Philips HP4698 User manual

Geometricks 10 in 1

HP4698

ENGLISH 6

 15

 24

 32

 40

 48

 57

 66

 74

 82

 91

 100

 110

 119

 127

 135

Introduction

With the new Salon Multistylist 10-in-1 you can create a unique look for

everyoccasion.The new 10-in-1 offers unlimited creativity and versatility

in hairstyling!

You can visit our website at wwww.philips.com for more information

about this product or any other Philips product.

General Description (Fig. 1)

ABrush

BSmall curling attachment

CSpiral

DLarge curling attachment

EZig-zag attachment

FTriangle attachment

GCrimping/straightening attachment

HCrimping/straightening plates

IHandle

JStorage pouch

KHair clips

Important

Read these instructions for use carefully before using the appliance and

save them for future reference.

Check if the voltage indicated on the appliance corresponds to the

local mains voltage before you connect the appliance.

Check the condition of the mains cord regularly. Do not use the

appliance if the plug, the cord or the appliance itself is damaged.

If the mains cord is damaged, it must be replaced by Philips, a

service centre authorised by Philips or similarly qualied persons in

order to avoid a hazard.

Keep this appliance away from water! Do not use this product near

or over water contained in baths, washbasins, sinks etc.When used

in a bathroom, unplug the appliance after use since the proximity of

water presents a risk.

ENGLISH

For additional protection, we advise you to install a residual

current device (RCD) with a rated residual operating current not

exceeding 30mA in the electrical circuit supplying the bathroom.

Ask your installer for advice.

Do not connect the handle to the mains without attaching an

attachment rst. Make sure the attachment is properly xed to the

handle before you put the plug in the wall socket.

Keep the attachments clean and free of dust, dirt, styling spray and

gel. Never use the appliance in combination with styling mousse,

styling spray, gel etc.

The attachments have a ceramic coating.This coating will wear

in the course of time.When this happens, the appliance will still

function normally.

The ceramic-coated parts of the attachments will become hot

during use. Prevent contact with the skin. Do not allow the mains

cord to touch any hot parts.

Always return the appliance to a service centre authorised by

Philips for examination or repair. Repair by unqualied people could

cause an extremely hazardous situation for the user.

Keep the appliance out of the reach of children.

Only use the appliance on dry or damp hair.

Always unplug the appliance after use.

Wait until the appliance has cooled down before storing it.

Do not wind the mains cord round the appliance.

Preparing for use

Before you start styling, comb or brush the hair so that it is

untangled and smooth.

Connecting the attachments

1 Insert one of the attachments into the handle. Make sure that the

stand is pointing downwards. (Fig. 2)

2 Turn the locking ring on the handle to the right until the bold

arrow on the locking ring is in line with the arrow on the handle.

The attachment is now securely xed to the handle. (Fig. 3)

ENGLISH 7

Follow this procedure for all attachments.To detach the

attachments, turn the locking ring to the left and pull the

attachment out of the handle.

Unplug the appliance when you remove an attachment after or during

styling.Avoid touching the metal and ceramic parts of the attachment,

as they are hot.



With the Salon Multistylist 10-in-1 you can create tight curls, large curls,

waves, ringlets, crimps, zig-zag curls, triangular curls and a sleek look.

1 After having connected the attachment to the handle, place the

appliance on the stand of the attachment and put the mains plug

in the wall socket.The pilot light goes on and the appliance starts

heating up. (Fig. 4)

2 Start styling when the ready dot on the attachment changes colour.

(Fig. 5)

3 When using one of the curling attachments or the brush, always

make sure the end of the lock is wound in the required direction.

4 How long you have to keep the styler in your hair depends on the

thickness of your hair. If you have ne hair, 5 seconds will be long

enough for a good result. Leave the styler in your hair longer (max.

10 seconds) if your hair is thicker.

Large or tight curls

1 Connect the large or small curling attachment to the handle. Make

sure that the stand is pointing downwards.

2 Take a lock of hair, open the clip by pressing the lever and place the

lock between the barrel and the clip. (Fig. 6)

3 Release the lever and slide the barrel to the end of the lock.Then

wind the lock round the barrel.

Make sure that the end of the lock is wound in the required direction.

ENGLISH8

4 Open the clip after 5 to 10 seconds and remove the barrel from

the hair. Let the curls cool down before combing, brushing or

nger-combing the hair into its nal style.

You can comb the curls with your ngers to add volume.

Waves

Prevent the brush from getting tangled in the hair in the following way:

Do not put too much hair in one lock.

Do not wind a lock of hair more than twice round the brush.

When unwinding a lock of hair, make sure that you hold the brush

away from the underlying hair.

1 Connect the small curling attachment to the handle and slide the

brush onto the curling attachment.

2 Take a lock of hair and wind it round the brush. (Fig. 7)

3 Remove the brush from your hair after 5 to 10 seconds. Let the

waves cool down before combing, brushing or nger-combing the

hair into its nal style.`

Ringlets

1 Connect the large curling attachment to the handle and slide the

spiral onto the curling attachment.

2 Take a lock of hair, open the clip by pressing the lever and place the

lock between the barrel and the clip. (Fig. 8)

3 Release the lever and slide the barrel to the end of the lock.Then

wind the lock round the barrel following the spiral prole. Make

sure that the end of the lock is wound in the required direction.

4 Open the clip after 5 to 10 seconds and remove the barrel from

the hair. Let the ringlets cool down before combing, brushing or

nger-combing the hair into its nal style.



1 Connect the triangle attachment to the handle. Make sure that the

stand is pointing downwards.

ENGLISH 9

2 Take a lock of hair, open the clip by pressing the lever and place the

lock between the barrel and the clip. (Fig. 9)

3 Release the lever and slide the barrel to the end of the lock.Then

wind the lock round the barrel.

Make sure that the end of the lock is wound in the required direction.

4 Open the clip after 5 to 10 seconds and remove the barrel from

the hair. Let the triangular curls cool down before combing,

brushing or nger-combing the hair into its nal style.

Zig-zag curls

1 Connect the zig-zag attachment to the handle. Make sure that the

stand is pointing downwards.

2 Take a lock of hair, open the clip by pressing the lever and place the

lock between the barrel and the clip. (Fig. 10)

Make sure that the end of the lock is wound in the required direction.

3 Open the clip after 5 to 10 seconds and remove the barrel from

the hair. Let the zig-zag curls cool down before combing, brushing

or nger-combing the hair into its nal style.

Crimps

1 Connect the crimping/straightening attachment with crimping

plates to the handle. (Fig. 11)

2 Take a lock of hair (max. 5 to 6 cm wide), open the attachment

by pressing the lever and place the lock between the plates of the

crimping/straightening attachment. Start crimping at the roots.

(Fig. 12)

3 Keep the plates locked for 5 to 10 seconds.

4 Open the attachment by pressing the lever and place a lower

section of the same lock of hair between the plates. Make sure

there is an overlap. Repeat this process until you have reached the

end of the lock.

ENGLISH10

Other manuals for HP4698

This manual suits for next models

Table of contents

Languages:

Other Philips Hair Styler manuals

Philips

Philips HP4625 User manual

Philips

Philips HP4681/17 User manual

Philips

Philips Salon Multistylist HP4696 User manual

Philips

Philips Salon Airstylist Pro HP4671 User manual

Philips

Philips HP4488/90 User manual

Philips

Philips HP4654 User manual

Philips

Philips HP4698/10 User manual

Philips

Philips GirlGLAM HP4680 User manual

Philips

Philips HP4654 User manual

Philips

Philips HP8651 User manual

Philips

Philips Norelco RQ111 Parts list manual

Philips

Philips TRESemme HP4658/17 User manual

Philips

Philips HP8309 User manual

Philips

Philips HP4681/00 User manual

Philips

Philips TRESemme HP4681/07 User manual

Philips

Philips beauty Airstylist quattro 600 User manual

Philips

Philips HP4684/08 User manual

Philips

Philips HP 4630 User manual

Philips

Philips SalonStraight Essential HP4661/00 User manual

Philips

Philips HP4636/00 User manual

Philips

Philips HP4635/00 User manual

Philips

Philips HP8632 User manual

Philips

Philips HP8651 User manual

Philips

Philips HP8300 Reference manual

Popular Hair Styler manuals by other brands

Eldom

Eldom bess HTS20 manual

Lunata Hair

Lunata Hair LH24HR Instructions and Safety Information

Conair

Conair S3CSC instruction manual

Remington

Remington CI89H1 manual

Dyson

Dyson Airwrap operating manual

Braun

Braun Satin Hair 1 AS 110 use instructions

REVAMP Professional

REVAMP Professional iGEN PROGLOSS CL-2750 user guide

Vitek

Vitek VT-2285 Manual instruction

point

point WAVE VIXEN TRIPLE WAVE MAKER user manual

Braun

Braun Satin Hair 5 quick start guide

Grundig

Grundig HS 7230 user manual

Remington

Remington AS7100 manual

Vitek

Vitek VT-2296 BK instruction manual

HOT TOOLS

HOT TOOLS SIGNATURE Series Use and Care Instruction Manual

Conair

Conair INFINITI INFCS25C instruction manual

Clas Ohlson

Clas Ohlson 44-1152 quick start guide

Panasonic

Panasonic EH-KA11 operating instructions

ARESA

ARESA AR-3334 instruction manual