUTRAL

BROWN - LIVE

As the colours of the wires in the mains lead of this appliance may not

correspond with the markings identifying the terminals in your plug,

proceed as follows:

The wire which is coloured BLUE must be connected to the terminal

which is marked with a letter "N" or coloured BLACK.

The wire which is coloured BROWN must be connected to the

terminal which is marked with the letter "L" or coloured RED.

DO NOT CONNECT either of these wires to the earth terminal in the

plug which is marked with the letter “E” or by the earth symbol E or

coloured GREEN, or GREEN AND YELLOW.

Note: If the terminals of the plug are unmarked or if you are in

any doubt consult a qualified electrician.

If a 13 Amp. 3-pin plug is fitted, it must be an "approved" plug,

conforming to BS 1363-1986.

General description (fig. 1)

AHandle

B"On"-light

CClamping ring

DConnect point

EContact pins

FHeel rest (turn backwards before use)

GClip

HStyling attachment "Spirals" (for corkscrew curls) (HP 4494/96)

IStyling attachment "Zig Zags" (for Z-shaped curls) (HP 4494/96)

JStyling attachment "Crimper/Straightener" (HP 4496)

KInset plates for "Crimper/Straightener" (HP 4496):

"Crimping plate" (ribbed side: for waves)

"Straightener" (flat side: for straight hair)

LStyling attachment "Curls" (for evenly rounded curls) (HP 4494/96)

MStyling attachment "Brush" (for brushing/untangling and creating

large rolls) (HP 4494/96)

NCool tips

OReady dot

English

Important

• The styling attachments and the inset plates of the "Crimper/

Straightener " will become hot during use. Prevent contact

with the skin. Do not allow the mains cord to touch any hot

parts.

• Never immerse the appliance in water. You may clean it with a

damp cloth, but first remove the plug from the wall socket.

• Washing your hair or using the "Flat plate" of the Crimper/

Straightener attachment will remove the waves and curls.

Making the "Geometricks" MultiStyler ready for use

How to change the styling attachments (fig. 2-6)

• When changing styling attachments during use only touch the plastic

parts. The metal parts are hot!

- To release the styling attachment, turn the clamping ring (C) in the

direction of the arrow (fig. 2).

- Pull the styling attachment from the handle (fig. 3).

- When mounting the required styling attachment, ensure that the

heel rest (F) is at the underside (fig. 4).

- Insert the styling attachment firmly into the main unit (fig. 5).

- Secure by turning the clamping ring (fig. 6).

How to change the Crimper/Straightener inset plates (fig. 7-10)

• Ribbed side: for waves

• Flat side: for straight hair

- Open the Crimper/Straightener by pressing the handle downwards

(fig. 7).

- Take the plate by the cool tips (N) at the front side.

- Pull the plate out of the Crimper/Straightener (fig. 8).

- Turn the plate (fig. 9).

- Insert the plate into the Crimper/Straightener. Ensure that the

protrusions at the sides enter the runners correctly (fig. 10).

Heating up (fig. 11-12)

- Insert the mains plug into the wall socket. The "On"-light (B) will come on

and the styling attachment will heat up (fig. 11).

- When the "Ready"-dot (O) on the styling attachment becomes dark the

appliance is ready for use (fig. 12).

How to use

• Before styling, comb or brush the hair so that it is completely untangled

and smooth.

• Always ensure good contact between hair and styling attachment or

Crimper. For that reason, do not attempt to style thick tresses of hair and

do not double-wind the hair when using the styling attachments.

• You need only 5 - 10 seconds to make a curl or wave.

A setting lotion may be applied after washing the hair.

Styling attachments (fig. 13 - 18)

• Always style small tresses of hair (2 - 3 cm or 1 inch thick).

• For good results, wind a tress around the styling attachment in a spiral

form. The full length of the tress will then be in contact with the hot rod.

• Fix the end of the tress with the clip and wind the hair around the rod

towards the head.

After 5 - 10 seconds open the clip and remove the barrel from the hair.

- With "Spirals" wind the tress following the spiral profile on the styling

attachment.

- With "Curls" wind the hair in straight.

- With the "Brush" a clip is not required as the teeth grip the hair.

• Important: Always ensure that the hair ends are wrapped smoothly

around the barrel of the attachment: this will avoid bent ends.

• You can divide the curls with your fingers to add volume. Especially with

Spirals this will give you a stunning hairstyle.

"Crimper/Straightener" (fig. 19 - 21)

• Take tresses of hair of max. 5 - 6 cm or 2 inches thick.

• The clip enables you to open and close the Crimper/Straightener, so that

you can style a tress of hair section by section.

• Always start crimping or straightening close to the head. Then

successively treat the lower sections.

• You may press the two parts of the Crimper/Straightener together by

using your fingers. (Do not touch the plates!)

• Keep the hair in the Crimper/Straightener for 5-10 seconds. Then open

the Crimper/Straightener to treat the next section of the same tress.

Ensure that there is an overlap!

After use

- After use remove the mains plug from the wall socket.

- Place the appliance with the stand downwards on a safe place and allow

it to cool down.

Replacing the mains cord

If the mains cord of this appliance is damaged, it must only be replaced by

Philips or their service representative, as special tools and/or parts are

required.

For U.K. only:

This appliance is supplied with a non-rewirable 13 Amp. plug. The plug

must never be used without the fuse cover being in place.

If a replacement fuse cover is required, it must be of the same type or

colour as the coloured insert around the fuse cover.

Replacement fuse covers are available from Electrical Retailers or direct

from Philips, tel. 081 - 689 - 2166, ext. 8014.

Replacement 3 Amp. fuses must be BSI or ASTA BS 1362 approved.

Important safety information

If the non-rewirable plug is not suitable for the socket outlets in your home,

it can be removed and replaced by a plug of the correct type.

The non-rewirable plug must be cut from the mains cord, the fuse

removed, and the plug safely discarded to prevent further use.

The removed plug can be hazardous if inserted into a live mains socket.

Fitting a plug: please refer to page 3

Description générale (fig. 1)

AAppareil

BTémoin lumineux

CBague de fixation de l'accessoire

DPoint de fixation de l'accessoire

EFiches de contact

FSupport de sécurité

GPince à cheveux

HAccessoire amovible "Spirales" (pour anglaises) (HP 4494/96)

IAccessoire amovible "Zig-Zags" (pour des cheveux crantés)

(HP 4494/96)

J"Crimper" (pour gaufrer et défriser les cheveux) (HP 4496)

KPlaques réversibles du "Crimper": (HP 4496)

Plaque à gaufrer (côté ondulé pour de fines ondulations)

Plaque à lisser (côté lisse, pour défriser les cheveux)

LAccessoire amovible "boucles" (pour des boucles rondes)

(HP 4494/96)

MAccessoire "brosse" (pour brosser, démêler ou donner du gonflant à

la coiffure) (HP 4494/96)

NPince (isolée thermiquement)

OIndicateur de température

Français

Important

• Les différents accessoires de l'appareil et les plaques

réversibles du "Crimper" deviennent très chauds pendant

l'utilisation: évitez tout contact avec la peau. Assurez-vous

que le fil ne soit jamais en contact avec les parties chaudes de

l'appareil.

• Ne plongez jamais l'appareil dans l'eau. Vous pouvez le

nettoyer avec un chiffon humide après l'avoir débranché et

seulement lorsqu'il est complètement refroidi.

• Vous pouvez éliminer toutes ondulations ou bouclés des

cheveux à l'aide d'un schampooing ou en utilisant le côté lisse

du Crimper.

This manual suits for next models

Table of contents

Languages:

Other Philips Styling Iron manuals

Philips

Philips HP8372 User manual

Philips

Philips Essential Care HP8323 User manual

Philips

Philips Duometricks straight HP4645/01 User manual

Philips

Philips SalonStraight Control HP4686 User manual

Philips

Philips HP4666/07 User manual

Philips

Philips Duometricks straight HP4645/01 User manual

Philips

Philips HP8309/80 User manual

Philips

Philips HP4669/07 User manual

Philips

Philips HP4646/00 User manual

Philips

Philips SalonStraight Seduce HP4668 User manual

Philips

Philips HP4687/08 User manual

Philips

Philips Straightener HP8361/00 User manual

Philips

Philips HP8309/03 User manual

Philips

Philips HP8696 User manual

Philips

Philips HP8600/00 User manual

Philips

Philips HP8300/01 User manual

Philips

Philips HP4646 User manual

Philips

Philips HP8360/00 User manual

Philips

Philips HP8301 User manual

Philips

Philips HP8343 User manual

Philips

Philips HP4684 User manual

Philips

Philips BHH880 User manual

Philips

Philips Ledino 44992/11/16 User manual

Philips

Philips HP8325 User manual

Popular Styling Iron manuals by other brands

Vitek

Vitek VT-2505 Manual instruction

Morphy Richards

Morphy Richards IB22063 Instruction & guarantee

TZS First AUSTRIA

TZS First AUSTRIA Ida FA-5670-3 instruction manual

izzy

izzy LN-112 instructions

Vitek

Vitek VT-2310 Manual instruction

Okoia

Okoia HS23 operating instructions

Arzum

Arzum TRENDCARE AR 5042 manual

SOLAC

SOLAC PP7251 Instructions for use

VS Sassoon

VS Sassoon VSLE330A Instruction booklet

Vitek

Vitek VT-8291 Manual instruction

VS Sassoon

VS Sassoon miniPRO Wave Envy instruction manual

Arzum

Arzum SUPERSTAR TOUCH instruction manual

Remington

Remington S2880ZBA manual

cecotec

cecotec Bamba RitualCare 900 Wet&Dry Max instruction manual

Andis

Andis Gold CSI-1E brochure

Jata

Jata Marco Aldany JBPP5570 Instructions of use

Koenic

Koenic KHC 502 P user manual

hairway

hairway 04104 user manual